- Mark the link as down, so if watchdog reset fails, link watching
failover software can notice it
- Don't send MXGEFW_CMD_ETHERNET_DOWN if the NIC has been reset, it is
not needed, and will fail on a freshly reset NIC.
- Ensure the transmit routines aren't attempting to PIO write to doorbells
while the NIC is being reset.
- Download the correct f/w, rather than using the EEPROM f/w after reset.
- Export a count of the number of watchdog resets via sysctl
- Zero all f/w stats at reset. This will lead to less confusing
diagnostic output when investigating NIC failures.
MFC after: 3 days
then trapsignal is called with ksi.ksi_signo = 0. For debugging kernels,
that should end up in panic, for non-debugging kernels behaviour is
undefined.
Do panic regardeless of execution mode at the moment of trap.
Reviewed by: jhb
MFC after: 1 month
instead of SI_SUB_KLD. Note that we don't believe that there is any
consumers of x86bios that would be triggered in the early stage of boot,
so this is more or less just a safebelt.
Submitted by: swell.k at gmail.com
x86emu to this new module.
This changeset also brings a fix for bugs introduced with the initial
x86emu commit, which prevents the user from using some display mode or
cause instant reboots during mode switch.
Submitted by: paradox <ddkprog yahoo com>
Add a maximum response length for FCP RSPNS IUs.
Clarify some of the FC option words for setting parameters
and try and disable automatic PRLI when in target mode- this
should correct some cases of N-port topologies with 23XX cards
where we put out an illegal PRLI (in target mode only we're
not supposed to put out a PRLI).
of the linked object is zero-length. More old code assumes that mmap
of zero length returns success.
For a.out and pre-8 ELF binaries, allow the mmap of zero length.
Reported by: tegge
Reviewed by: tegge, alc, jhb
MFC after: 3 days
corresponding svn version if this is a git-svn clone'ed repo.
This prefers svn version information over git in case a working
directory has both .svn and .git directories.
MFC after: 3 days
X-MFC: not stable/8 before 8.0
allocations M_NOWAIT so that we don't try and sleep with a nested non-sleepable
lock.
This makes the userland scsi_target begin to function again.
Obtained from: Sean Bruno
MFC after: 1 month
Just take keyent_t to use an u_int to store the Unicode codepoints.
Unfortunately the keymap is now too big to be loaded using an ioctl
argument, so change the ioctl to pick a pointer.
This change breaks kbdcontrol ABI. It doesn't break X11, because X11
doesn't do anything with syscons keymaps. It just switches the device
out of K_XLATE.
Obtained from: //depot/user/ed/newcons/...
This code seems to do exactly the same as ttydisc_rint_simple() does
nowadays. Just remove it.
Obtained from: //depot/user/ed/newcons/sys/dev/syscons/syscons.c
run for re-acuiring the lock, but recheck if new pages are allocatable
from the pool and free the previously allocated ones.
Tested by: pho, Giovanni Trematerra
<giovanni dot trematerra at gmail dot com>
usable again with options VIMAGE kernels.
Submitted by: bz (the original version, probably identical to this one)
Reviewed by: many @ DevSummit Cambridge
MFC after: 3 days
- Implement MSI support (MSIX support was already there)
- Use a table to drive MSI/MSIX exceptions
- Pre-calculate the command address instead of wasting cycles doing the
calculation on every i/o.
number of MSIX interrupts that are needed, and don't strictly check for 4.
Enable enough interrupt mask bits so that the controller will generate
interrupts in PERFORMANT mode. This fixes the hang-on-boot issues that
people were seeing with newer controllers.
When authenticating DATA chunks some DATA chunks
might get stuck when the MTU gets decreased via
an ICMP message.
Approved by: rrs (mentor)
MFC after: immediately
