is in accordance with the information provided at
ftp://ftp.cs.berkeley.edu/pub/4bsd/README.Impt.License.Change
Also add $FreeBSD$ to a few files to keep svn happy.
Discussed with: imp, rwatson
not very usefully, in all other displays). This was the original point
of the PR.
Move the load average up by 2 so that it starts in row 0 for all windows
(2 lines above it were wasted for all other windows except vmstat).
Move everything below it up by 2 or 3 (3 for icmp and icmp6 which had
an extra blank line due from not compensating for the foot-shooting in
note (3); only ip and ip6 compensated). Reduce the magic numbers related
to this.
Notes by the submitter:
%%%
1. All the subwin() calls are identical using #define MAINWIN_ROW 3
(systat.h).
2. The load average is at the top of the window.
3. Each display starts on the fourth line. I made changes to those
displays that shifted the start line (i.e., icmp). This entailed a
lot of changes within the comments at the top of those displays.
4. For ip6, I shifted the "Input next-header histogram" column down one
row to separate it from "IPv6 Output". I raised "bad scope packets"
and "address selection failed" up one row to stay with "IPv6 Input"
(valid?). They were down one row to probably line up at the bottom,
but I think they should stick with their fellow items in a column.
5. I condensed ifstat a bit. It had a lot of empty rows.
%%%
Submitted by: Se=E1n Farley <sean-freebsd at farley dot org>
PR: bin/81874
and compiler warnings.
The data for network statistics are still obtained via the kvm interface
if systat was started with the needed privileges, otherwise sysctls are
used. The reason for this is that with really many open sockets, the
sysctl method is probably slower, but it systat -netstat is probably not
really usable in either mode under these conditions.
Approved by: rwatson