Unfortunately there are two slight problems with that:
- Yacc and lex might generate code that generates warnings because of
this. Require yacc and lex to be rebuilt during bootstrap. I'm not
incrementing __FreeBSD_version here, because I assume someone else
will do this eventually.
- When running `make buildkernel', it uses share/mk from the source
treeo to build aicasm. Because aicasm also depends on lex, this would
break. Lower WARNS to 5 for now. We should just increment it to 6
again somewhere in the very far future.
aliases were added or deleted. The announced route entry for
an address alias is no longer empty because this empty route
entry was causing some route daemon to fail and exit abnormally.
MFC after: 5 days
same interface. The first address will install the prefix route into
the kernel routing table and that prefix will be marked as on-link.
Without RADIX_MPATH enabled, the other address aliases of the same
prefix will update the prefix reference count but no other routes
will be installed. Consequently the prefixes associated with these
addresses would not be marked as on-link. As such, incoming packets
destined to these address aliases will fail the ND6 on-link check
on input. This patch fixes the above problem by searching the kernel
routing table and try to find an on-link prefix on the given interface.
MFC after: 5 days
IFF_POINTOPOINT link types. The reason was due to the routing
entry returned from the kernel covering the remote end is of an
interface type that does not support ARP. This patch fixes this
problem by providing a hint to the kernel routing code, which
indicates the prefix route instead of the PPP host route should
be returned to the caller. Since a host route to the local end
point is also added into the routing table, and there could be
multiple such instantiations due to multiple PPP links can be
created with the same local end IP address, this patch also fixes
the loopback route installation failure problem observed prior to
this patch. The reference count of loopback route to local end would
be either incremented or decremented. The first instantiation would
create the entry and the last removal would delete the route entry.
MFC after: 5 days
stored in a BAR since the CIS BAR is mapped before the PCI bus driver
enumerates all the BARs. Without this change, the PCI bus driver would
attempt to initialize a BAR that was already allocated resulting in a panic.
handling for the PCIR_BIOS decoding enable bit from the cardbus driver.
The PCIR_BIOS BAR does include type bits like other BARs. Instead, it is
always a 32-bit non-prefetchable memory BAR where the low bit is used as a
flag to enable decoding.
Reviewed by: imp
active.
- Fix bus_generic_rl_(alloc|release)_resource() to not attempt to fetch a
resource list for grandchild devices, but just pass those requests up to
the parent directly. This worked by accident previously, but it is
better to not let bus drivers try to operate on devices they do not
manage.
o Optimize for memory mapped I/O by making all I/O port acceses function
calls and marking the test for the IA64_BUS_SPACE_IO tag with
__predict_false(). Implement the I/O port access functions in a new
file, called bus_machdep.c.
o Change the bus_space_handle_t for memory mapped I/O to the virtual
address rather than the physical address. This eliminates the PA->VA
translation for every I/O access. The handle for I/O port access is
still the port number.
o Move inb(), outb(), inw(), outw(), inl(), outl(), and their string
variants from cpufunc.h and define them in bus.h. On ia64 these are
not CPU functions at all. In bus.h they are merely aliases for the
new I/O port access functions defined in bus_machdep.h.
o Handle the ACPI resource bug in nexus_set_resource(). There we can
do it once so that we don't have to worry about it whenever we need
to write to an I/O port that is really a memory mapped address.
The upshot of this change is that the KBI is better defined and that I/O
port access always involves a function call, allowing us to change the
actual implementation without breaking the KBI. For memory mapped I/O the
virtual address is abstracted, so that we can change the VA->PA mapping
in the kernel without causing an KBI breakage. The exception at this time
is for bus_space_map() and bus_space_unmap().
MFC after: 1 week.
grant table API. Valid grant refs are in the range of positive 32bit
integers. ENOSPACE, being 29, is also a positive integer. Return
GNTTAB_LIST_END (-1) instead when gnttab_claim_grant_reference() fails.
This replaces d_mmap() with the d_mmap2() implementation and also
changes the type of offset to vm_ooffset_t.
Purge d_mmap2().
All driver modules will need to be rebuilt since D_VERSION is also
bumped.
Reviewed by: jhb@
MFC after: Not in this lifetime...
get required command protocol. But they have no idea about new commands,
such as DATA SET MANAGEMENT (TRIM). As soon as this info any way provided
by CAM, give controller specific instructions.
* new firmware
* untested support for 1000 and 6000 series
* bgscan support
* remove unnecessary RXON changes
* allow setting of country/regdomain by enforcing channel flags read
from the EEPROM
* suspend/resume fixes
* RF kill switch fixes
* LED adjustments
* several bus_dma*() related fixes
* addressed some LORs
* many other bug fixes
Submitted by: Bernhard Schmidt <bschmidt at techwires.net>
Obtained from: Brandon Gooch <jamesbrandongooch at gmail dot com> (LED
related changes), Benjamin Kaduk <kaduk at mit dot edu>
(LOR fixes), OpenBSD
renamed. Previously the vlan interfaces would lose their configuration as if
the parent interface had been physically removed. Now vlan interfaces ignore
rename events.
- Add a new ifnet flag (IFF_RENAMING) that is set while an ifnet is being
renamed. This flag can be checked in ifnet departure/arrival event
handlers to treat rename events differently.
- Change the ifnet departure event handler in the if_vlan(4) driver to
ignore departure events due to a trunk interface being renamed.
Reviewed by: brooks, rwatson
MFC after: 1 week
Fix some wrong usages.
Note: this does not affect generated binaries as this argument is not used.
PR: 137213
Submitted by: Eygene Ryabinkin (initial version)
MFC after: 1 month
making it possible for zpools created on OpenSolaris 2009.06 be used
on FreeBSD.
PR: kern/141800
Submitted by: mm
Reviewed by: pjd, trasz
Obtained from: OpenSolaris
MFC after: 2 weeks
- For SSDs use TRIM feature of DATA SET MANAGEMENT command, as defined by
ACS-2 specification working draft.
- For CompactFlash use CFA ERASE command, same as ad(4) does.
With this patch, `newfs -E /dev/ada1` was able to restore write speed of
my heavily weared OCZ Vertex SSD (firmware 1.4) up to the initial level
for the most part of it's capacity. Previous 1.3 firmware, even reportiong
TRIM capabilty bit set, was not working, reporting ABORT error for every
DSM command.
I have no idea whether it is normal, but for some reason it takes 200ms
to handle any TRIM command on this drive, that was making delete extremely
slow. But TRIM command is able to accept long list of LBAs and the length of
that list seems doesn't affect it's execution time. Implemented request
clusting algorithm allowed me to rise delete rate up to reasonable numbers,
when many parallel DELETE requests running.
blkif interface in Xen requires all I/O to be 512 byte aligned with each
segment bounded by a 4k page.
Note: This submission only documents the proper contraints for blkif I/O.
The alignment code in busdma does not yet handle alignment constraints
correctly in all cases.
the namecache records. The reclamation is not enabled by default because
for typical workload it would make namecache unusable, but large nested
directory tree easily puts any process that accesses filesystem into 1
second wait for vlru.
Reported by: yar (long time ago)
MFC after: 3 days
within ip_output, achieving (in random order of importance):
- a reduction of the number of 'r's in the source code;
- improved legibility;
- a reduction of 64 bytes in the .text
+ remove two unnecessary initializations in ip_output;
+ localize 'len';
+ introduce a temporary variable n to count the number of fragments,
the compiler seems unable to identify a common subexpression
(written 3 times, used twice);
+ document some assumptions on ip_len and ip_hl
r201011
- move most of ng_ipfw.h into ip_fw_private.h, as this code is
ipfw-specific. This removes a dependency on ng_ipfw.h from some files.
- move many equivalent definitions of direction (IN, OUT) for
reinjected packets into ip_fw_private.h
- document the structure of the packet tags used for dummynet
and netgraph;
r201049
- merge some common code to attach/detach hooks into
a single function.
r201055
- remove some duplicated code in ip_fw_pfil. The input
and output processing uses almost exactly the same code so
there is no need to use two separate hooks.
ip_fw_pfil.o goes from 2096 to 1382 bytes of .text
r201057 (see the svn log for full details)
- macros to make the conversion of ip_len and ip_off
between host and network format more explicit
r201113 (the remaining parts)
- readability fixes -- put braces around some large for() blocks,
localize variables so the compiler does not think they are uninitialized,
do not insist on precise allocation size if we have more than we need.
r201119
- when doing a lookup, keys must be in big endian format because
this is what the radix code expects (this fixes a bug in the
recently-introduced 'lookup' option)
No ABI changes in this commit.
MFC after: 1 week
the Sun Fire V215/V245 and Sun Ultra 25/45 machines. This driver also
already includes all the code to support the `Oberon' Uranus to PCIe
bridges found in the Fujitsu-Siemens based Mx000 machines but due to
lack of access to such a system for testing, probing of these bridges
is currently disabled.
Unfortunately, the event queue mechanism of these bridges for MSIs/
MSI-Xs matches our current MD and MI interrupt frameworks like square
pegs fit into round holes so for now we are generous and use one event
queue per MSI, which limits us to 35 MSIs/MSI-Xs per Host-PCIe-bridge
(we use one event queue for the PCIe error messages). This seems
tolerable as long as most devices just use one MSI/MSI-X anyway.
Adding knowledge about MSIs/MSI-Xs to the MD interrupt code should
allow us to decouple the 1:1 mapping at the cost of no longer being
able to bind MSIs/MSI-Xs to specific CPUs as we currently have no
reliable way to quiesce a device during the transition of its MSIs/
MSI-Xs to another event queue. This would still require the problem
of interrupt storms generated by devices which have no one-shot
behavior or can't/don't mask interrupts while the filter/handler is
executed (like the older PCIe NICs supported by bge(4)) to be solved
though.
Committed from: 26C3
or we create loops.
The divert cookie (that can be set from userland too)
contains the matching rule nr, so we must start from nr+1.
Reported by: Joe Marcus Clarke
