is already in 32-bit mode, we need to be able to detect this and still
read the chip ID code. Detecting 32-bit mode is actually a little
tricky, since we want to avoid turning it on accidentally. The easiest
way to do it is to just try and read the PCI subsystem ID from the
bus control registers using 16-bit accesses and compare that with the
value read from PCI config space. If they match, then we know we're in
16-bit mode, otherwise we assume 32-bit mode.
instead of ng_send_data().
The latter could lead to running the IP stack at splimp
instead of splnet, (among other problems) (that MAY be safe
but I wouldn't count on it).
Noticed while preparing a new set of netgraph stuff.
counter register in-CPU.
This is to be used as a fast "timer", where linearity is more important
than time, and multiple lines in the linearity caused by multiple CPUs
in an SMP machine is not a problem.
This adds no code whatsoever to the FreeBSD kernel until it is actually
used, and then as a single-instruction inline routine (except for the
80386 and 80486 where it is some more inline code around nanotime(9).
Reviewed by: bde, kris, jhb
a kevent upon completion of the I/O. Specifically, introduce a new type
of sigevent notification, SIGEV_EVENT. If sigev_notify is SIGEV_EVENT,
then sigev_notify_kqueue names the kqueue that should receive the event
and sigev_value contains the "void *" is copied into the kevent's udata
field.
In contrast to the existing interface, this one: 1) works on
the Alpha 2) avoids the extra copyin() call for the kevent because all
of the information needed is in the sigevent and 3) could be
applied to request a single kevent upon completion of an entire lio_listio().
Reviewed by: jlemon
- move the call to cia_init_sgmap() to after we've determined if we're a pyxis
- convert needed splhigh() in cia_sgmap_invalidate_pyxis() to disable_intr()
Previously, any isa DMA on a pyxis based machine would cause a panic
in cia_sgmap_invalidate_pyxis() because the pyxis workaround was never
setup.
- while i'm at it, convert needed splhigh() in cia_swiz_set_hae_mem to
disable_intr()
in the face of multiple processes doing massive numbers of filesystem
operations. While this patch will work in nearly all situations, there
are still some perverse workloads that can overwhelm the system.
Detecting and handling these perverse workloads will be the subject
of another patch.
Reviewed by: Paul Saab <ps@yahoo-inc.com>
Obtained from: Ethan Solomita <ethan@geocast.com>
could not compress into clusters. This could result in lots of
wasted clusters while recieving small packets from an interface
that uses clusters for all it's packets.
Patch is partially from BSDi (limiting the size of the copy) and
based on a patch for 4.1 by Ian Dowse <iedowse@maths.tcd.ie> and
myself.
Reviewed by: bmilekic
Obtained From: BSDi
Submitted by: iedowse
- Use the mutex in hardclock to ensure no races between it and
softclock.
- Make softclock be INTR_MPSAFE and provide a flag,
CALLOUT_MPSAFE, which specifies that a callout handler does not
need giant. There is still no way to set this flag when
regstering a callout.
Reviewed by: -smp@, jlemon
Removed most of the hacks that were trying to deal with low-memory
situations prior to now.
The new code is based on the concept that I/O must be able to function in
a low memory situation. All major modules related to I/O (except
networking) have been adjusted to allow allocation out of the system
reserve memory pool. These modules now detect a low memory situation but
rather then block they instead continue to operate, then return resources
to the memory pool instead of cache them or leave them wired.
Code has been added to stall in a low-memory situation prior to a vnode
being locked.
Thus situations where a process blocks in a low-memory condition while
holding a locked vnode have been reduced to near nothing. Not only will
I/O continue to operate, but many prior deadlock conditions simply no
longer exist.
Implement a number of VFS/BIO fixes
(found by Ian): in biodone(), bogus-page replacement code, the loop
was not properly incrementing loop variables prior to a continue
statement. We do not believe this code can be hit anyway but we
aren't taking any chances. We'll turn the whole section into a
panic (as it already is in brelse()) after the release is rolled.
In biodone(), the foff calculation was incorrectly
clamped to the iosize, causing the wrong foff to be calculated
for pages in the case of an I/O error or biodone() called without
initiating I/O. The problem always caused a panic before. Now it
doesn't. The problem is mainly an issue with NFS.
Fixed casts for ~PAGE_MASK. This code worked properly before only
because the calculations use signed arithmatic. Better to properly
extend PAGE_MASK first before inverting it for the 64 bit masking
op.
In brelse(), the bogus_page fixup code was improperly throwing
away the original contents of 'm' when it did the j-loop to
fix the bogus pages. The result was that it would potentially
invalidate parts of the *WRONG* page(!), leading to corruption.
There may still be cases where a background bitmap write is
being duplicated, causing potential corruption. We have identified
a potentially serious bug related to this but the fix is still TBD.
So instead this patch contains a KASSERT to detect the problem
and panic the machine rather then continue to corrupt the filesystem.
The problem does not occur very often.. it is very hard to
reproduce, and it may or may not be the cause of the corruption
people have reported.
Review by: (VFS/BIO: mckusick, Ian Dowse <iedowse@maths.tcd.ie>)
Testing by: (VM/Deadlock) Paul Saab <ps@yahoo-inc.com>
Pre-rfork code assumed inherent locking of a process's file descriptor
array. However, with the advent of rfork() the file descriptor table
could be shared between processes. This patch closes over a dozen
serious race conditions related to one thread manipulating the table
(e.g. closing or dup()ing a descriptor) while another is blocked in
an open(), close(), fcntl(), read(), write(), etc...
PR: kern/11629
Discussed with: Alexander Viro <viro@math.psu.edu>
are in softclock() for a long time. The old code already did an
splx()/slphigh() pair here, I just missed adding in the equivalent mutex
operations on sched_lock earlier.
This makes crash recovery work for stripe sizes that are not multiples of
DEFAULT_REVIVE_BLOCKSIZE (currently 64 kB).
While we're here, fix a few cosmetic nits.
Reviewed by: grog
Sponsored by: Enitel ASA (http://www.enitel.no/)
may block on a mutex while on the sleep queue without corrupting
it.
- Move dropping of Giant to after the acquire of sched_lock.
Tested by: John Hay <jhay@icomtek.csir.co.za>
jhb
instead of DIAGNOSTIC.
- Remove the p_wchan check as it no longer applies since a process may be
switched out during CURSIG() within msleep() or mawait().
- Remove an extra sanity check only needed during the early SMPng work.
with Julian and Archie.
Implement a new ``sizedstring'' parse type for dealing with field pairs
consisting of a uint16_t followed by a data field of that size, and use
this to deal with the data_len and data fields.
Written by: Archie with some input by me
Agreed in principle by: julian
