Brucify the Makefile.
Differentiate atime and mtime in fetch*Stat().
Fix a few pointer bugs.
Tweak some error messages.
Don't #include sys/param.h and stdio.h in fetch.h.
Document that sys/param.h and stdio.h must be #included before fetch.h.
on rshd and rlogind. However, note that:
1: rshd used to drop a connection with -a if the hostname != ip address.
This is unneeded, because iruserok() does it's own checking.
It was also wrong if .rhosts had an explicit IP address in it,
connections would be dropped from that host solely because the DNS was
mismatched even though it was explicitly intended to work by IP address.
2: rlogind and rshd check the hostname mappings by default now because that
is what goes into the utmp/wtmp and logs. If the hostname != ip address,
then it uses the IP address for logging/utmp/wtmp purposes. There isn't
much point logging ficticious hostnames.
3: rshd -a is now accepted (but ignored) for compatability. If you really
want to make life miserable for people with bad reverse DNS, use tcpd in
paranoid mode (which is questionable anyway, given DNS ttl tweaking).
as well as several functional additions.
(1) dot3 MIB support.
(2) if_media selection method support.
(3) bridge support.
(4) new boards support. Supported boards are as follows.
[PC/AT]
* Fujitsu FMV-180 series
* Allied-Telesis RE2000 series
* Allied-Telesyn AT1700 series
* Gateway Communications G/Ether series
* UB networks Access/PC ISA series
* TDK/LANX LAC-AX series
* ICL EtherTeam16i series
* RATOC REX-5586/5587
[PC-98]
* Allied-Telesis RE1000 series
* Allied-Telesis RE1000Plus/ME1500 series
* Contec C-NET(9N)E series
* Contec C-NET(98)P2 series
* UB networks Access/PC N98C+ series
* TDK/LANX LAC-98 series(not tested)
Submitted by: seki@sysrap.cs.fujitsu.co.jp (Masahiro Sekiguchi) and
chi@bd.mbn.or.jp (Chiharu Shibata)
in rev.1.30 (just before FreeBSD-1.1R) to almost match corresponding
breakage in FreeBSD-1.x's diskerr(). FreeBSD-2.x's diskerr() never
had the breakage.
in target mode, but we are not completing the command.
Use a template of allowed bus arbitration phases to selectively and
dynamically enable/disable initiator or target (re)selection.
Properly handle timeouts for target role transactions - just go to the
bus free state and report the error to the peripheral driver.
Checkpoint support for the XPT_ABORT_CCB function code. This currently
handles the accept tio and immediate notify ccb types, but does not
handle the continue target I/O or SCSI I/O ccb types. This is enough
to handle dynamic target enable/disable events.
Clean up the SCSI reset code so that we perform at most 1 SCSI bus
reset at initialization, the reset requested by the XPT layer.
level so they can be reclaimed before attempting to disable our lun.
Correctly free descriptors. Add periph locking and spl protection
around open and close.
