On a soekris Net5501, if you do a watchdog -t 16, followed by a watchdog
-t 0 to disable the watchdog, and then after some time (16s) re-enable
the watchdog the box reboots immediatly. This prevents also to stop and
restart watchdogd(8).
This is because when you stop the watchdog, the timer is not stoped,
only the hard reset is disabled. So when the timer has elapsed, the C2
event of the timer is set.
But when the hard reset is re-enabled, the event is not cleared and the
box reboots.
The attached patch stops and resets the counter when the watchdog is
disabled and do not disable the hard reset of the timer (if the timer
has elapsed it's too late).
Submitted by: Patrick Lamaizière
- add a moderation value to the Link vector
- allow disabling HW RSC on the 82599 if LRO
is not enabled.
- correct error in the stats code
- change optic type on the 82598 DA device
Thanks to Andrew Boyer for the changes.
We cannot expect that modspace is the last entry in the linker
set and thus that modspace + possible extra space up to PAGE_SIZE
would be contiguous. For the moment do not support more than
*_MODMIN space and ignore the extra space (*).
(*) We know how to get it back but it'll need testing.
Discussed with: jeff, rwatson (briefly)
Reviewed by: jeff
Sponsored by: The FreeBSD Foundation
Sponsored by: CK Software GmbH
MFC after: 4 days
implementation.
- Revert the Sun Fire V890 WAR of r205254. Instead let schizo_pci_bus()
only panic in case of fatal errors as the interrupt triggered by the
error the firmware of these and also Sun Fire 280R with version 7
Schizo caused may happen as late as using the HBA and not only prior
to touching the PCI bus (in the former case the actual error still is
fatal but we clear it before touching the PCI bus).
While at it count and export non-fatal error interrupts via sysctl(9).
- Remove unnecessary locking from schizo_ue().
RFA. Also drop frames that have either CRC error or alignment
error. Normally bad frames are not received at all. But controllers
running in promiscuous mode will receive bad frames. 82557 will
also receive bad frames to receive VLAN oversized frames.
While I'm here mark RNR condition if driver happen to see RNR in
RFA status and restart RU to receive frames again. Because driver
checks all received frames in RX loop, RNR condition could be set
in the middle of RX processing. Just relying on RNR interrupt was
not enough.
This change fixes "Memory modified after free" issue when fxp(4)
is running as a member of if_bridge(4).
Tested by: Larry Baird <lab <> gta dot com>
MFC after: 5 days
It includes the following changes:
- parallel reads in traversal code (Bug ID 6333409)
- faster traversal for zfs send (Bug ID 6418042)
- traversal code cleanup (Bug ID 6725675)
- fix for two scrub related bugs (Bug ID 6729696, 6730101)
- fix assertion in dbuf_verify (Bug ID 6752226)
- fix panic during zfs send with i/o errors (Bug ID 6577985)
- replace P2CROSS with P2BOUNDARY (Bug ID 6725680)
List of OpenSolaris Bug IDs:
6333409, 6418042, 6757112, 6725668, 6725675, 6725680,
6725698, 6729696, 6730101, 6752226, 6577985, 6755042
Approved by: pjd, delphij (mentor)
Obtained from: OpenSolaris (multiple Bug IDs)
MFC after: 1 week
from 2000 bytes to 20 Kbytes, which now matches the buffer size used for
NGM_BINARY2ASCII conversions.
The aim of this change is to allow for bigger binary structures to be
managed via netgraph ASCII messages, until we come up with an API
improvement which would get rid of such arbitrary hardcoded limits.
MFC after: 3 days
bottom of the manpages and order them consistently.
GNU groff doesn't care about the ordering, and doesn't even mention
CAVEATS and SECURITY CONSIDERATIONS as common sections and where to put
them.
Found by: mdocml lint run
Reviewed by: ru
microframe slot was not in the smask. The problem was that the EHCI driver was
then thinking that the transfer was immediately complete in some cases. Which
could lead to freeze-like situations, which can be recovered by unplugging the
USB device.
Reported by: Richard Kolkovich
Submitted by: Hans Petter Selasky
USB enumeration lock is locked, then the USB stack fails to resume the device
because locking the USB enumeration lock is part of the resume procedure. To
solve this issue a new lock is introduced which only protects the suspend and
resume callbacks, which can be dropped inside the usbd_do_request_flags()
function, to allow suspend and resume during so-called enumeration operations.
Submitted by: Hans Petter Selasky
- Make sure that when you kick the streams you add correctly
using a 16 bit unsigned.
- Make sure when sending out you allow FWD-TSN to skip over
and list the ACKED chunks in the stream/seq list (so the
rcv will kick the stream)
MFC after: 3 days
- Slide the map at the proper place.
- Mark the bits in the nr_array ONLY if there
is no marking.
- When generating a FWD-TSN we allow us to skip past
ACKED chunks too.
MFC after: 1 weeks
labeled iretq instruction.
Suppose that multithreaded process executes two threads, currently
scheduled on different processors. Let assume that thread A executes
using %cs or %ss pointing into the descriptor from LDT. If IPI comes
which handler does not return by jump to doreti, and meantime thread B
invalidates descriptor pointed to by %cs or %ss, then iretq from IPI
handler could fault.
Routing the return by doreti_iret allows kernel to catch the situation
and recover from it by sending signal to the usermode.
Tested by: pho
MFC after: 1 week
frame upon segment register load fault. The doreti procedure does not
load segment registers when returning to the kernel frame, and current
values in the segment descriptor cache already allow the kernel mode
to run, not modified by faulted loaded.
Suggested by: bde
Tested by: pho
MFC after: 1 week
