Small modifications to the nmreplay man page.
Used igor and mandoc tools to fix warnings and errors.
Reviewed by: bcr
MFC after: 3 days
Differential Revision: https://reviews.freebsd.org/D18629
Changelist:
- General reformatting
- Fix packet duplication in cons(). Whenever cons() reached the
burst limit it would send all pending packets without advancing
head. This caused the last injected packet to be sent again in
the next round.
- Fix full-speed transmissions after first loop.
MFC after: 3 days
This code validates the netmap buf_size against the interface MTU
and maximum descriptor size, to make sure the values are consistent.
Moving this functionality to its own function is needed because this
function is also called by Linux-specific code.
MFC after: 3 days
implement not double-caching for reads from vnode-backed md devices.
Use VOP_ADVISE() similarly instead of !IO_DIRECT unsimilarly for writes.
Add a "cache" option to mdconfig to allow changing the default of not
caching.
This depends on a recent commit to fix VOP_ADVISE(). A previous version
had optimizations for sequential i/o's (merge the i/o's and only uncache
for discontiguous i/o's and for full blocks), but optimizations and
knowledge of block boundaries belong in VOP_ADVISE(). Read-ahead should
also be handled better, by supporting it in md and discarding it in
VOP_ADVISE().
POSIX_FADV_DONTNEED is ignored by zfs, but so is IO_DIRECT.
POSIX_FADV_DONTNEED works better than IO_DIRECT if it is not ignored,
since it only discards from the buffer cache immediately, while
IO_DIRECT also discards from the page cache immediately.
IO_DIRECT was not used for writes since it was claimed to be too slow,
but most of the slowness for writes is from doing them synchronously by
default. Non-synchronous writes still deadlock in many cases.
IO_DIRECT only has a special implementation for ffs reads with DIRECTIO
configured. Otherwise, if it is not ignored than it uses the buffer and
page caches normally except for discarding everything after each i/o,
and then it has much the same overheads as POSIX_FADV_DONTNEED. The
overheads for reading with ffs and DIRECTIO were similar in tests of md.
Reviewed by: kib
POSIX_FADV_DONTNEED). The most broken case was for applications that
advise for the whole file and then do block-aligned i/o's 1 block at
a time. Then advice is sent to VOP_ADVISE() 1 block at a time, but
in vop_stdadvise() the 1-block advice was turned into 0-block advice
for the buffer cache part.
The bugs were caused partly by callers representing the region as
(a_start, a_end), where a_end is actually the maximum, and everything
else representing the region as (start, end) where 'end' is actually
the end (1 after the maximum). The maximum a_end must be rounded up,
but was rounded down. Also, rounding to page boundaries was inconsistent.
The bugs and fixes have no effect for zfs and other file systems that
don't use the buffer cache or the page cache. Most or all file systems
currently use the default VOP_FADVISE(), but it finds a null buffer cache
and a null page cache for file systems that don't use normal methods.
Reviewed by: kib
be called before VFS_ROOT() is called. Move the call for VFS_STATFS()
so that it is done after VFS_MOUNT(), but before VFS_ROOT().
This change actually improves the robustness of the mount system
call because it returns an error rather than failing silently
when VFS_STATFS() returns failure.
Reported by: Rebecca Cran <rebecca@bluestop.org>
Sponsored by: Netflix
When the NFSv4 server was coded, I believed that the specification authors
did not want NFSv4 servers to require a client to use a reserved port#.
However, recently it has been noted that the Linux NFSv4 server does support
a check for a reserved port#.
Since both the FreeBSD and Linux NFSv4 clients use a reserved port# by
default, enabling vfs.nfsd.nfs_privport to require a reserved port# for
NFSv4 the same as it does for NFSv2, 3 seems reasonable.
The only case where this could cause a POLA violation is a FreeBSD NFSv4
server with vfs.nfsd.nfs_privport set, but with NFSv4 clients doing mounts
without using a reserved port# (< 1024).
Tested by: chaz.newton58@gmail.com
PR: 234106
MFC after: 1 week
Move static variable definition (cdevsw) to a more conventional location
(the C file it is used in), rather than a header.
This fixes the GCC warning, -Wunused-variable ("defined but not used") when
the tpm20.h header is included in files other than tpm20.c (e.g.,
tpm_tis.c).
X-MFC-with: r342084
Sponsored by: Dell EMC Isilon
Currently, the installer uses pre-created 800KB FAT12 filesystems that
it dd's onto the ESP partition.
This changeset improves that by having the installer generate a FAT32
filesystem directly onto the ESP using newfs_msdos and then copying
loader.efi into /EFI/freebsd.
For live installs it then runs efibootmgr to add a FreeBSD boot entry
in the BIOS.
Sponsored by: Netflix
Differential Revision: https://reviews.freebsd.org/D17947
The reason for this change is that currently, a send/recv
takes many hours to time out.
This is suboptimal in the bootloader because it means for example
that NFS will take hours to fail before allowing subsequent access
methods such as gzip to be tried.
Setting MAXWAIT to 300 seconds (5 minutes) still allows slow
connections of 1Mb to be used to download a 30MB kernel file.
Sponsored by: Netflix
Differential Revision: https://reviews.freebsd.org/D18544
When receiving TCP segments the stack protects itself by limiting
the resources allocated for a TCP connections. This patch adds
an exception to these limitations for the TCP segement which is the next
expected in-sequence segment. Without this patch, TCP connections
may stall and finally fail in some cases of packet loss.
Reported by: jhb@
Reviewed by: jtl@, rrs@
MFC after: 3 days
Sponsored by: Netflix, Inc.
Differential Revision: https://reviews.freebsd.org/D18580
On amd64 the RSP address can be read in single 8-byte transaction,
which is obviously not possible on 32-bit platforms. Fix that
by performing 2 4-byte read on them.
Obtained from: Semihalf
Sponsored by: Stormshield
Per discussions on mips@, 32-bit mips SMP is now unsupported. The
files in the tree will compile for a while longer, but when the
atomic_swap_64 or similar atomic enters into the MI part of the tree,
as currently foreseen sometime next year, these ports will start to no
longer link. The JZ4780 is the only such system we have.
The UP version of this chip is unaffected by this, and will remain
supported.
Discussed on: mips@
Relnotes: yes
The first part of the mips pruning has been commited. This part
is uncontested. Fix the date in the UPDATING file to reflect when
I made the commit. The contested parts will be committed (or not)
once those discussions complete.
This is an older broadcom part that implements the mips32 ISA. 32-bit
FreeBSD/mips now requires mips32r2, so retire this config. Most of the
broadcom port is shared with newer ports, so what little code may be
unique to this part has not been GC'd at this time.
Discussed on: freebsd-mips@
Differential Revision: https://reviews.freebsd.org/D18543
This was useful in bring up. However, it causes more issues than the
support is worth (64-bit atomics being chief among them).
Discussed on: freebsd-mips@
Differential Revision: https://reviews.freebsd.org/D18543
gxemul was a nice stop-gap while qemu support for mips was firmed
up. Now MALTA* + qemu is the platform of choice retire gxemul support.
It's unknown when this was last confirmed working.
Discussed on: freebsd-mips@
Differential Revision: https://reviews.freebsd.org/D18543
relevant and is unused. It's also getting in the way of progress in
some admittedly minor ways. Better to retire it to reduce the burden
on the project.
Discussed on: freebsd-mips@
Differential Revision: https://reviews.freebsd.org/D18543
Update the appropriate Makefile to build the new driver
together with the old one.
Submitted by: Kornel Duleba <mindal@semihalf.com>
Reported by: kib
Obtained from: Semihalf
Sponsored by: Stormshield
Prior to the change the code would branch on return value and then check
if probes are enabled. Since vast majority of the time they are not, this
is clearly wasteful. Check probes first.
Sponsored by: The FreeBSD Foundation
iBCS2 was disconnected from the build in 2015 (see r291419)
bsdconfig parts submitted by dteske.
Reviewed by: kib (previous version)
Sponsored by: The FreeBSD Foundation
Due to insufficient validation of network-provided data it may have been
possible for a malicious actor to craft a bootp packet which could cause
a stack buffer overflow.
admbugs: 850
Reported by: Reno Robert
Reviewed by: markj
Approved by: so
Security: FreeBSD-SA-18:15.bootpd
Sponsored by: The FreeBSD Foundation
The sbadaddr register was renamed in version 1.10 of the privileged
architecture specification. No functional change intended.
Submitted by: Mitchell Horne <mhorne063@gmail.com>
MFC after: 1 week
Differential Revision: https://reviews.freebsd.org/D18594
