operate on one type of filesystem, mention this.
While here, capitalise the use of "UFS" in growfs.8 to match other uses of
the term in other man pages.
MFC after: 1 week
an attacker with root access to the jail can create a setuid binary for
their own use in the host environment (if they also have this access),
thus breaking root in the host.
This exploit is impossible if the jail's files are not world-readable.
Add instructions to the man page on how to create a jail with the
correct permissions set.
PR: docs/156853
Submitted by: Chris Rees (utisoft at gmail dot com)
Reviewed by: cperciva (security parts)
MFC after: 9 days
- instead of calling iwn_plcp_signal() for every frame, map the expected
value directly within wn->ridx
- concat plcp, rflags and xrflags, there is no clean byte boundary within
the flags, for example the antenna setting uses bit 6, 7 and 8
- there is still need for a custom rate to plcp mapping, as those expected
by the hardware are not conform to the std
?, [...] patterns match codepoints instead of bytes. They do not match
invalid sequences. [...] patterns must not contain invalid sequences
otherwise they will not match anything. This is so that ${var#?} removes the
first codepoint, not the first byte, without putting UTF-8 knowledge into
the ${var#pattern} code. However, * continues to match any string and an
invalid sequence matches an identical invalid sequence. (This differs from
fnmatch(3).)
On legacy channels every once in a while the firmware throws a SYSASSERT
on line 208. On HT channels though this does always happen and I'm not
aware of any workaround currently.
was not updated to pass CRD_F_KEY_EXPLICIT flag to opencrypto. This resulted in
always using first key.
We need to support providers created with this bug, so set special
G_ELI_FLAG_FIRST_KEY flag for GELI provider in integrity mode with version
smaller than 6 and pass the CRD_F_KEY_EXPLICIT flag to opencrypto only if
G_ELI_FLAG_FIRST_KEY doesn't exist.
Reported by: Anton Yuzhaninov <citrin@citrin.ru>
MFC after: 1 week
for the given channel is available.
It isn't used yet; ar5416GetWirelessModes() needs to be taught
about this rather than assuming HT20/HT40 is available.
This seems to make the AR9160 behave better during heavy scanning,
where before it'd hang and require a hard reset to recover.
Obtained From: Linux ath9k, Atheros
modifying AR_DIAG_SW.
There's a hardware workaround which sets disabling some errors
early at startup and clears said bits before the PCU begins
receiving - it does this to avoid RX descriptor status errors.
It's possible these bits aren't being completely properly twiddled
in all instances; but in particular if the diag_reg HAL variable
is set it won't be setting these bits correctly. I'll review this
at some point.
* Disable multicast search on mac address and key id - the driver
doesn't use it at the moment and thus adhoc may be broken for
merlin and later.
* Change this to be for Merlin 1.0 (which from what I understand
wasn't ever publicly released) to be more correct.
Apparently all three RX chains need to be enabled before initial calibration
is done, even if only two are configured.
Reorder the alt chain swap bit to match what the Atheros HAL is doing.
Obtained From: ath9k, Atheros
starting from base C types (int, long, etc).
That is also reflected when building atomic operations, as the
size-bounded types are built from the base C types.
However, powerpc does the inverse thing, leading to a serie of nasty
bugs.
Cleanup the atomic implementation by defining as base the base C type
version and depending on them, appropriately.
Tested by: jceel
