route in ifa_ifwithroute(), as the last resort, look up the route to
the gateway, not destination (to derive the interface from).
PR: kern/27852
Submitted by: Iasen Kostoff <tbyte@tbyte.org>
MFC after: 2 weeks
card bus bridges.
We now always use pci interrupts for pci cards. This will allow us to
more easily configure things. You must change your IRQ lines in
/etc/pccard.conf to match what we've probed. I'm not sure the right
way to deal with this right now.
Development of pci pcmcia has been funded by Monzoon Networks AG. I
am grateful for their generosity.
certain cases, and a close() by another process could potentially rip the
pipe out from under the (blocked) locking operation.
Reported-by: Alexander Viro <viro@math.psu.edu>
for card change interrupts is different than the pci stuff that's
coming soon. Set the management irq in different ways. If
pci_parallel interrutp routing, then use the PCI way of getting
interrupts. Move polling mode into pcic_isa since when we're routing
via pci polling doesn't work because many bridges (systems hang solid).
If we're routing interrupts via pci, they can be shared, so flag them
as such.
Note, this doesn't actually change anything since the pci attachment
isn't quite ready to be committed.
A attacker sending a lot of bogus fragmented packets to the target
(with different IPv4 identification field - ip_id), may be able
to put the target machine into mbuf starvation state.
By setting a upper limit on the number of reassembly queues we
prevent this situation.
This upper limit is controlled by the new sysctl
net.inet.ip.maxfragpackets which defaults to 200,
as the IPv6 case, this should be sufficient for most
systmes, but you might want to increase it if you have
lots of TCP sessions.
I'm working on making the default value dependent on
nmbclusters.
If you want old behaviour (no upper limit) set this sysctl
to a negative value.
If you don't want to accept any fragments (not recommended)
set the sysctl to 0 (zero).
Obtained from: NetBSD
MFC after: 1 week
if_up() must be called at splnet or higher.
Second, set the IFF_RUNNING flag on an interface after its
resources (i.e. tunnel source and destination addresses)
have been set. Note that we don't set IFF_UP because it is
if_up()'s job to do that.
PR: kern/27851
Submitted by: Horacio J. PeÓa <horape@compendium.com.ar>
The 3C509-TX card apparently had a slightly different version of the
chip, and has problems when this register is set. The problem does
not appear on the 3C509{BC} cards, but since only the fxp driver needs
specific bits set, conditionalize on that.
canonical: define a versioned struct xswdev, and add a sysctl node
handler that allows the user to get this structure for a certain device
index by specifying this index as last element of the MIB.
This new node handler, vm.swap_info, replaces the old vm.nswapdev
and vm.swapdevX.* (where X was the index) sysctls.
memory I/O space. Otherwise, our resource allocation system might
mistakenly assign pccard, plug and play devices or other things
addresses that conflict with ROMs.
I cleaned up his code a little from the submited driver: style(9)
issues, commentary on why something that looks incorrect really is
correct. Also noted that while a checksum field is defined for the
ROMs, enough common hardware neglects it to make it not worthwhile
checking.
Submitted by: Nikolai Saoukh <nms@otdel-1.org>
PR: 22078
the interface conversion to platform.pci_intr_route(). I've left the
platform.pci_intr_route() function pointer in place, as well as
alpha_pci_route_interrupt(), but no platform currently implements it.
To work around the removal of alpha_platform_assign_pciintr(cfg);
from the pci probe code, I've hooked in calls to platform.pci_intr_map()
in pcib_read_config (similar to the x86 APIC_IO ifdef in pci_cfgregread)
for every chipset that has a platform which needs it.
While here, I've removed the interupt mapping/routing code from the
AS2x00 platform because its not required (it has never been present in
-stable).
Tested on: UP1000, Miata(GL), XP1000, AS2100, AS500
Only tun0 -> tun32767 may now be opened as struct ifnet's if_unit
is a short.
It's now possible to open /dev/tun and get a handle back for an available
tun device (use devname to find out what you got).
The implementation uses rman by popular demand (and against my judgement)
to track opened devices and uses the new dev_depends() to ensure that
all make_dev()d devices go away before the module is unloaded.
Reviewed by: phk
- move the sysctl code to kern_intr.c
- do not use INTRCNT_COUNT, but rather eintrcnt - intrcnt to determine
the length of the intrcnt array
- move the declarations of intrnames, eintrnames, intrcnt and eintrcnt
from machine-dependent include files to sys/interrupt.h
- remove the hw.nintr sysctl, it is not needed.
- fix various style bugs
Requested by: bde
Reviewed by: bde (some time ago)
This closes a minor information leak which allows a remote observer to
determine the rate at which the machine is generating packets, since the
default behaviour is to increment a counter for each packet sent.
Reviewed by: -net
Obtained from: OpenBSD
setting the 'max packet size' register in window 3. This only
works for cards based on the cyclone or newer chipsets (i.e. it
won't work with the original 3c905/boomerang cards).
There is a trick which will work with the boomerang, which is to turn
on the 'large packets ok' bit in the MAC control register, however this
lets the chip accept any frame up to 4K in length, which is larger than
the mbuf cluster buffers we use to receive frames. If somebody sends us
such a frame and the chip DMAs it to us, it could write past the end
of the cluster buffer and clobber something.
PR: kern/27742
A attacker sending a lot of bogus fragmented packets to the target
(with different IPv4 identification field - ip_id), may be able
to put the target machine into mbuf starvation state.
By setting a upper limit on the number of reassembly queues we
prevent this situation.
This upper limit is controlled by the new sysctl
net.inet.ip.maxfragpackets which defaults to NMBCLUSTERS/4
If you want old behaviour (no upper limit) set this sysctl
to a negative value.
If you don't want to accept any fragments (not recommended)
set the sysctl to 0 (zero)
Obtained from: NetBSD (partially)
MFC after: 1 week
all alphas with devices behind ppb's. I'm working on a better solution now.
Note that all alphas that use per-platform interrupt mapping are broken
again (as they have been for several months)
gigabit ethernet controller chip. This device is used on some
fiber optic gigE cards from SMC, D-Link and Addtron. Jumbograms and
TCP/IP checksum offload on receive are supported. Hardware VLAN
filtering is not, because it doesn't play well with our existing
VLAN code. Also add manual page.
There is a 4.x version of this driver available at
http://www.freebsd.org/~wpaul/Level1/4.x if anyone feels adventurous
and wants to test it. I still need to do performance testing and
tuning with this device.
(For my next trick, I will make the 3Com 3cR990 sit up and beg.)
any response to our third SYN to work-around some broken
terminal servers (most of which have hopefully been retired)
that have bad VJ header compression code which trashes TCP
segments containing unknown-to-them TCP options.
PR: kern/1689
Submitted by: jesper
Reviewed by: wollman
MFC after: 2 weeks
