incorrectly calling vm_object_page_clean(). They are passing the length of
the range rather than the ending offset of the range.
Perform the OFF_TO_IDX() conversion in vm_object_page_clean() rather than the
callers.
Reviewed by: kib
MFC after: 3 weeks
MAP_STACK_* entries. (See r71983 and r74235.)
In some cases, performing this call to vm_map_simplify_entry() halves the
number of vm map entries used by the Sun JDK.
sbuf_new_for_sysctl(9). This allows using an sbuf with a SYSCTL_OUT
drain for extremely large amounts of data where the caller knows that
appropriate references are held, and sleeping is not an issue.
Inspired by: rwatson
assertion that is no longer required. Long ago, calls to vm_page_alloc()
from an interrupt handler had to specify VM_ALLOC_INTERRUPT so that
vm_page_alloc() would not attempt to reclaim a PQ_CACHE page from another vm
object. Today, with the synchronization on a vm object's collection of
PQ_CACHE pages, this is no longer an issue. In fact, VM_ALLOC_INTERRUPT now
reclaims PQ_CACHE pages just like VM_ALLOC_{NORMAL,SYSTEM}.
MFC after: 3 weeks
OBJT_PHYS objects. Thus, there is no need for handling them specially
in vm_fault(). In fact, this special case handling would have led to
an assertion failure just before the call to pmap_enter().
Reviewed by: kib@
MFC after: 6 weeks
need it anymore. Moreover, its implementation had a type mismatch, a
long is not necessarily an uint64_t. (This mismatch was hidden by
casting.) Move the remaining two counters up a level in the sysctl
hierarchy. There is no reason for them to be under the vm.pmap node.
Reviewed by: kib
hold this lock until the end of the function.
With the aforementioned change to vm_pageout_clean(), page locks don't need
to support recursive (MTX_RECURSE) or duplicate (MTX_DUPOK) acquisitions.
Reviewed by: kib
consumer of the flag, and it used the flag because OBJ_MIGHTBEDIRTY
was cleared early in vm_object_page_clean, before the cleaning pass
was done. This is no longer true after r216799.
Moreover, since OBJ_CLEANING is a flag, and not the counter, it could
be reset too prematurely when parallel vm_object_page_clean() are
performed.
Reviewed by: alc (as a part of the bigger patch)
MFC after: 1 month (after r216799 is merged)
instead skip over them. As long as a page is held, it can't be reclaimed by
contigmalloc(M_WAITOK). Moreover, a held page may be undergoing
modification, e.g., vmapbuf(), so even if the hold were released before the
completion of contigmalloc(), the page might have to be flushed again.
MFC after: 3 weeks
vm_object_set_writeable_dirty().
Fix an issue where restart of the scan in vm_object_page_clean() did
not removed write permissions for newly added pages or, if the mapping
for some already scanned page changed to writeable due to fault.
Merge the two loops in vm_object_page_clean(), doing the remove of
write permission and cleaning in the same loop. The restart of the
loop then correctly downgrade writeable mappings.
Fix an issue where a second caller to msync() might actually return
before the first caller had actually completed flushing the
pages. Clear the OBJ_MIGHTBEDIRTY flag after the cleaning loop, not
before.
Calls to pmap_is_modified() are not needed after pmap_remove_write()
there.
Proposed, reviewed and tested by: alc
MFC after: 1 week
condition in proc_rwmem() and to (2) simplify the implementation of the
cxgb driver's vm_fault_hold_user_pages(). Specifically, in proc_rwmem()
the requested read or write could fail because the targeted page could be
reclaimed between the calls to vm_fault() and vm_page_hold().
In collaboration with: kib@
MFC after: 6 weeks
vmspace_fork and vm_map_wire that would lead to "vm_fault_copy_wired: page
missing" panics. While faulting in pages for a map entry that is being
wired down, mark the containing map as busy. In vmspace_fork wait until the
map is unbusy, before we try to copy the entries.
Reviewed by: kib
MFC after: 5 days
Sponsored by: Isilon Systems, Inc.
mapped and entered via vm_page_setup, keep track of it like we do
for amd64.
# A separate commit will be made to move this to a capability-based ifdef
# rather than arch-based ifdef.
Submitted by: alc@
MFC after: 1 week
in "struct vm_object". This is required to make it possible to account
for per-jail swap usage.
Reviewed by: kib@
Tested by: pho@
Sponsored by: FreeBSD Foundation
vm_page_startup(). Specifically, the dump_avail array should be used
instead of the phys_avail array to calculate the size of vm_page_dump. For
example, the pages for the message buffer are allocated prior to
vm_page_startup() by subtracting them from the last entry in the phys_avail
array, but the first thing that vm_page_startup() does after creating the
vm_page_dump array is to set the bits corresponding to the message buffer
pages in that array. However, these bits might not actually exist in the
array, because the size of the array is determined by the current value in
the last entry of the phys_avail array. In general, the only reason why
this doesn't always result in an out-of-bounds array access is that the size
of the vm_page_dump array is rounded up to the next page boundary. This
change eliminates that dependence on rounding (and luck).
MFC after: 6 weeks
The current implementation of vm_page_alloc_freelist() does not handle
order > 0 correctly. Remove order parameter to the function and use it
only for order 0 pages.
Submitted by: alc
backing storage. Such pages might be then reused, racing with the
assert in vm_object_page_collect_flush() that verified that dirty
pages from the run (most likely, pages with VM_PAGER_AGAIN status) are
write-protected still. In fact, the page indexes for the pages that
were removed from the object page list should be ignored by
vm_object_page_clean().
Return the length of successfully written run from vm_pageout_flush(),
that is, the count of pages between requested page and first page
after requested with status VM_PAGER_AGAIN. Supply the requested page
index in the array to vm_pageout_flush(). Use the returned run length
to forward the index of next page to clean in vm_object_page_clean().
Reported by: avg
Reviewed by: alc
MFC after: 1 week
object page list. The only use of object generation count now is a
restart of the scan in vm_object_page_clean(), which makes sense to do
on the page addition. Page removals do not affect the dirtiness of the
object, as well as manipulations with the shadow chain.
Suggested and reviewed by: alc
MFC after: 1 week
The ports/Mk/bsd.port.mk uses sys/param.h to fetch osrel, and cannot
grok several constants with the prefix.
Reported and tested by: swell.k gmail com
MFC after: 1 week
The unmapped page separates the tip of the stack and possible adjanced
segment, making some uses of stack overflow harder. The stack growing
code refuses to expand the segment to the last page of the reseved
region when sysctl security.bsd.stack_guard_page is set to 1. The
default value for sysctl and accompanying tunable is 0.
Please note that mmap(MAP_FIXED) still can place a mapping right up to
the stack, making continuous region.
Reviewed by: alc
MFC after: 1 week
