to the current pcb.
Remove interrupt global defines; they use PCPU_REG now.
Move ATOMIC_INC_INT here from exception.s, add ATOMIC_DEC_INT.
Add a KASSERT macro for use in assembler.
instead of relying on the previous filters to be present.
Back out r1.125, as a reset is needed to unload any existing microcode,
(which clears the multicast addresses), as it is superceded by this change.
automatically extended to prevent overflow.
* Added sbuf_vprintf(); sbuf_printf() is now just a wrapper around
sbuf_vprintf().
* Include <stdio.h> and <string.h> when building libsbuf to silence
WARNS=4 warnings.
Reviewed by: des
macro. As a result, mandatory signal delivery policies will be
applied consistently across the kernel.
- Note that this subtly changes the protection semantics, and we should
watch out for any resulting breakage. Previously, delivery of SIGIO
in this circumstance was limited to situations where the subject was
privileged, or where one of the subject's (ruid, euid) matched one
of the object's (ruid, euid). In the new scenario, subject (ruid, euid)
are matched against the object's (ruid, svuid), and the object uid's
must be a subset of the subject uid's. Likewise, jail now affects
delivery, and special handling for P_SUGID of the object is present.
This change can always be reversed or tweaked if it proves to disrupt
application behavior substantially.
Obtained from: TrustedBSD Project
Sponsored by: DARPA, NAI Labs
authorized based on a subject credential rather than a subject process.
This will permit the same logic to be reused in situations where only
the credential generating the signal is available, such as in the
delivery of SIGIO.
- Because of two clauses, the automatic success against curproc,
and the session semantics for SIGCONT, not all logic can be pushed
into cr_cansignal(), but those cases should not apply for most other
consumers of cr_cansignal().
- This brings the base system inter-process authorization code more
into line with the MAC implementation.
Obtained from: TrustedBSD Project
Sponsored by: DARPA, NAI Labs
fifesystem problems could prevent the release from completing and
this could result in init being blocked indefinitely.
This was looked over by Matt ages ago.
Approved by: dillon
SMTX in utils such as ps and top. The KI_CTTY flag was assigned to
kinfo_proc->ki_kiflag rather than or'd into the flag, thus clobbering
any flags set earlier, including KI_MTXBLOCK.
Prodding by: peter
mutex releases to not require flags for the cases when preemption is
not allowed:
The purpose of the MTX_NOSWITCH and SWI_NOSWITCH flags is to prevent
switching to a higher priority thread on mutex releease and swi schedule,
respectively when that switch is not safe. Now that the critical section
API maintains a per-thread nesting count, the kernel can easily check
whether or not it should switch without relying on flags from the
programmer. This fixes a few bugs in that all current callers of
swi_sched() used SWI_NOSWITCH, when in fact, only the ones called from
fast interrupt handlers and the swi_sched of softclock needed this flag.
Note that to ensure that swi_sched()'s in clock and fast interrupt
handlers do not switch, these handlers have to be explicitly wrapped
in critical_enter/exit pairs. Presently, just wrapping the handlers is
sufficient, but in the future with the fully preemptive kernel, the
interrupt must be EOI'd before critical_exit() is called. (critical_exit()
can switch due to a deferred preemption in a fully preemptive kernel.)
I've tested the changes to the interrupt code on i386 and alpha. I have
not tested ia64, but the interrupt code is almost identical to the alpha
code, so I expect it will work fine. PowerPC and ARM do not yet have
interrupt code in the tree so they shouldn't be broken. Sparc64 is
broken, but that's been ok'd by jake and tmm who will be fixing the
interrupt code for sparc64 shortly.
Reviewed by: peter
Tested on: i386, alpha
hw.midi.debug and hw.midi.seq.debug to 1 to enable debug log.
- Make debug messages human-frendly.
- Implement /dev/music.
- Add a timer engine required by /dev/music.
- Fix nonblocking I/O.
- Fix the numbering of midi and synth devices.
firmware to delay completion of commands so that it can attempt to batch
a bunch of completions at once- either returning 16 bit handles in mailbox
registers, or in a resposne queue entry that has a whole wad of 16 bit handles.
Distinguish between 2300 and 2312 chipsets- if only because the revisions
on the chips have different meanings.
Add more instrumentation plus ISP_GET_STATS and ISP_CLR_STATS ioctls.
Run up the maximum number of response queue entities we'll look at
per interrupt.
If we haven't set HBA role yet, always return success from isp_fc_runstate.
MFC after: 2 weeks
(There has been some discussion, whether ENOENT or EBADF is more
appropriate. I choose the latter, since the operation is not supported
on the file descriptor at that time, even if it was, immediately before.)
PR: 32681
Reviewed by: dillon, iedowse, ...
Approved by: nectar
MFC after: 3 days
(pending RE approval)
substantial fraction of the number of entries of tte's in the tsb
would need to be looked up, traverse the tsb instead. This is crucial
in some places, e.g. when swapping out a process, where a certain
pmap_remove() call would take very long time to complete without this.
2. Implement pmap_qenter_flags(), which will become used later
3. Reactivate the instruction cache flush done when mapping as executable.
This is required e.g. when executing files via NFS, but is known to
cause problems on UltraSPARC-IIe CPU's. If you have such a CPU, you
will need to comment this call out for now.
Submitted by: jake (3)
