r357614 added CTLFLAG_NEEDGIANT to make it easier to find nodes that are
still not MPSAFE (or already are but aren’t properly marked).
Use it in preparation for a general review of all nodes.
This is non-functional change that adds annotations to SYSCTL_NODE and
SYSCTL_PROC nodes using one of the soon-to-be-required flags.
Approved by: kib (mentor, blanket)
Differential Revision: https://reviews.freebsd.org/D23636
If a failure happens reading the lid state, assume the lid is opened.
Suggested by: cem @
Differential Revision: https://reviews.freebsd.org/D23724
PR: 240881
MFC after: 1 week
Sponsored by: Mellanox Technologies
r357614 added CTLFLAG_NEEDGIANT to make it easier to find nodes that are
still not MPSAFE (or already are but aren’t properly marked).
Use it in preparation for a general review of all nodes.
This is non-functional change that adds annotations to SYSCTL_NODE and
SYSCTL_PROC nodes using one of the soon-to-be-required flags.
Mark all low hanging fruits as MPSAFE.
Reviewed by: markj
Approved by: kib (mentor, blanket)
Differential Revision: https://reviews.freebsd.org/D23626
The index should be computed as distance from arg[0] and not
the beginning of struct mlx5_ib_congestion .
While at it fix a use of zero length array to avoid depending
on undefined compiler behaviour.
MFC after: 1 week
Sponsored by: Mellanox Technologies
While at it update the sysctl(9) description for the lid state.
Differential Revision: https://reviews.freebsd.org/D23724
PR: 240881
Submitted by: Yuri Pankov <yuripv@yuripv.me>
MFC after: 1 week
Sponsored by: Mellanox Technologies
When we register an interrupt handler we need to pass the intr_type along in
bus_setup_intr().
The interrupt type matters because it is used to decide if we need to enter
NET_EPOCH. That meant that vtmmio-based if_vtnet did not, which led to panics
with INVARIANTS set.
Sponsored by: Axiado
The epoch stuff with taskqueues works fine if the driver never calls
the receive path in other contexts, but this driver does. If there was
a chip reset during active receive then part of the reset will call
the receive path to flush out any active packets before reinitialising
the receive queue and that needs to be done with the epoch held.
So:
* make the receive task a normal task again
* explicitly call epoch enter/exit around the legacy and newer DMA
receive paths
* add a couple of epoch asserts to ensure that the receive packet
path itself is called with epoch held.
This fixes it on my Atom eeepc laptop (circa 2010!) that I did
all of my initial 802.11n work in this driver and net80211.
Tested:
* AR9285, STA mode
TODO:
* Test on EDMA chipset (AR9380)
* Test in AP/adhoc modes, just to be sure (eg for beacon
receive processing in particular.)
ACPI Control Method Batteries have a _BIF and/or _BIX object which
provide static properties of the battery. FreeBSD acpi_cmbat module
supported _BIF object only, which was deprecated as of ACPI 4.0.
_BIX is an extended version of _BIF defined in ACPI 4.0 or later.
As of writing, _BIX has two revisions. One is in ACPI 4.0 (rev.0) and
another is in ACPI 6.0 (rev.1). It seems that hardware vendors still
stick to _BIF only or _BIX rev.0 + _BIF for the maximum compatibility.
Microsoft requires _BIX rev.0 for Windows machines, so there are some
laptop machines with _BIX rev.0 only. In this case, FreeBSD does not
recognize the battery information.
After this change, the acpi_cmbat module gets battery information from
_BIX or _BIF object and internally uses _BIX rev.1 data structure as
the primary information store in the kernel. ACPIIO_BATT_GET_BI[FX]
returns an acpi_bi[fx] structure built by using information obtained
from a _BIF or a _BIX object found on the system. The revision number
field can be used to check which field is available. The acpiconf(8)
utility will show additional information if _BIX is available.
Although ABIs of ACPIIO_BATT_* were changed, the existing APIs for
userland utilities are not changed and the backward-compatible ABIs
are provided. This means that older versions of acpiconf(8) can also
work with the new kernel. The (union acpi_battery_ioctl_arg) was
padded to 256 byte long to avoid another ABI change in the future.
A _BIX object with its revision number >1 will be treated as
compatible with the rev.1 _BIX format.
Reviewed by: takawata
MFC after: 1 week
Differential Revision: https://reviews.freebsd.org/D23728
buffer group.
This fixes a bug where congestion drops on port 1 of a T6 card would
incorrectly be counted as drops on port 0.
MFC after: 1 week
Sponsored by: Chelsio Communications
We need this to use EARLY_DRIVER_MODULE in child drivers on arm64. This
should be a no-op on x86 as it has DRIVER_MODULE in the nexus driver making
all later drivers attach in the last pass.
Reviewed by: imp
MFC after: 1 month
Sponsored by: Innovate UK
Differential Revision: https://reviews.freebsd.org/D23717
r357614 added CTLFLAG_NEEDGIANT to make it easier to find nodes that are
still not MPSAFE (or already are but aren’t properly marked). Use it in
preparation for a general review of all nodes.
This is non-functional change that adds annotations to SYSCTL_NODE and
SYSCTL_PROC nodes using one of the soon-to-be-required flags.
Reviewed by: imp, kib
Approved by: kib (mentor)
Differential Revision: https://reviews.freebsd.org/D23633
Fix the following -Werror warning from clang 10.0.0 in hptmv(4):
sys/dev/hptmv/ioctl.c:240:4: error: misleading indentation; statement is not part of the previous 'if' [-Werror,-Wmisleading-indentation]
_vbus_p=pArray->pVBus;
^
sys/dev/hptmv/ioctl.c:237:10: note: previous statement is here
if(!mIsArray(pArray))
^
This is because the return statement after the if statement was not
indented. (Note that this file has been idented assuming 4-space tabs.)
MFC after: 3 days
r357614 added CTLFLAG_NEEDGIANT to make it easier to find nodes that are
still not MPSAFE (or already are but aren’t properly marked). Use it in
preparation for a general review of all nodes.
This is non-functional change that adds annotations to SYSCTL_NODE and
SYSCTL_PROC nodes using one of the soon-to-be-required flags.
Reviewed by: hselasky, kib
Approved by: kib (mentor)
Differential Revision: https://reviews.freebsd.org/D23632
r357614 added CTLFLAG_NEEDGIANT to make it easier to find nodes that are
still not MPSAFE (or already are but aren’t properly marked). Use it in
preparation for a general review of all nodes.
This is non-functional change that adds annotations to SYSCTL_NODE and
SYSCTL_PROC nodes using one of the soon-to-be-required flags.
Reviewed by: kib, trasz
Approved by: kib (mentor)
Differential Revision: https://reviews.freebsd.org/D23640
The upstream OpenSSL changes only set the cipher for GCM since the
authentication is redundant, and changes to OCF will soon remove the
GCM authentication algorithm constants entirely for the same reason.
In addition, ktls_create_session() already validates these fields and
wouldn't pass down an invalid auth_algorithm value to any drivers or
ktls backends.
Reviewed by: hselasky
Sponsored by: Chelsio Communications
Differential Revision: https://reviews.freebsd.org/D23671
It duplicated the kern_tls_records stat and was not conditional on NIC
TLS being enabled.
Reviewed by: np
Sponsored by: Chelsio Communications
Differential Revision: https://reviews.freebsd.org/D23670
Initialize the FCH SMBus controller for Hygon Dhyana CPU.
Set the vendor of the FCH description via the exact CPU vendor.
Submitted by: Pu Wen <puwen@hygon.cn>
MFC after: 1 week
Differential revision: https://reviews.freebsd.org/D23558
Add support for decoding pressed keys as a bitmap. The keys in the
bitmap are described in the interface specific HID descriptor. Some
keyboards even have multiple input interfaces, only using the bitmap
method when the event array is full. That typically means when more
than seven keys are pressed simultaneously.
The internals of the USB keyboard driver have been slightly reworked
to keep track of all keys in a single bitmap having 256 bits. This
bitmap is then divided into blocks of 64-bits as an optimisation.
Simplify automatic key repeat logic, because only the last key pressed
can be repeated.
PR: 224592
PR: 233884
Tested by: Alex V. Petrov <alexvpetrov@gmail.com>
MFC after: 1 week
Sponsored by: Mellanox Technologies
It was saved from the initial purge of drivers in fcp-101 due to being
the onboard Ethernet device on a number of sparc64 machines. Now that
sparc64 is gone, it serves little purpose (PCI cards exist, but are rare
and are unlikely to have been deployed outside Sun systems).
MFC after: 3 days
Platform (N1SDP).
Neoverse N1 is a high-performance ARM microarchitecture designed
by the ARM Holdings for the server market.
The PCI part on N1SDP was shipped untested and suffers from some
integration issues.
For instance accessing to not existing BDFs causes System Error
(SError) exception. To mitigate this, the firmware scans the bus,
catches SErrors and creates a table with valid BDFs. That allows
us to filter-out accesses to invalid BDFs in this driver.
Also the root complex config space (BDF == 0) has an unusual
location in memory map, so remapping accesses to it is required.
Finally, the config space is restricted to 32-bit accesses only.
This was tested on the ARM boxes kindly provided by the ARM Ltd
to the DARPA CHERI Project.
In collaboration with: andrew
Reviewed by: andrew
Sponsored by: DARPA, AFRL
Differential Revision: https://reviews.freebsd.org/D23349
This patch introduces processing of the frames
up to 9kB by the mvneta driver. Some versions of
this NIC limit TX checksum offloading, depending
on the frame size, so add appropriate handling
of this feature.
Submitted by: Kornel Duleba
Obtained from: Semihalf
Sponsored by: Stormshield
Differential Revision: https://reviews.freebsd.org/D23225
To make the PMC tool pmcstat working properly on Hygon platform, add
support for Hygon Dhyana family 18h by using the PMC initialization
code path of AMD family 17h.
Submitted by: Pu Wen <puwen@hygon.cn>
MFC after: 1 week
Differential revision: https://reviews.freebsd.org/D23562
riscv cores.
GFE cores come with standard DTS file that lacks standard 'dmas ='
property, which means xae(4) could not find a DMA controller to use.
The 'dmas' property could not be added to the DTS file because the
ethernet controller and DMA engine parts in Linux are implemented
in a single driver.
Instead of 'dmas' property the standard Xilinx 'axistream-connected'
property is provided, so fallback to use it instead.
Suggested by: James Clarke <jrtc27@jrtc27.com>
Reviewed by: James Clarke <jrtc27@jrtc27.com>
Sponsored by: DARPA, AFRL
in the sysctl block for the driver. mpsutil/mprutil needs this so it can
know how big of a buffer to allocate when requesting the IOCFacts from the
controller. This eliminates the kernel console messages about wrong
allocation sizes.
Reported by: imp
BIO_READ and BIO_WRITE, we've handled this expanded syntax poorly in
drivers when the driver doesn't support a particular command. Do a
sweep and fix that.
Reported by: imp
Currently the Xen console is always attached with priority CN_REMOTE
(highest), which means that when booting with a single console the Xen
console will take preference over the VGA for example, and that's not
intended unless the user has also selected to use a serial console.
Fix this by lowering the priority of the Xen console to NORMAL unless
the user has selected to use a serial console. This keeps the usual
FreeBSD behavior of outputting to the internal consoles (ie: VGA) when
booted as a Xen dom0.
MFC after: 3 days
Sponsored by: Citrix Systems R&D
This means that extra virtual interfaces (VIs) created with
hw.cxgbe.num_vis are no longer required to use netmap. Use this
tunable to enable native netmap support on the main interface:
hw.cxgbe.native_netmap="3"
There is no change in default behavior.
Suggested by: jch@
MFC after: 2 weeks
Sponsored by: Chelsio Communications
In legacy VirtIO drivers, the header must be PCI endianness (little) and the
device-specific region is encoded in the native endian of the guest.
This patch makes the access (read/write) to VirtIO header using the little
endian order. Other read and write access are native endianness. This also
sets the device's IO region as big endian if on big endian machine.
PR: 205178
Submitted by: Andre Silva <afscoelho@gmail.com>
Reported by: Kenneth Salerno <kennethsalerno@yahoo.com>
Reviewed by: bryanv, bdragon, luporl, alfredo
Approved by: jhibbits (mentor)
Differential Revision: https://reviews.freebsd.org/D23401
