efivar_device_path_to_unix_path translates from UEFI to Unix
efivar_unix_path_to_device_path translates from Unix to UEFI
At present, only HD() device types are supported (both GPT and
MBR). CdRom and floppy devices aren't supported. ZFS isn't supported
because there's no way in the UEFI standard to specify a ZFS datastore.
Network devices aren't supported either.
Three forms of Unix path are accepted: /path/to/file (for a mounted
filesystem), //path/to/file (uses the EFI partition on the same disk
as /), and dev:/path/to/file (for unmounted filesystem). Two forms are
produced (the first and last).
Sponsored by: Netflix
Currently, bwn(4) relies on the siba_bwn(4) bus driver to provide support
for the on-chip SSB interconnect found in Broadcom's older PCI(e) Wi-Fi
adapters. Non-PCI Wi-Fi adapters, as well as the newer BCMA interconnect
found in post-2009 Broadcom Wi-Fi hardware, are not supported by
siba_bwn(4).
The bhnd(4) bus driver (also used by the FreeBSD/MIPS Broadcom port)
provides a unified kernel interface to a superset of the hardware supported
by siba_bwn; by attaching bwn(4) via bhnd(4), we can support both modern
PCI(e) Wi-Fi devices based on the BCMA backplane interconnect, as well as
Broadcom MIPS WiSoCs that include a D11 MAC core directly attached to their
SSB or BCMA backplane.
This diff introduces opt-in bwn(4) support for bhnd(4) by providing:
- A small bwn(4) driver subclass, if_bwn_bhnd, that attaches via
bhnd(4) instead of siba_bwn(4).
- A bhndb(4)-based PCI host bridge driver, if_bwn_pci, that optionally
probes at a higher priority than the siba_bwn(4) PCI driver.
- A set of compatibility shims that perform translation of bwn(4)'s
siba_bwn function calls into their bhnd(9) API equivalents when bwn(4)
is attached via a bhnd(4) bus parent. When bwn(4) is attached via
siba_bwn(4), all siba_bwn function calls are simply passed through to
their original implementations.
To test bwn(4) with bhnd(4), place the following lines in loader.conf(5):
hw.bwn_pci.preferred="1"
if_bwn_pci_load="YES
bwn_v4_ucode_load="YES"
bwn_v4_lp_ucode_load="YES"
To verify that bwn(4) is using bhnd(4), you can check dmesg:
bwn0: <Broadcom 802.11 MAC/PHY/Radio, rev 15> ... on bhnd0
... or devinfo(8):
pcib2
pci2
bwn_pci0
bhndb0
bhnd0
bwn0
...
bwn(4)/bhnd(4) has been tested for regressions with most chipsets currently
supported by bwn(4), including:
- BCM4312
- BCM4318
- BCM4321
With minimal changes to the DMA code (not included in this commit), I was
also able to test support for newer BCMA devices by bringing up basic
working Wi-Fi on two previously unsupported, BCMA-based N-PHY chipsets:
- BCM43224
- BCM43225
Approved by: adrian (mentor, implicit)
Sponsored by: The FreeBSD Foundation & Plausible Labs
Differential Revision: https://reviews.freebsd.org/D13041
The Display Interface Unit (DIU) uses main memory for the framebuffer, which
is already mapped as cache coherent physical memory. Prevent mmap() from
using its own attributes which may otherwise conflict.
- Add missing call to device_delete_children() in bhndb_detach(), without
which we're left with stale child devices on module unload.
- Pass the parent PCI device to pci_release_msi(), not the bhndb_pci(4)
child.
Approved by: adrian (mentor, implicit)
Sponsored by: The FreeBSD Foundation
bhnd_chipc's children may hold strong provider references to their parent;
we must detach any children before attempting to deregister the bhnd_chipc
device as a bus service provider.
Approved by: adrian (mentor, implicit)
Sponsored by: The FreeBSD Foundation
Default WARNS to 0 still, since there's still some warnings on other
architectures.
Sponsored by: Netflix
Differential Revision: https://reviews.freebsd.org/D13301
These prototypes were needlessly different from the standard. Fix them
to be the same, and fix the surrounding code after the changes.
Sponsored by: Netflix
Only define the CFLAGS we need.
SSP_CFLAGS is now defined globally, no need to define it here.
Define -D_STANDALONE globally for src/stand builds.
Sponsored by: Netflix
Move kernel includes and libsa includes together at the top of defs.mk
Move all machine specific defines from Makefile.inc to their friends
in defs.mk.
Add comments and remove now useless junk after the move.
Sponsored by: Netflix
Remove the now-useless dependency on ufsread.c. In some cases, it was
on the wrong file. But in all cases, we now automatically generate
.depend files, so we don't need it explicitly.
Sponsored by: Netflix
system calls. Man pages are missing for v2 and v5, so any entries for
those versions were inferred by new implementations of these functions
in libc.
Obtained from: http://www.tuhs.org/cgi-bin/utree.pl
Based on the patch by: Pawel Biernacki <pawel.biernacki@gmail.com>
Sponsored by: Mysterious Code Ltd. (Pawel),
The FreeBSD Foundation (me)
MFC after: 1 week
Differential revision: https://reviews.freebsd.org/D13228
a10_gpio previously accepted only {allwinner,}drive and {allwinner,}pull for
drive/bias setting, while newer DTS is using drive-strength and
bias-{disable,pull-up,pull-down} properties. Accept these properties as
well.
Additionally make bias and drive strength optional rather than required; not
setting them should just indicate that we do not need to configure these
properties.
Tested on: BananaPi-M3 (a83t)
Reviewed by: manu
Approved by: emaste (implicit)
Obtained from: NetBSD (partially)
Differential Revision: https://reviews.freebsd.org/D13284
SIOCGIFXMEDIA is required for extended ethernet media types,
but iflib did not support it.
Reported by: Bhargava Chenna Marreddy <bhargava.marreddy@broadcom.com>
Sponsored by: Limelight Networks
Differential Revision: https://reviews.freebsd.org/D13312
A correct destruction is important for WITNESS(4) and LOCK_PROFILING(9).
Submitted by: Sebastian Huber <sebastian.huber@embedded-brains.de>
MFC after: 1 week
SPDB was cleaned using TAILQ_CONCAT() instead of calling key_unlink()
for each SP, thus we need to properly clean lists in each bucket of
V_sphashtbl to avoid panic in hashdestroy() when INVARIANTS is enabled.
Do the same for V_acqaddrhashtbl and V_acqseqhashtbl.
When we are called in DEFAULT_VNET, destroy also all global locks and
drain key_timer callout.
Reported by: kp
Tested by: kp
MFC after: 1 week
iPXE does insert stub BLOCK IO protocol handle to rework other issues,
this handle is not usable as it does not provide actual implementation.
We can detect this situation by checking and validating the BlockSize
property, so this update does make sure we have BlockSize at least 512B
and its value is power of 2.
PR: 223969
Reported by: Jeff Pieper
Reviewed by: imp
Differential Revision: https://reviews.freebsd.org/D13297
We periodically record synchronization progress in the metadata
block of the disk being synchronized; this allows an interrupted
synchronization to be resumed. However, the frequency of these
updates heavily pessimized synchronization time on some media. This
change modifies gmirror to update metadata based on a time period,
and adds a sysctl to control that period. The default value results
in a much lower update frequency and increases the completion time
for an interrupted rebuild only marginally.
Reported by: Andre Albsmeier <andre@fbsd.e4m.org>
MFC after: 3 weeks
This change adds an implementation of a sysent for running CloudABI
armv6 and armv7 binaries on FreeBSD/arm64. It is a somewhat literal copy
of the armv6 version, except that it's been patched up to use the proper
registers.
Just like for cloudabi32.ko on FreeBSD/amd64, we make use of a vDSO that
automatically pads system call parameters to 64-bit value. These are
stored in a buffer on the stack, meaning we need to use copyin() and
copyout() unconditionally.
"panic: vdev_geom_close_locked: cp->private is NULL"
This panic will result if ZFS fails to open a device due to either of the
following reasons:
1) The device's sector size is greater than 8KB.
2) ZFS wants to open the device RW, but it can't be opened for writing.
The solution is to change the initialization order to ensure that the
assertion will be satisfied.
PR: 221066
Reported by: David NewHamlet <wheelcomplex@gmail.com>
Reviewed by: avg
MFC after: 3 weeks
Sponsored by: Spectra Logic Corp
Differential Revision: https://reviews.freebsd.org/D13278
"panic: vdev_geom_close_locked: cp->private is NULL"
This panic will result if ZFS fails to open a device due to either of the
following reasons:
1) The device's sector size is greater than 8KB.
2) ZFS wants to open the device RW, but it can't be opened for writing.
The solution is to change the initialization order to ensure that the
assertion will be satisfied.
PR: 221066
Reported by: David NewHamlet <wheelcomplex@gmail.com>
Reviewed by: avg
MFC after: 3 weeks
Sponsored by: Spectra Logic Corp
Differential Revision: https://reviews.freebsd.org/D13278
