- Allow setting format, resolution and accuracy of BPF time stamps per
listener. Previously, we were only able to use microtime(9). Now we can
set various resolutions and accuracies with ioctl(2) BIOCSTSTAMP command.
Similarly, we can get the current resolution and accuracy with BIOCGTSTAMP
command. Document all supported options in bpf(4) and their uses.
- Introduce new time stamp 'struct bpf_ts' and header 'struct bpf_xhdr'.
The new time stamp has both 64-bit second and fractional parts. bpf_xhdr
has this time stamp instead of 'struct timeval' for bh_tstamp. The new
structures let us use bh_tstamp of same size on both 32-bit and 64-bit
platforms without adding additional shims for 32-bit binaries. On 64-bit
platforms, size of BPF header does not change compared to bpf_hdr as its
members are already all 64-bit long. On 32-bit platforms, the size may
increase by 8 bytes. For backward compatibility, struct bpf_hdr with
struct timeval is still the default header unless new time stamp format is
explicitly requested. However, the behaviour may change in the future and
all relevant code is wrapped around "#ifdef BURN_BRIDGES" for now.
- Add experimental support for tagging mbufs with time stamps from a lower
layer, e.g., device driver. Currently, mbuf_tags(9) is used to tag mbufs.
The time stamps must be uptime in 'struct bintime' format as binuptime(9)
and getbinuptime(9) do.
Reviewed by: net@
interface when tearing down a vlan interface. If a trunk interface is
detached, all of its multicast addresses are removed before the ifnet
departure eventhandlers are invoked. This means that all of the multicast
addresses are removed before the vlan interfaces are removed which causes
the if_delmulti() calls in the vlan teardown to fail.
In the VLAN_ARRAY case, this left vlan interfaces referencing a no longer
valid parent interface. In the !VLAN_ARRAY case, the eventhandler gets
stuck in an infinite loop retrying vlan_unconfig_locked() forever. In
general the callers of vlan_unconfig_locked() do not expect nor handle
failure, so I believe it is safer to ignore the errors and tear down as
much of the vlan state as possible.
Silence from: net@
MFC after: 4 days
We cannot expect that modspace is the last entry in the linker
set and thus that modspace + possible extra space up to PAGE_SIZE
would be contiguous. For the moment do not support more than
*_MODMIN space and ignore the extra space (*).
(*) We know how to get it back but it'll need testing.
Discussed with: jeff, rwatson (briefly)
Reviewed by: jeff
Sponsored by: The FreeBSD Foundation
Sponsored by: CK Software GmbH
MFC after: 4 days
queue length. The default value for this parameter is 50, which is
quite low for many of today's uses and the only way to modify this
parameter right now is to edit if_var.h file. Also add read-only
sysctl with the same name, so that it's possible to retrieve the
current value.
MFC after: 1 month
architecture from page queue lock to a hashed array of page locks
(based on a patch by Jeff Roberson), I've implemented page lock
support in the MI code and have only moved vm_page's hold_count
out from under page queue mutex to page lock. This changes
pmap_extract_and_hold on all pmaps.
Supported by: Bitgravity Inc.
Discussed with: alc, jeffr, and kib
"Whitspace" churn after the VIMAGE/VNET whirls.
Remove the need for some "init" functions within the network
stack, like pim6_init(), icmp_init() or significantly shorten
others like ip6_init() and nd6_init(), using static initialization
again where possible and formerly missed.
Move (most) variables back to the place they used to be before the
container structs and VIMAGE_GLOABLS (before r185088) and try to
reduce the diff to stable/7 and earlier as good as possible,
to help out-of-tree consumers to update from 6.x or 7.x to 8 or 9.
This also removes some header file pollution for putatively
static global variables.
Revert VIMAGE specific changes in ipfilter::ip_auth.c, that are
no longer needed.
Reviewed by: jhb
Discussed with: rwatson
Sponsored by: The FreeBSD Foundation
Sponsored by: CK Software GmbH
MFC after: 6 days
Add missing CURVNET_RESTORE() calls for multiple code paths, to stop
leaking the currently cached vnet into callers and to the process.
Sponsored by: The FreeBSD Foundation
Sponsored by: CK Software GmbH
MFC after: 4 days
bd_compat32 field of struct bpf_d is kept unconditionally to not
impose the requirement of including "opt_compat.h" on all numerous
users of bpfdesc.h.
Submitted by: jhb (version for 6.x)
Reviewed and tested by: emaste
MFC after: 2 weeks
interface considers that it hits a fatal error, and will not copyout
the request structure back for _IOW and _IOWR ioctls, keeping them
untouched.
The previous implementation of the SIOCGIFDESCR ioctl intends to
feed the buffer length back to userland. However, if we return
an error, the feedback would be defeated and ifconfig(8) would
trap into an infinite loop.
This commit changes SIOCGIFDESCR to set buffer field to NULL to
indicate the previous ENAMETOOLONG case.
Reported by: bschmidt
MFC after: 2 weeks
to remove it to avoid panics in case of two threads trying to remove it in
parallel.
PR: kern/116837
Submitted by: Takahiro Kurosawa (takahiro.kurosawa gmail.com) (orig version)
MFC after: 10 days
prevented the link-layer entry from being freed.
In both in.c and in6.c (though that code path seems to be basically dead)
plug a reference leak in case of a pending callout being drained.
In if_ether.c consistently add a reference before resetting the callout
and in case we canceled a pending one remove the reference for that.
In the final case in arptimer, before freeing the expired entry, remove
the reference again and explicitly call callout_stop() to clear the active
flag.
In nd6.c:nd6_free() we are only ever called from the callout function and
thus need to remove the reference there as well before calling into
llentry_free().
In if_llatbl.c when freeing entire tables make sure that in case we cancel
a pending callout to remove the reference as well.
Reviewed by: qingli (earlier version)
MFC after: 10 days
Problem observed, patch tested by: simon on ipv6gw.f.o,
Christian Kratzer (ck cksoft.de),
Evgenii Davidov (dado korolev-net.ru)
PR: kern/144564
Configurations still affected: with options FLOWTABLE
dom_ifdetach() calls as they might sleep for callout_drain().
Do as we do in if_attachdomain1() [r121470] and handle
if_afdata_initialized earlier and call dom_ifdetach() unlocked.
Discussed with: rwatson
MFC after: 10 days
has actually succeeded to initialize and attach. There is a theoretical
possibility to drop out early in if_attachdomain1() leaving the array
uninitialized if we cannot get the lock.
Discussed with: rwatson
MFC after: 10 days
- increase flow cleaning frequency and decrease flow caching time
when near the flow limit
- stop allocating new flows when within 3% of maxflows don't start
allocating again until below 12.5%
MFC after: 7 days
that provides the allocated and setup eventhandler entry.
Add a new wrapper for VIMAGE that allocates extra space to hold the
callback function and argument in addition to an extra wrapper function.
While the wrapper function goes as normal callback function the
argument points to the extra space allocated holding the original func
and arg that the wrapper function can then call.
Provide an iterator function for the virtual network stack (vnet) that
will call the callback function for each network stack.
Provide a new set of macros for VNET that in the non-VIMAGE case will
just call eventhandler_register() while in the VIMAGE case it will use
vimage_eventhandler_register() passing in the extra iterator function
but will only register once rather than per-vnet.
We need a special macro in case we are interested in the tag returned
as we must check for curvnet and can neither simply assign the
return value, nor not change it in the non-vnet0 case without that.
Sponsored by: ISPsystem
Discussed with: jhb
Reviewed by: zec (earlier version), jhb
MFC after: 1 month
- show all lltables [1] (optional flag to also show the llentries as well)
- show lltable <struct lltable *>
- show llentry <struct llentry *>
MFC after: 6 days
if the interface has such capability. The interface
capability flag indicates whether such capability
exists. This approach is much more backward compatible.
Physical device driver changes will be part of another
commit.
Also updated the ifconfig utility to show the LINKSTATE
capability if present.
Reviewed by: rwatson, imp, juli
MFC after: 3 days
- Add a missing callout_drain(9) before the descriptor deallocation.[1]
- Prefer callout_init_mtx(9) over callout_init(9) and let the callout
subsystem handle the mutex for callout function.
PR: kern/144453
Submitted by: Alexander Sack (asack at niksun dot com)[1]
MFC after: 1 week
address as well as the transport protocol port information
from the outbound packets. The routing code is generic and
compares every byte in the given sockaddr object. Therefore
the temporary sockaddr objects must be cleared due to padding
bytes. In addition, the port information must be stripped
or the route search will either fail or return the incorrect
route entry.
Unit testing is done using OpenVPN over the if_tun interface.
MFC after: 7 days
- add a name argument to flowtable_alloc for printing with ddb commands
- extend ddb commands to print destination address or 4-tuples
- don't parse ports in ulp header if FL_HASH_ALL is not passed
- add kern_flowtable_insert to enable more generic use of flowtable
(e.g. system calls for adding entries)
- don't hash loopback addresses
- cleanup whitespace
- keep statistics per-cpu for per-cpu flowtables to avoid cache line contention
- add sysctls to accumulate stats and report aggregate
MFC after: 7 days
does not set or update the if_link_state variable.
As such RT_LINK_IS_UP() fails for the if_tap interface.
Also, the RT_LINK_IS_UP() needs to bypass all loopback
interfaces because loopback interfaces are considered
up logically as long as the system is running.
This patch fixes the above issues by setting and updating
the if_link_state variable when the tap interface is
opened or closed respectively. Similary approach is
already done in the if_tun device.
MFC after: 3 days
allow for connection load balancing across interfaces. Currently
the address alias handling method is colliding with the ECMP code.
For example, when two interfaces are configured on the same prefix,
only one prefix route is installed. So connection load balancing
among the available interfaces is not possible.
The other advantage of ECMP is for failover. The issue with the
current code, is that the interface link-state is not reflected
in the route entry. For example, if there are two interfaces on
the same prefix, the cable on one interface is unplugged, new and
existing connections should switch over to the other interface.
This is not done today and packets go into a black hole.
Also, there is a small bug in the kernel where deleting ECMP routes
in the userland will always return an error even though the command
is successfully executed.
MFC after: 5 days
radix table root nodes. This is only needed (and available)
in the virtualization case to free the resources when tearing
down a virtual network stack.
Sponsored by: ISPsystem
Reviewed by: julian, zec
MFC after: 5 days
or overflow the netisr queue and fall back to the interface
queue so that we can garuantee that the ifnet pointer stays
valid. Formerly we ended up with reference counts <= 0 in
case the netisr had returned ENOBUFS. The idea is to track
any packet in the netisr queue and only change the refount
on edge operations for the fallback interface queue. This
also avoids problems in case the if_snd.ifq_len lies to us.
Also rework refount assertions to make sure they trigger if
we go below 1. Formerly a negative refence count did not
trigger the assert as the refcount variable is u_int.
Sponsored by: ISPsystem
MFC after: 5 days
and tested over the past two months in the ipfw3-head branch. This
also happens to be the same code available in the Linux and Windows
ports of ipfw and dummynet.
The major enhancement is a completely restructured version of
dummynet, with support for different packet scheduling algorithms
(loadable at runtime), faster queue/pipe lookup, and a much cleaner
internal architecture and kernel/userland ABI which simplifies
future extensions.
In addition to the existing schedulers (FIFO and WF2Q+), we include
a Deficit Round Robin (DRR or RR for brevity) scheduler, and a new,
very fast version of WF2Q+ called QFQ.
Some test code is also present (in sys/netinet/ipfw/test) that
lets you build and test schedulers in userland.
Also, we have added a compatibility layer that understands requests
from the RELENG_7 and RELENG_8 versions of the /sbin/ipfw binaries,
and replies correctly (at least, it does its best; sometimes you
just cannot tell who sent the request and how to answer).
The compatibility layer should make it possible to MFC this code in a
relatively short time.
Some minor glitches (e.g. handling of ipfw set enable/disable,
and a workaround for a bug in RELENG_7's /sbin/ipfw) will be
fixed with separate commits.
CREDITS:
This work has been partly supported by the ONELAB2 project, and
mostly developed by Riccardo Panicucci and myself.
The code for the qfq scheduler is mostly from Fabio Checconi,
and Marta Carbone and Francesco Magno have helped with testing,
debugging and some bug fixes.
