(This eliminates a surprising number of page queues lock acquisitions by
vm_fault() because the page's queue is PQ_NONE and thus the page queues
lock is not needed to remove the page from a queue.)
vm_page_try_to_free(). Consequently, push down the page queues lock into
pmap_enter_quick(), pmap_page_wired_mapped(), pmap_remove_all(), and
pmap_remove_write().
Push down the page queues lock into Xen's pmap_page_is_mapped(). (I
overlooked the Xen pmap in r207702.)
Switch to a per-processor counter for the total number of pages cached.
managed pages that didn't already have that lock held. (Freeing an
unmanaged page, such as the various pmaps use, doesn't require the page
lock.)
This allows a change in vm_page_remove()'s locking requirements. It now
expects the page lock to be held instead of the page queues lock.
Consequently, the page queues lock is no longer required at all by callers
to vm_page_rename().
Discussed with: kib
to unconditionally set PG_REFERENCED on a page before sleeping. In many
cases, it's perfectly ok for the page to disappear, i.e., be reclaimed by
the page daemon, before the caller to vm_page_sleep() is reawakened.
Instead, we now explicitly set PG_REFERENCED in those cases where having
the page persist until the caller is awakened is clearly desirable. Note,
however, that setting PG_REFERENCED on the page is still only a hint,
and not a guarantee that the page should persist.
architecture from page queue lock to a hashed array of page locks
(based on a patch by Jeff Roberson), I've implemented page lock
support in the MI code and have only moved vm_page's hold_count
out from under page queue mutex to page lock. This changes
pmap_extract_and_hold on all pmaps.
Supported by: Bitgravity Inc.
Discussed with: alc, jeffr, and kib
the page table entry's accessed bit is either preset by the immediately
preceding call to pmap_enter() or by hardware (or software) upon return
from vm_fault() when the faulting access is restarted.
killed by OOM. When killed process waits for a page allocation, try to
satisfy the request as fast as possible.
This removes the often encountered deadlock, where OOM continously
selects the same victim process, that sleeps uninterruptibly waiting
for a page. The killed process may still sleep if page cannot be
obtained immediately, but testing has shown that system has much
higher chance to survive in OOM situation with the patch.
In collaboration with: pho
Reviewed by: alc
MFC after: 4 weeks
represented a write access that is allowed to override write protection.
Until now, VM_PROT_OVERRIDE_WRITE has been used to write breakpoints into
text pages. Text pages are not just write protected but they are also
copy-on-write. VM_PROT_OVERRIDE_WRITE overrides the write protection on the
text page and triggers the replication of the page so that the breakpoint
will be written to a private copy. However, here is where things become
confused. It is the debugger, not the process being debugged that requires
write access to the copied page. Nonetheless, the copied page is being
mapped into the process with write access enabled. In other words, once the
debugger sets a breakpoint within a text page, the program can write to its
private copy of that text page. Whereas prior to setting the breakpoint, a
SIGSEGV would have occurred upon a write access. VM_PROT_COPY addresses
this problem. The combination of VM_PROT_READ and VM_PROT_COPY forces the
replication of a copy-on-write page even though the access is only for read.
Moreover, the replicated page is only mapped into the process with read
access, and not write access.
Reviewed by: kib
MFC after: 4 weeks
pages.
(Note: Claims made in the comments about the handling of breakpoints in
wired pages have been false for roughly a decade. This and another bug
involving breakpoints will be fixed in coming changes.)
Reviewed by: kib
version of this file. When a process forks, any wired pages are immediately
copied because copy-on-write is not supported for wired pages. In other
words, the child process is given its own private copy of each wired page
from its parent's address space. Unfortunately, to date, these copied pages
have been mapped into the child's address space with the wrong permissions,
typically VM_PROT_ALL. This change corrects the permissions.
Reviewed by: kib
install new shadow object behind the map entry and copy the pages
from the underlying objects to it. This makes the mprotect(2) call to
actually perform the requested operation instead of silently do nothing
and return success, that causes SIGSEGV on later write access to the
mapping.
Reuse vm_fault_copy_entry() to do the copying, modifying it to behave
correctly when src_entry == dst_entry.
Reviewed by: alc
MFC after: 3 weeks
a device pager (OBJT_DEVICE) object in that it uses fictitious pages to
provide aliases to other memory addresses. The primary difference is that
it uses an sglist(9) to determine the physical addresses for a given offset
into the object instead of invoking the d_mmap() method in a device driver.
Reviewed by: alc
Approved by: re (kensmith)
MFC after: 2 weeks
charge the objects created by vm_fault_copy_entry. The object charge
was set, but reserve not incremented.
Reported by: Greg Rivers <gcr+freebsd-current tharned org>
Reviewed by: alc (previous version)
Approved by: re (kensmith)
rlimit RLIMIT_SWAP that limits the amount of swap that may be reserved
for the uid.
The accounting information (charge) is associated with either map entry,
or vm object backing the entry, assuming the object is the first one
in the shadow chain and entry does not require COW. Charge is moved
from entry to object on allocation of the object, e.g. during the mmap,
assuming the object is allocated, or on the first page fault on the
entry. It moves back to the entry on forks due to COW setup.
The per-entry granularity of accounting makes the charge process fair
for processes that change uid during lifetime, and decrements charge
for proper uid when region is unmapped.
The interface of vm_pager_allocate(9) is extended by adding struct ucred *,
that is used to charge appropriate uid when allocation if performed by
kernel, e.g. md(4).
Several syscalls, among them is fork(2), may now return ENOMEM when
global or per-uid limits are enforced.
In collaboration with: pho
Reviewed by: alc
Approved by: re (kensmith)
busy count. Only mappings that allow write access should be prevented by
a non-zero busy count.
(The prohibition on mapping pages for read access when they have a non-
zero busy count originated in revision 1.202 of i386/i386/pmap.c when
this code was a part of the pmap.)
Reviewed by: tegge
fault. In r188331 this update was relocated because of synchronization
changes to a place where it would occur on both hard and soft faults. This
change again restricts the update to hard faults.
acquire vnode lock for OBJT_VNODE object after map lock is dropped.
Because we have the busy page(s) in the object, sleeping there would
result in deadlock with vnode resize. Try to get lock without sleeping,
and, if the attempt failed, drop the state, lock the vnode, and restart
the fault handler from the start with already locked vnode.
Because the vnode_pager_lock() function is inlined in vm_fault(),
axe it.
Based on suggestion by: alc
Reviewed by: tegge, alc
Tested by: pho
Instead of checking each page for PG_UNMANAGED, perform a one-time
check whether the object is OBJT_PHYS. (PG_UNMANAGED pages only
belong to OBJT_PHYS objects.)
Specifically, since the delete-behind heuristic is never applied to a
device-backed object, there is no point in checking whether each of the
object's pages is fictitious. (Only device-backed objects have
fictitious pages.)
machine-independent support for superpages. (The earlier part was
the rewrite of the physical memory allocator.) The remainder of the
code required for superpages support is machine-dependent and will
be added to the various pmap implementations at a later date.
Initially, I am only supporting one large page size per architecture.
Moreover, I am only enabling the reservation system on amd64. (In
an emergency, it can be disabled by setting VM_NRESERVLEVELS to 0
in amd64/include/vmparam.h or your kernel configuration file.)
ways:
(1) Cached pages are no longer kept in the object's resident page
splay tree and memq. Instead, they are kept in a separate per-object
splay tree of cached pages. However, access to this new per-object
splay tree is synchronized by the _free_ page queues lock, not to be
confused with the heavily contended page queues lock. Consequently, a
cached page can be reclaimed by vm_page_alloc(9) without acquiring the
object's lock or the page queues lock.
This solves a problem independently reported by tegge@ and Isilon.
Specifically, they observed the page daemon consuming a great deal of
CPU time because of pages bouncing back and forth between the cache
queue (PQ_CACHE) and the inactive queue (PQ_INACTIVE). The source of
this problem turned out to be a deadlock avoidance strategy employed
when selecting a cached page to reclaim in vm_page_select_cache().
However, the root cause was really that reclaiming a cached page
required the acquisition of an object lock while the page queues lock
was already held. Thus, this change addresses the problem at its
root, by eliminating the need to acquire the object's lock.
Moreover, keeping cached pages in the object's primary splay tree and
memq was, in effect, optimizing for the uncommon case. Cached pages
are reclaimed far, far more often than they are reactivated. Instead,
this change makes reclamation cheaper, especially in terms of
synchronization overhead, and reactivation more expensive, because
reactivated pages will have to be reentered into the object's primary
splay tree and memq.
(2) Cached pages are now stored alongside free pages in the physical
memory allocator's buddy queues, increasing the likelihood that large
allocations of contiguous physical memory (i.e., superpages) will
succeed.
Finally, as a result of this change long-standing restrictions on when
and where a cached page can be reclaimed and returned by
vm_page_alloc(9) are eliminated. Specifically, calls to
vm_page_alloc(9) specifying VM_ALLOC_INTERRUPT can now reclaim and
return a formerly cached page. Consequently, a call to malloc(9)
specifying M_NOWAIT is less likely to fail.
Discussed with: many over the course of the summer, including jeff@,
Justin Husted @ Isilon, peter@, tegge@
Tested by: an earlier version by kris@
Approved by: re (kensmith)
1. Rewrite the backward scan. Specifically, reverse the order in which
pages are allocated so that upon failure it is never necessary to
free pages that were just allocated. Moreover, any allocated pages
can be put to use. This makes the backward scan behave just like the
forward scan.
2. Eliminate an explicit, unsynchronized check for low memory before
calling vm_page_alloc(). It serves no useful purpose. It is, in
effect, optimizing the uncommon case at the expense of the common
case.
Approved by: re (hrs)
MFC after: 3 weeks
vm_fault_additional_pages() that was introduced in revision 1.47. Then
as now, it is unnecessary because dev_pager_haspage() returns zero for
both the number of pages to read ahead and read behind, producing the
same exact behavior by vm_fault_additional_pages() as the special case
handling.
Approved by: re (rwatson)
tracks the total number of reactivated pages. (We have not been
counting reactivations by vm_fault() since revision 1.46.)
Correct a comment in vm_fault_additional_pages().
Approved by: re (kensmith)
MFC after: 1 week
