bcm4306 cards are ambiguous. BCM4306 rev 2 requires bwi. BCM4306 rev
3 will work with either. Since we can't easily determine which is
which, just remove them.
The $ip6addrctl_policy is a variable to choose a pre-defined address
selection policy set by ip6addrctl(8).
The keyword "ipv4_prefer" sets IPv4-preferred one described in Section 10.3,
the keyword "ipv6_prefer" sets IPv6-preferred one in Section 2.1 in RFC 3484,
respectively. When "AUTO" is specified, it attempts to read
/etc/ip6addrctl.conf first. If it is found, it reads and installs it as
a policy table. If not, either of the two pre-defined policy tables is
chosen automatically according to $ipv6_activate_all_interfaces.
When $ipv6_activate_all_interfaces=NO, interfaces which have no corresponding
$ifconfig_IF_ipv6 is marked as IFDISABLED for security reason.
The default values are ip6addrctl_policy=AUTO and
ipv6_activate_all_interfaces=NO.
Discussed with: ume and bz
code associated with overflow or with the drain function. While this
function is not expected to be used often, it produces more information
in the form of an errno that sbuf_overflowed() did.
define USDT probes on a provider.d file and then use this new make
infrastructure to build the corresponding header file and object file.
This will only take effect when the user defines WITH_DTRACE when building.
Sponsored by: The FreeBSD Foundation
called when the sbuf internal buffer is filled. For kernel sbufs with a
drain, the internal buffer will never be expanded. For userland sbufs
with a drain, the internal buffer may still be expanded by
sbuf_[v]printf(3).
Sbufs now have three basic uses:
1) static string manipulation. Overflow is marked.
2) dynamic string manipulation. Overflow triggers string growth.
3) drained string manipulation. Overflow triggers draining.
In all cases the manipulation is 'safe' in that overflow is detected and
managed.
Reviewed by: phk (the previous version)
a solution is using PIO mode. As fas as I know all open source based
broadcom drivers for specially LP PHY has this issue because it's
a reverse engineered driver from wl(4).
Pointed by: Warren Block <wblock at wonkity.com>
- add rm_try_rlock().
- add RM_SLEEPABLE to use sx(9) as the back-end lock in order to sleep while
holding the write lock.
- change rm_noreadtoken to a cpu bitmask to indicate which CPUs need to go
through the lock/unlock in order to synchronize. As a side effect, this
also avoids IPI to CPUs without any readers during rm_wlock.
Discussed with: ups@, rwatson@ on arch@
Sponsored by: Isilon Systems, Inc.
