add some packet(s) to tx ring and arge_stop() is called before receive the
sent packet interrupt from hardware. Fix arge_stop() to unload the in use
dma tags and free the associated mbuf.
PR: 178319, 163670
Approved by: adrian (mentor)
sf_buf_alloc()/sf_buf_free() inlines, to save two calls to an absolutely
empty functions.
Reviewed by: alc, kib, scottl
Sponsored by: Nginx, Inc.
Sponsored by: Netflix
This is a nice small outdoor/indoor AP from Ubiquity Networks.
The device has:
AR7241 CPU SoC
AR9287 Wifi
8MB flash
32MB RAM
wifi has been tested to work along with leds.
Submitted by: loos
Approved by: sbruno (mentor, implicit)
Tested by: hiren
MADV_DONTNEED) and madvise(..., MADV_FREE). Specifically, introduce a new
pmap function, pmap_advise(), that operates on a range of virtual addresses
within the specified pmap, allowing for a more efficient implementation of
MADV_DONTNEED and MADV_FREE. Previously, the implementation of
MADV_DONTNEED and MADV_FREE relied on per-page pmap operations, such as
pmap_clear_reference(). Intuitively, the problem with this implementation
is that the pmap-level locks are acquired and released and the page table
traversed repeatedly, once for each resident page in the range
that was specified to madvise(2). A more subtle flaw with the previous
implementation is that pmap_clear_reference() would clear the reference bit
on all mappings to the specified page, not just the mapping in the range
specified to madvise(2).
Since our malloc(3) makes heavy use of madvise(2), this change can have a
measureable impact. For example, the system time for completing a parallel
"buildworld" on a 6-core amd64 machine was reduced by about 1.5% to 2.0%.
Note: This change only contains pmap_advise() implementations for a subset
of our supported architectures. I will commit implementations for the
remaining architectures after further testing. For now, a stub function is
sufficient because of the advisory nature of pmap_advise().
Discussed with: jeff, jhb, kib
Tested by: pho (i386), marcel (ia64)
Sponsored by: EMC / Isilon Storage Division
(re)start the interface when it is down. This change fix a race with
BOOTP where the response packet is lost because the interface is being
reset by a netmask change right after send the packet.
PR: 178318
Approved by: adrian (mentor)
- Route PCI interrupt for NIC
- Make "no mapping" warning more user-friendly: add device name and mention
that it's IRQ mapping
- Do not overlap ICUs' IO window with PCI devices' IO windows by starting
IO rman at offset 0x100
form xx:xx:xx:xx:xx:xx complete with ":" characters taking of 18 bytes
instead of 6 integers. Expose a "readascii" tuneable to handle this case.
Remove restriction on eepromac assignement for the first dev instance only.
Add eepromac address for DIR-825 to hints file.
Add readascii hint for DIR-825
Reviewed by: adrian@
which is the part of struct vmspace, allocated from UMA_ZONE_NOFREE
zone. Initialize the pmap lock in the vmspace zone init function, and
remove pmap lock initialization and destruction from pmap_pinit() and
pmap_release().
Suggested and reviewed by: alc (previous version)
Tested by: pho
Sponsored by: The FreeBSD Foundation
Unify the 2 concept into a real, minimal, sxlock where the shared
acquisition represent the soft busy and the exclusive acquisition
represent the hard busy.
The old VPO_WANTED mechanism becames the hard-path for this new lock
and it becomes per-page rather than per-object.
The vm_object lock becames an interlock for this functionality:
it can be held in both read or write mode.
However, if the vm_object lock is held in read mode while acquiring
or releasing the busy state, the thread owner cannot make any
assumption on the busy state unless it is also busying it.
Also:
- Add a new flag to directly shared busy pages while vm_page_alloc
and vm_page_grab are being executed. This will be very helpful
once these functions happen under a read object lock.
- Move the swapping sleep into its own per-object flag
The KPI is heavilly changed this is why the version is bumped.
It is very likely that some VM ports users will need to change
their own code.
Sponsored by: EMC / Isilon storage division
Discussed with: alc
Reviewed by: jeff, kib
Tested by: gavin, bapt (older version)
Tested by: pho, scottl
transparent layering and better fragmentation.
- Normalize functions that allocate memory to use kmem_*
- Those that allocate address space are named kva_*
- Those that operate on maps are named kmap_*
- Implement recursive allocation handling for kmem_arena in vmem.
Reviewed by: alc
Tested by: pho
Sponsored by: EMC / Isilon Storage Division
* Make Yarrow an optional kernel component -- enabled by "YARROW_RNG" option.
The files sha2.c, hash.c, randomdev_soft.c and yarrow.c comprise yarrow.
* random(4) device doesn't really depend on rijndael-*. Yarrow, however, does.
* Add random_adaptors.[ch] which is basically a store of random_adaptor's.
random_adaptor is basically an adapter that plugs in to random(4).
random_adaptor can only be plugged in to random(4) very early in bootup.
Unplugging random_adaptor from random(4) is not supported, and is probably a
bad idea anyway, due to potential loss of entropy pools.
We currently have 3 random_adaptors:
+ yarrow
+ rdrand (ivy.c)
+ nehemeiah
* Remove platform dependent logic from probe.c, and move it into
corresponding registration routines of each random_adaptor provider.
probe.c doesn't do anything other than picking a specific random_adaptor
from a list of registered ones.
* If the kernel doesn't have any random_adaptor adapters present then the
creation of /dev/random is postponed until next random_adaptor is kldload'ed.
* Fix randomdev_soft.c to refer to its own random_adaptor, instead of a
system wide one.
Submitted by: arthurmesh@gmail.com, obrien
Obtained from: Juniper Networks
Reviewed by: obrien
DB120 development board.
The AR934x SoCs are a MIPS74k based system with increased RAM addressing
space, some scratch-pad RAM, an improved gige switch PHY and 2x2 or 3x3
on-board dual-band wifi.
This support isn't complete by any stretch; it's just enough to bring
the board up for others to tinker with. Notably, the MIPS74k support
is broken. However it boots enough to echo some basic probe/attach
messages, before dying somewhere in the TLB code.
Thankyou to Qualcomm Atheros for their continued support of me doing
open source work with their hardware.
Tested:
* AR9344, mips74k
This code reads the PLL configuration registers and correctly programs
things so the UART and such can come up.
There's MIPS74k platform issues that need fixing; but this at least brings
things up enough to echo stuff out the serial port and allow for interactive
debugging with ddb.
Tested:
* AR71xx SoCs
* AR933x SoC
* AR9344 board (DB120)
Obtained from: Qualcomm Atheros; Linux/OpenWRT
For all pre-AR933x chips, the frequency is just the APB frequency.
For the AR933x, the UART frequency is different but we just hacked around
it.
For the AR934x, there's a different PLL setting for these, so they have
to be broken out.
They originated in the original Octeon port. They weren't present, as
far as I can tell, on the projects/mips branch until after this
point. They were in the original Octeon port in code picked up from
the vendor, who I've been able to find out trolling old email put them
there to get around an SMP problem that most likely was fixed in other
ways.
NetBSD and Linux don't have these, except for some specific uses of
SYNC on the alchemy parts (which we don't support, but even if we did
it is only a specific case and would be specifically coded
anyway). This is true of the current Linux code, as well as one old
version I polled.
I looked back at the old R12000, R8000, R6000, R4000, R4400 errata
that I have, and could find no mention of SYNC needing NOPs for
silicon bugs (although plenty of other cases where NOPs and other
contortions were needed).
An Google search turned up no old mailing list discussions on this on
Linux, NetBSD or FreeBSD (except the disussion that kicked off these
studies).
I've test booted this on my Octeon Plus eval board and survived a
buildworld. Adrian Chadd reports that this patch has no ill effects on
the Ahteros platforms he tested it on.
I conclude it is safe to just remove the NOPs. But added
__MIPS_PLATFORM_SYNC_NOPS as a failsafe in case we find some platform
where these are, in fact, required.
Reviewed by: adrian@
This is an AR7240 based device with an AR9285 on-board.
I've tested the initial boot and wifi support; however at the moment
the ethernet switch driver doesn't seem to be picking up carrier on the
active ethernet port. Basic flood pinging works however, so I think
we're on the right track.
Thank you to Adrian Woodley <adrian@diskworld.com.au> for purchasing me
one of these devices to bootstrap FreeBSD-HEAD on.
Issues were noted by Bruce Evans and are present on all architectures.
On i386, a counter fetch should use atomic read of 64bit value,
otherwise carry from the increment on other CPU could be lost for the
given fetch, making error of 2^32. If 64bit read (cmpxchg8b) is not
available on the machine, it cannot be SMP and it is enough to disable
preemption around read to avoid the split read.
On x86 the counter increment is not atomic on purpose, which makes it
possible for the store of the incremented result to override just
zeroed per-cpu slot. The effect would be a counter going off by
arbitrary value after zeroing. Perform the counter zeroing on the
same processor which does the increments, making the operations
mutually exclusive. On i386, same as for the fetching, if the
cmpxchg8b is not available, machine is not SMP and we disable
preemption for zeroing.
PowerPC64 is treated the same as amd64.
For other architectures, the changes made to allow the compilation to
succeed, without fixing the issues with zeroing or fetching. It
should be possible to handle them by using the 64bit loads and stores
atomic WRT preemption (assuming the architectures also converted from
using critical sections to proper asm). If architecture does not
provide the facility, using global (spin) mutex would be non-optimal
but working solution.
Noted by: bde
Sponsored by: The FreeBSD Foundation
