Interface routes are refcounted as packets move through the stack,
and there's garbage collection tied to it so that route changes can
safely propagate while traffic is flowing. In our setup, we weren't
changing or deleting any routes, but the refcounting logic in
ip6_input() was wrong and caused a reference leak on every inbound
V6 packet. This eventually caused a 32bit overflow, and the resulting
0 value caused the garbage collection to run on the active route.
That then snowballed into the panic.
Reviewed by: scottl
MFC after: 3 days
headers for TSO but also for generic checksum offloading. Ideally we
would only have one common function shared amongst all drivers, and
perhaps when updating them for IPv6 we should introduce that.
Eventually we should provide the meta information along with mbufs to
avoid (re-)parsing entirely.
To not break IPv6 (checksums and offload) and to be able to MFC the
changes without risking to hurt 3rd party drivers, duplicate the v4
framework, as other OSes have done as well.
Introduce interface capability flags for TX/RX checksum offload with
IPv6, to allow independent toggling (where possible). Add CSUM_*_IPV6
flags for UDP/TCP over IPv6, and reserve further for SCTP, and IPv6
fragmentation. Define CSUM_DELAY_DATA_IPV6 as we do for legacy IP and
add an alias for CSUM_DATA_VALID_IPV6.
This pretty much brings IPv6 handling in line with IPv4.
TSO is still handled in a different way and not via if_hwassist.
Update ifconfig to allow (un)setting of the new capability flags.
Update loopback to announce the new capabilities and if_hwassist flags.
Individual driver updates will have to follow, as will SCTP.
Reported by: gallatin, dim, ..
Reviewed by: gallatin (glanced at?)
MFC after: 3 days
X-MFC with: r235961,235959,235958
already plan to support >64k payload here, the IPv6 header payload
length obviously is only 16 bit and the calculations need to be right.
Reported by: dim
Tested by: dim
MFC after: 1 day
X-MFC: with r235958
Use M_ZERO with malloc rather than calling bzero() ourselves.
Change if () panic() checks to KASSERT()s as they are only
catching invariants in code flow but not dependent on network
input/output.
Move initial assigments indirecting pointers after the lock
has been aquired.
Passing layer boundries, reset M_PROTOFLAGS.
Remove a NULL assignment before free.
Sponsored by: The FreeBSD Foundation
Sponsored by: iXsystems
Reviewed by: gnn (as part of the whole)
MFC After: 3 days
Factor out Hop-By-Hop option processing. It's still not heavily used,
it reduces the footprint of ip6_input() and makes ip6_input() more
readable.
Sponsored by: The FreeBSD Foundation
Sponsored by: iXsystems
Reviewed by: gnn (as part of the whole)
MFC After: 3 days
Defer checksum calulations on UDP6 output and respect the mbuf
flags set by NICs having done checksum validation for us already,
thus saving the computing time in the input path as well.
Sponsored by: The FreeBSD Foundation
Sponsored by: iXsystems
Reviewed by: gnn (as part of the whole)
MFC After: 3 days
Add support for delayed checksum calculations in the IPv6
output path. We currently cannot offload to the card if we
add extension headers (which incl. fragmentation).
Fix two SCTP offload support copy&paste bugs: calculate
checksums if fragmenting and no need to flag IPv4 header
checksums in the IPv6 forwarding path.
Sponsored by: The FreeBSD Foundation
Sponsored by: iXsystems
Reviewed by: gnn (as part of the whole)
MFC After: 3 days
Hide the ip6aux functions. The only one referenced outside ip6_input.c
is not compiled in yet (__notyet__) in route6.c (r235954). We do have
accessor functions that should be used.
Sponsored by: The FreeBSD Foundation
Sponsored by: iXsystems
Reviewed by: gnn (as part of the whole)
MFC After: 3 days
X-MFC: KPI?
Simplify the code removing a return from an earlier else case,
not differing from the default function return called now.
Sponsored by: The FreeBSD Foundation
Sponsored by: iXsystems
Reviewed by: gnn (as part of the whole)
MFC After: 3 days
We currently nowhere set IP6A_SWAP making the entire check useless
with the current code. Keep around but do not compile in.
Sponsored by: The FreeBSD Foundation
Sponsored by: iXsystems
Reviewed by: gnn (as part of the whole)
MFC After: 3 days
No need to hold the (expensive) rt lock over (expensive) logging.
Sponsored by: The FreeBSD Foundation
Sponsored by: iXsystems
Reviewed by: gnn (as part of the whole)
MFC After: 3 days
Introduce a (for now copied stripped down) in6_cksum_pseudo()
function. We should be able to use this from in6_cksum() but
we should also ponder possible MD specific improvements.
It takes an extra csum argument to allow for easy checks as
will be done by the upper layer protocol input paths.
Sponsored by: The FreeBSD Foundation
Sponsored by: iXsystems
Reviewed by: gnn (as part of the whole)
MFC After: 3 days
Optimize in6_cksum(), re-ordering work and limiting variable
initialization, removing a bzero() for mostly re-initialized
struct values, making use of the newly introduced in6_getscope(),
as well as converting an if/panic to a KASSERT().
Sponsored by: The FreeBSD Foundation
Sponsored by: iXsystems
Reviewed by: gnn (as part of the whole)
MFC After: 3 days
Introduce in6_getscope() to allow more effective checksum
computations without the need to copy the address to clear the
scope.
Sponsored by: The FreeBSD Foundation
Sponsored by: iXsystems
Reviewed by: gnn (as part of the whole)
MFC After: 3 days
casted to structs by getting rid of these buffers entirely. In r169832, it
was tried to paper over this issue by 32-bit aligning the buffers. Depending
on compiler optimizations that still was insufficient for 64-bit architectures
with strong alignment requirements though.
While at it, add comments regarding the total lack of locking in this area.
Tested by: bz
Reviewed by: bz (slightly earlier version), yongari (earlier version)
MFC after: 1 week
inp_socket. To avoid panic, do not dereference inp_socket,
but obtain reuse port option from inp_flags2, like this
is done after next call to in_pcblookup_local() a few lines
down below.
Submitted by: rwatson
call in an #if 0 section.
In in6_selecthlim() optimize a case where in6p cannot be NULL due to an
earlier check.
More consistently use u_int instead of int for fibnum function arguments.
Sponsored by: Cisco Systems, Inc.
MFC after: 3 days
at which the lle_tbl pointer points to freed memory and the llt_free pointer is no longer
valid.
Move the free pointer in to the llentry itself and update the initalization sites.
MFC after: 2 weeks
return ifnet double pointer.
Pass that hint down to in6_selectif() to be used when i) the default FIB
is queried and ii) route lookup fails because the network is not present
(i.e. someone deleted the connected subnet).
This hint should not be generally used from anywhere outside the neighbor
discovery code. We just make use of it from nd6_ns_output().
Extend the nd6_na_output() interface by a nd6_na_output_fib() version
and pass the FIB number from the NS mbuf on to NA to allow the new mbuf
to inherit the FIB tag and a later lookup from ip6_output() to succeed
in the aformentioned example case.
Provide a wrapper function for the old public interface also used from
CARP but mark it with BURN_BRIDGES to cleanup in HEAD after MFC.
Sponsored by: Cisco Systems, Inc.
the original IPv4 implementation from r178888:
- Use RT_DEFAULT_FIB in the IPv4 implementation where noticed.
- Use rt*fib() KPI with explicit RT_DEFAULT_FIB where applicable in
the NFS code.
- Use the new in6_rt* KPI in TCP, gif(4), and the IPv6 network stack
where applicable.
- Split in6_rtqtimo() and in6_mtutimo() as done in IPv4 and equally
prevent multiple initializations of callouts in in6_inithead().
- Use wrapper functions where needed to preserve the current KPI to
ease MFCs. Use BURN_BRIDGES to indicate expected future cleanup.
- Fix (related) comments (both technical or style).
- Convert to rtinit() where applicable and only use custom loops where
currently not possible otherwise.
- Multicast group, most neighbor discovery address actions and faith(4)
are locked to the default FIB. Individual IPv6 addresses will only
appear in the default FIB, however redirect information and prefixes
of connected subnets are automatically propagated to all FIBs by
default (mimicking IPv4 behavior as closely as possible).
Sponsored by: Cisco Systems, Inc.
The actual ia6->ia6_lifetime access is hidden in
IFA6_IS_INVALID/IFA6_IS_DEPRECATED macros since a long time ago
(see netinet6/nd6.c, r1.104 of KAME for the reference).
MFC after: 3 days
comments to longer, also refining strange ones.
Properly use #ifdef rather than #if defined() where possible. Four
#if defined(PCBGROUP) occurances (netinet and netinet6) were ignored to
avoid conflicts with eventually upcoming changes for RSS.
Reported by: bde (most)
Reviewed by: bde
MFC after: 3 days
If set to 1, no ABORT is sent back in response to an incoming
INIT. If set to 2, no ABORT is sent back in response to
an out of the blue packet. If set to 0 (the default), ABORTs
are sent.
Discussed with rrs@.
MFC after: 1 month.
in6m_release_locked() to defer calls to mld_v1_transmit_report() until
after the IF_ADDR_LOCK is dropped. This removes a race where the lock
is dropped and reacquired while attempting to walk an interface's
address list.
Reviewed by: bz
MFC after: 1 week
reference on a group in the leaving state while iterating over the loop.
Instead, use the same approach used in igmp_ifdetach() and mld_ifdetach()
of placing the groups to free on pending release list and then releasing
the references after dropping the IF_ADDR_LOCK. This closes an ugly race
where the code was dropping the lock in the middle of iterating over the
list. It also fixes some additional potential use-after-free bugs since
the cancellation routine also applied other changes to the group after
dropping the reference. Now those changes are performed before the
reference is dropped and the group is potentially freed.
Prodded to fix by: glebius
Reviewed by: bz
MFC after: 1 week
