umountable file systems, hung processes, or system panics:
- Some operations could return without decrementing the vnode
reference count.
- Some operations could leave the vnode locked.
- Generalize the /kern/rootdev & rrootdev files so that they
are no longer special cased in kernfs_lookup().
Note: procfs, fdescfs, and most of the other miscfs/* file systems
also suffer from the same type of problems and I will work on
fixing them one at a time.
BUS DEVICE RESET followed by BUS RESET failure recovery strategy including
the necesary renegotiation of sync/wide transfers after recovery completes.
Clean up debugging code to make it more finely selectable. Reset code
debugging is enabled for now so I can get more feedback on how this
code behaves in real life.
as is required to be POSIXLY_CORRECT and "right". I interpret
"referring to a directory" as being a directory or becoming a
directory. E.g., the trailing slashes in mkdir("/nonesuch/"),
rename("/tmp", /nonesuch/") and link("/tmp", "/root_can_like_dirs/")
are ignored because the target will become a directory if the
syscall succeeds. A trailing slash on a symlink causes the symlink
to be followed (this is a bug if the symlink doesn't point to a
directory; fix later).
queues for TIOCSETA[W]. Swapping an even number of times broke
the queue resource limits. This would have broken CRTSCTS flow
control if the clist slush list was used up.
Don'concatenate the queues for TIOCSETA[W] if one of the queues
has a resource limit of 0. Concatenation would cause a panic if
one of the queues is nonempty and the other is limited to length
0. This may have caused panics in PPPDISC.
Wake up readers after all transitions of ICANON. When ICANON is
turned off it is quite likely that characters will become available
to be read.
Reduce indentation near these changes.
on output below low water) and TS_SO_OCOMPLETE (sleep on output complete).
Most of the support for this has already been committed. Drivers should
call ttwwakeup() to handle wakeups whenever output is below low water
(and some output event causes this condition to be checked) or TS_BUSY is
cleared.
tty.c:
Fix the livelock in ttywait() properly by sleeping on output complete, not
on output below low water.
Use ttwwakeup() instead of separate select and output wakeups for all
wakeups of writers.
Add wakeups of writers for output flushes and carrier/clocal transitions.
Don't go to sleep in ttycheckoutq() if ttstart() reduces the queue to below
low water.
Use the timeout built into tsleep() in ttycheckoutq().
Optimize the select wakeup in ttwwakeup(). It seems reasonable to know
too much about the internals of tp->t_wsel now that the knowledge is
localised in tty.c.
Remove nullmodem().
It may be useful to have a null modem routine, but nullmodem()
wasn't one. nullmodem() was identical to ttymodem() except it
didn't implement MDMBUF (carrier) flow control, didn't do any
wakeups for off to on carrier transitions, and didn't flush the
i/o queues for on to off carrier transitions (flushing has the side
effect of waking up readers and writers) although it did generate
SIGHUPs. The wakeups must normally be done even if nullmodem() is
null in case something is sleeping waiting for a carrier transition.
In any case, the wakeups should be harmless. They may cause bogus
results for select(), but select() is already bogus for nonstandard
line disciplines.
essential when I fix excessive wakeups for output-below-low-water.
In cy.c and sio.c, wake up via the driver start routine to also
eliminate duplicated code involving the clearing of TS_TTSTOP.
Always (except in code to be replaced soon) call driver start
routine directly instead of going through ttstart().
Amancio. There is some SoundSource support here that is primitive and
probably doesn't work, but I'll let the two submitters let me know
how my integration of that was since I don't have this card to test.
I've only tested this on my GUS MAX since it's all I have.
This all probably needs to be re-done anyway since we're widely variant
from the original VOXWARE source in the current layout.
Submitted by: Amancio Hasty and Jim Lowe
Obtained from: Hannu Savolainen
floppy DMA buffers...use avail_start not "first". Removed duplicate
(and wrong) declaration of phys_avail[].
Submitted by: Bruce Evans, but fixed differently by me.
case, multicast options are not passed to ip_mforward().) The previous
version had a wrong test, thus causing RSVP mrouters to forward RSVP messages
in violation of the spec.
This finishes making the kernel compile without -O.
The "optimized" asm version of the function being inlined
(translate_bytes()) uses slow instructions. On a 486, assuming
everything is in the cache (unlikely), it is 21/15 times slower
than the dumb C version and 21/3 times slower than the best
possible bytewise method.
for the kernel, but gcc provides an inline version of it if the
kernel is compiled with -O.
The inline memcmp() is OK for small compares and is better than
the dumb kernel bcmp() in all cases, but it has been hiding the
library memcmp() which is 4 times faster for large compares.
don't go away when the kernel is compiled with -O.
The functions are backed up by extern versions in cd9660_util.c,
but these versions are disabled by `#ifdef __notanymore__'. They
could have been enabled by using `#if defined(__notanymore__) ||
!defined(__OPTIMIZE__)' but then I would have had to check that
they still work. The correct way to handle all this is to replace
`extern inline' by `EXTERN_INLINE' and define `EXTERN_INLINE' as
`extern inline' in most modules and as empty in one module.
didn't work are somewhat bogusly optimized away before the constraint
is checked. We still expect constants passed to inline functions to
remain constant, but if the compiler ever decides that they aren't
constant then it will just generate slightly slower code instead of
an error.
Declare `cheat' as static. It was bogusly shared between the aha1742 and
ultrastor drivers.
Even static variables should have unique names so that they can be
debugged, but fixing them can wait.
different types of panics/inconsistencies with NFS clients.
Cleared PG_WANTED where appropriate.
Added checks for buffer busy in allocbuf and biodone.
Reviewed by: John Dyson
when it is moved to an NFS filesystem from from another filesystem and /bin/mv
failed to set the file ownership during the move.
I believe that this bug is present in STABLE but I have not tested it. The fix
would be the same in STABLE even though the code has changed quite considerably
in CURRENT.
ended that fork() uses to determine the time that the process
started when calculating the elapsed time. This prevents the
ac_etime field in the accounting record from getting set to -1
if the process exists for a VERY short period of time.
