ip6addrctl_enable is set to YES, address selection policy is installed
into kernel.
If there is /etc/ip6addrctl.conf, it is used for address selection
policy. Even if there is no /etc/ip6addrctl.conf, we install default
policy. In this case, if ipv6_enable is set to YES, we use address
selection policy described in RFC 3484 as default. Otherwise, we
install priority policy for IPv4 address.
The default of ip6addrctl_enable is NO for now. However, it may
better to enable it by default.
/usr/local/www
[1] Semi-arbitrary cutoff, but I didn't want to add every locale directory
used by ports, because a lot are only used by one or two, and it's less
intrusive for these ports to just clean up after themselves.
MFC after: 2 days
The reason for doing this is that (at least some) 4.x binaries are very
unhappy if host.conf does not exist, and if we create host.conf but not
nsswitch.conf, nsswitch.conf will be created at the next reboot, so it
is better to create a correct nsswitch.conf right away.
use the conf/* stuff for their firewall configuration.
Running ipfw before could seem to make sense in that it would allow
one to setup access to the NFS server on a "default-deny" kernel,
but it is pretty obvious to the casual observer that such a configuration
never makes it far enough to mount the NFS-root in the first place.
debug.watchdog since it is not created by hardware watchdog(4) devices.
The watchdog(4) device is always compiled in the kernel, so removing the
check should not cause any problems.
Approved by: phk
initdiskless. The output of several commands and if available the
contents of /entropy are feed into /dev/random to kickstart the PRNG.
/etc/rc.d/initrandom is left alone to maintain the previous behavior as
much as possiable.
Further work in this area is probably needed.
Discussed with: markm
and permissions specified per rc.conf(5) now apply both to the md
device and to the mountpoint directory, after the mount has completed.
This has to be done in two steps, because chown is not available
until after /usr has been mounted, but the mdconfig and newfs steps
have to complete before fstab processing.
(when new natd is started before old natd died) and allows to manage natd
without touching ipfw.
natd should probably be killed with SIGKILL when stopping natd.
- Use sendmail_foo variables after load_rc_config so that they actually work.
- Utilize sendmail_procname.
- Check sendmail_submit_enable instead of sendmail_enable when dealing
with mail submission MTA.
comments and empty lines have been touched.
All of this should go in the diskless(8) manpage, now if we had
some kind of 'literate programming' tool to extract the comments
from the script and put them in a reasonable nroff format, it
would be a lot easier to keep code and docs in sync
+ SUBDIR.cpio.gz prevents files from SUBDIR/ to be copied when
priming the memory filesystems. This restores the old behaviour
and makes the copy process a lot more efficient
+ look for templates also in the list of directories supplied by
bootp/dhcp via the T134 option aka kern.bootp_cookie
+ keep track of directories temporarily mounted with "remount"
or "diskless_remount" commands and unmount them once we are done
with them (at the end of this script).
