The name trunk is misused as the networking term trunk means carrying multiple
VLANs over a single connection. The IEEE standard for link aggregation (802.3
section 3) does not talk about 'trunk' at all while it is used throughout IEEE
802.1Q in describing vlans.
The lagg(4) driver provides link aggregation, failover and fault tolerance.
Discussed on: current@
tolerance. This driver allows aggregation of multiple network interfaces as
one virtual interface using a number of different protocols/algorithms.
failover - Sends traffic through the secondary port if the master becomes
inactive.
fec - Supports Cisco Fast EtherChannel.
lacp - Supports the IEEE 802.3ad Link Aggregation Control Protocol
(LACP) and the Marker Protocol.
loadbalance - Static loadbalancing using an outgoing hash.
roundrobin - Distributes outgoing traffic using a round-robin scheduler
through all active ports.
This code was obtained from OpenBSD and this also includes 802.3ad LACP support
from agr(4) in NetBSD.
hardware drivers. Unlike pseudo-device drivers, which just attach
to the cloning framework and wait for "ifconfig create", h/w drivers
create interfaces for installed cards as soon as loaded. The issue
of devd(8) involuntarily reloading modules should be dealt with in a
different way.
new interface. In other cases loading the module is unwanted and
can lead to ill side effects. One such effect found is as follows:
"kldunload if_foo" tells the module to kill all its interfaces,
which results in messages sent to devd; the module unloads. Then
devd starts processing the messages, which ends up in a etc script
running ifconfig fooX, which reloads the module.
'-alias', and that 'add' and 'delete are in fact synonyms for these
in the ifconfig(8) grammar.
Use network prefixes explicitly specified in IETF RFCs for
documentation purposes. (bz)
PR: 102701
MFC after: 1 day
See also: RFC 3330, RFC 3849
Submitted by: bz
one. This is based on NetBSD but unlike NetBSD this implementation prints
the instance number for all media instances and doesn't skip it for the
first one as I don't see a reason to suppress it except for the vague
reason to preserve the output for single-instance configurations.
- Fix some whitespace nits.
o add hack/nonstandard channel mapping for public safety band channels to
mirror kernel (temporary until we have proper 802.11 state)
o change ieee80211_mhz2ieee to take channel flags (unused right now)
While here do some minor fixups like using IEEE80211_IS_CHAN_ANYG.
- use flags rather than sperate ioctls for edge, p2p
- implement p2p and autop2p flags
- define large pathcost constant as ULL
- show bridgeid and rootid in ifconfig
Obtained from: Reyk Floeter <reyk@openbsd.org>
address learned by the bridge is made permanent, the address will not age out
and most importantly will not migrate to another interface.
This can be used to stop mac address poisoning or clients roaming in much the
same way as static entries without the hassle of preloading the table.
RSTP provides faster spanning tree convergence, the protocol will exchange
information with neighboring switches to quickly transition to forwarding
without creating loops. The code will default to RSTP mode but will downgrade
any port connected to a legacy STP network so is fully backward compatible.
Reviewed by: syrinx
Tested by: syrinx
'ifconfig em0 tso' and 'ifconfig em0 -tso'. TSO for IPv4 and IPv6 is always
enabled or disabled together. The driver may enable only one if it doesn't
support both.
Document 'tso' and '-tso' in the ifconfig(8) man pages.
Sponsored by: TCP/IP Optimization Fundraise 2005
mechanism
o change vlan cloning to use callback and pass all vlan parameters
on create using the new SIOCREATE2 ioctl
o update vlan set logic to match existing practice
order to - for example - apply firewall rules to a whole group of
interfaces. This is required for importing pf from OpenBSD 3.9
Obtained from: OpenBSD (with changes)
Discussed on: -net (back in April)
