each of the existing kernel configs. This gives a place to put config
that applies to the entire arch.
Add the ARM_NEW_PMAP option to std.armv6. This is working well in early
testing and it's time for wide exposure, but it's still nice to be able
to fall back to the old implementation for testing when a problem comes
along. Eventually the option and the old implementation will go away.
The opportunity now exists to move a whole lot of boilerplate from all the
arm kernel config files into std.arm*, but that's a commit for another day.
into the kernel, which is used mostly on early development stages.
On RPI(2) the DTB is loaded and modified by firmware and then handed to
kernel via U-Boot and ubldr.
The RPI firmware adds (or modify) a few valuable data to the in memory
DTB, like:
- System memory;
- Ethernet MAC address;
- framebuffer settings;
- Board serial and revision;
- clock-frequency for most of devices.
handles versions 0.1 and 0.2 of the standard on 32-bit ARM.
With this driver we can shutdown in QEMU. Further work is needed to
turn secondary cores on on boot and to support later revisions of the
specification.
Submitted by: Robin Randhawa <Robin.Randhawa at ARM.com>
Sponsored by: The FreeBSD Foundation
the Raspberry Pi B we support most of the devices are already supported,
however the base address has changed.
A few items are not working, or missing. The main ones are:
* DMA doesn't work in the sdhci driver.
* Enabling vchiq halts the boot, may be interrupt related.
* There is no U-Boot port yet so the DTB is embedded in the kernel.
The last point will make it difficult to boot FreeBSD, however there is
support for the Raspberry Pi 2 in the U-Boot git repo. As I have not tested
this it is left as an open task to create a port to build.
X-MFC: When the above issues are fixed
Sponsored by: ABT Systems Ltd
These are left over from long ago when there was no way to load modules
on early armv6 platforms, and when there was a build problem with ahc
that has long since been fixed, and they just keep getting copy-pasted
into new configs.
driver on Rockchip boards. It currently supports PIO mode
and dma mode needs external dma controller to be used.
Submitted by: jmcneill
Approved by: stas (mentor)
To cut off the power we need to start the shutdown sequence by writing
the OFF bit on PMIC.
Once the PMIC is programmed the SoC needs to toggle the PMIC_PWR_ENABLE
pin when it is ready for the PMIC to cut off the power. This is done by
triggering the ALARM2 interrupt on SoC RTC.
The RTC driver only works in power management mode which means it won't
provide any kind of time keeping functionality. It only implements a way
to trigger the ALARM2 interrupt when requested.
Differential Revision: https://reviews.freebsd.org/D1489
Reviewed by: rpaulo
MFC after: 2 weeks
which means that the NFSCLIENT and NFSSERVER
kernel options will no longer work. This commit
only removes the kernel components. Removal of
unused code in the user utilities will be done
later. This commit does not include an addition
to UPDATING, but that will be committed in a
few minutes.
Discussed on: freebsd-fs
o Move similar block/networking methods to common file
o Follow r275640 and correct MMIO registers width
o Pass value to MMIO platform_note method.
Sponsored by: DARPA, AFRL
have chosen different (and more traditional) stateless/statuful
NAT64 as translation mechanism. Last non-trivial commits to both
faith(4) and faithd(8) happened more than 12 years ago, so I assume
it is time to drop RFC3142 in FreeBSD.
No objections from: net@
