To avoid have warning for services that are using oomprotect, oomprotect
will only be applied on services that won't run inside jails.
Reported by: allanjude
MFC after: 2 weeks.
Always define boot.netif.server in kenv in pxeboot
Add "boot.tftproot.server" to kenv when pxeboot uses tftpfs
Change the code order when setting env for TFTP or NFS to be the same as
common/dev_net.c
Reported by: tsoome
pages, specificially, dirty pages that have passed once through the inactive
queue. A new, dedicated thread is responsible for both deciding when to
launder pages and actually laundering them. The new policy uses the
relative sizes of the inactive and laundry queues to determine whether to
launder pages at a given point in time. In general, this leads to more
intelligent swapping behavior, since the laundry thread will avoid pageouts
when the marginal benefit of doing so is low. Previously, without a
dedicated queue for dirty pages, the page daemon didn't have the information
to determine whether pageout provides any benefit to the system. Thus, the
previous policy often resulted in small but steadily increasing amounts of
swap usage when the system is under memory pressure, even when the inactive
queue consisted mostly of clean pages. This change addresses that issue,
and also paves the way for some future virtual memory system improvements by
removing the last source of object-cached clean pages, i.e., PG_CACHE pages.
The new laundry thread sleeps while waiting for a request from the page
daemon thread(s). A request is raised by setting the variable
vm_laundry_request and waking the laundry thread. We request launderings
for two reasons: to try and balance the inactive and laundry queue sizes
("background laundering"), and to quickly make up for a shortage of free
pages and clean inactive pages ("shortfall laundering"). When background
laundering is requested, the laundry thread computes the number of page
daemon wakeups that have taken place since the last laundering. If this
number is large enough relative to the ratio of the laundry and (global)
inactive queue sizes, we will launder vm_background_launder_target pages at
vm_background_launder_rate KB/s. Otherwise, the laundry thread goes back
to sleep without doing any work. When scanning the laundry queue during
background laundering, reactivated pages are counted towards the laundry
thread's target.
In contrast, shortfall laundering is requested when an inactive queue scan
fails to meet its target. In this case, the laundry thread attempts to
launder enough pages to meet v_free_target within 0.5s, which is the
inactive queue scan period.
A laundry request can be latched while another is currently being
serviced. In particular, a shortfall request will immediately preempt a
background laundering.
This change also redefines the meaning of vm_cnt.v_reactivated and removes
the functions vm_page_cache() and vm_page_try_to_cache(). The new meaning
of vm_cnt.v_reactivated now better reflects its name. It represents the
number of inactive or laundry pages that are returned to the active queue
on account of a reference.
In collaboration with: markj
Reviewed by: kib
Tested by: pho
Sponsored by: Dell EMC Isilon
Differential Revision: https://reviews.freebsd.org/D8302
Some tools spawn c++filt and pass it a single line at a time for
demangling. This is akin to r276689 for addr2line.
Sponsored by: The FreeBSD Foundation
print. Also add a new flag -s that add blocks size to statistics.
PR: 198347, 212726
Submitted by: Ben RUBSON <ben.rubson@gmail.com>
Tested by: pi
MFC After: 2 weeks.
When symbol versioning was added to rtld, the boolean 'in_plt' argument
to find_symdef() was converted to a bitmask of flags. The first flag
added was 'SYMLOOK_IN_PLT' which replaced the 'in_plt' bool. This
happened to still work by accident as SYMLOOK_IN_PLT had the value of 1
which is the same as 'true', so there should be no functional change.
Tested on: amd64
Reviewed by: kan
MFC after: 2 weeks
Sponsored by: DARPA / AFRL
The BUF_TRACKING bio pointer only makes sense for kernel consumers of
CCBs.
PR: 214250
Reported by: trasz@
Reviewed by: imp@, markj@
Sponsored by: Dell EMC Isilon
Differential Revision: https://reviews.freebsd.org/D8477
Pass current thread credentials instead of NOCRED.
Only allow unmapped buffers for filesystem which proclaimed the support.
For all filesystems which currently use buffer pager (UFS, msdosfs and
cd9660), the changes are effectively nop.
Tested by: pho
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
The expected deviation should not be more than 1Hz per second. The USB
v2.0 specification also mandates this requirement. Refer to chapter
5.12.4.2 about feedback.
PR: 208791
MFC after: 3 days
This change does modify devsw dv_print() to return the int value,
enabling walkers to interrupt the walk on non zero value from dv_print().
This will allow the pager_print actually to stop displaying data on
user input, and additionally pager is used in various *dev_print callbacks,
where it was missing.
For test, lsdev [-v] command should display data by screenfuls and should
stop when the key 'q' is pressed on pager prompt.
Reviewed by: allanjude
Approved by: allanjude (mentor)
Differential Revision: https://reviews.freebsd.org/D5461
Trivially capsicumize some simple programs that just interact with
stdio. This list of programs uses 'pledge("stdio")' in OpenBSD.
No objection from: allanjude, emaste, oshogbo
Sponsored by: Dell EMC Isilon
Differential Revision: https://reviews.freebsd.org/D8307
address, but the associated PF is giving the VF an all zeros MAC address
when one is not administratively assigned. The driver should check for
this case and generate a random address, similar to how the linux igbvf
driver does.
Submitted by: skoumjian@juniper.net (Scott Koumjian)
MFH: 2 weeks
Differential Revision: https://reviews.freebsd.org/D8399
- Split driver in two parts: FDT and non-FDT
- Instead of reattach gpioled nodes to GPIO bus use
gpio_pin_get_by_ofw_idx and add ofwbus and simplebus as parrent buses
Reviewed by: loos
Differential Revision: https://reviews.freebsd.org/D8233
It was added in SES-3 spec, and its support required to properly link
the Additional Element Status page data to the original elements.
MFC after: 2 weeks
Sponsored by: iXsystems, Inc.
- Move all VCHI activity to worker thread: channel methods are called with
non-sleepable lock held and VCHI uses sleepable lock.
- In worker thread use sx(9) lock instead of mutex(9) for the same reason.
PR: 213801, 205979
The firmware/hardware does not generate additional completion
events unless we post new buffers. Use a timer to try to post
more buffers in case we are temporarily out of mbufs. Else
the receive schedule completely stops.
Sponsored by: Mellanox Technologies
MFC after: 1 week
machine/armreg.h requires access to the __ARM_ARCH macro, which is not
always properly defined (especially by gcc 4.2.1). We should include
sys/cdefs.h in order to get the definitions in machine/acle-compat.h,
which would properly define the __ARM_ARCH macro in these cases.
So, in cases where machine/armreg.h is included without _SYS_CDEFS_H_
being defined - generate an #error.
Reviewed by: andrew
Sponsored by: Smartcom - Bulgaria AD
Differential Revision: https://reviews.freebsd.org/D8460
vp->v_mount->mnt_vnodecovered unlocked. This allowed unmount to race.
Lock vnode after we noticed the VV_ROOT flag. See comments for
explanation why unlocked check for the flag is considered safe.
Reported and tested by: avg
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
Only include sys/boot.h if LINUX_BOOT_ABI is defined in
sys/arm/arm/machdep.c
Not doing this prevents kernels that do not define LINUX_BOOT_ABI from
being build with gcc (at least 4.2.1).
Reviewed by: mmel
Sponsored by: Smartcom - Bulgaria AD
Differential Revision: https://reviews.freebsd.org/D8459
