so that fsck does not complain with `SUMMARY BLK COUNT(S) WRONG IN
SUPERBLK' the first time it is run on a new filesystem.
Reported by: Poul-Henning Kamp <phk@freebsd.org>
Sponsored by: DARPA & NAI Labs.
that the kernel will refuse to mount. Specifically it now enforces
the MAXBSIZE blocksize limit. This update also fixes a problem where
newfs could segment fault if the selected fragment size was too large.
PR: bin/30959
Submitted by: Ceri Davies <setantae@submonkey.net>
Sponsored by: DARPA & NAI Labs.
the old 8-bit fs_old_flags to the new location the first time that the
filesystem is mounted by a new kernel. One of the unused flags in
fs_old_flags is used to indicate that the flags have been moved.
Leave the fs_old_flags word intact so that it will work properly if
used on an old kernel.
Change the fs_sblockloc superblock location field to be in units
of bytes instead of in units of filesystem fragments. The old units
did not work properly when the fragment size exceeeded the superblock
size (8192). Update old fs_sblockloc values at the same time that
the flags are moved.
Suggested by: BOUWSMA Barry <freebsd-misuser@netscum.dyndns.dk>
Sponsored by: DARPA & NAI Labs.
filesystem expands the inode to 256 bytes to make space for 64-bit
block pointers. It also adds a file-creation time field, an ability
to use jumbo blocks per inode to allow extent like pointer density,
and space for extended attributes (up to twice the filesystem block
size worth of attributes, e.g., on a 16K filesystem, there is space
for 32K of attributes). UFS2 fully supports and runs existing UFS1
filesystems. New filesystems built using newfs can be built in either
UFS1 or UFS2 format using the -O option. In this commit UFS1 is
the default format, so if you want to build UFS2 format filesystems,
you must specify -O 2. This default will be changed to UFS2 when
UFS2 proves itself to be stable. In this commit the boot code for
reading UFS2 filesystems is not compiled (see /sys/boot/common/ufsread.c)
as there is insufficient space in the boot block. Once the size of the
boot block is increased, this code can be defined.
Things to note: the definition of SBSIZE has changed to SBLOCKSIZE.
The header file <ufs/ufs/dinode.h> must be included before
<ufs/ffs/fs.h> so as to get the definitions of ufs2_daddr_t and
ufs_lbn_t.
Still TODO:
Verify that the first level bootstraps work for all the architectures.
Convert the utility ffsinfo to understand UFS2 and test growfs.
Add support for the extended attribute storage. Update soft updates
to ensure integrity of extended attribute storage. Switch the
current extended attribute interfaces to use the extended attribute
storage. Add the extent like functionality (framework is there,
but is currently never used).
Sponsored by: DARPA & NAI Labs.
Reviewed by: Poul-Henning Kamp <phk@freebsd.org>
Use only one filedescriptor. Open in R/O or R/W based in the '-N' option.
Make the filedescriptor a global variable instead of passing it around
as semi-global variable(s).
Remove the undocumented ability to specify type without '-T' option.
Replace fatal() with straight err(3)/errx(3). Save calls to strerror()
where applicable. Loose the progname variable.
Get the sense of the cpgflag test correct so we only issue warnings if
people specify cpg and can't get that. It can be argued that this
should be an error.
Remove the check to see if the disk is mounted: Open for writing
would fail if it were mounted.
Attempt to get the sectorsize and mediasize with the generic disk
ioctls, fall back to disklabel and /etc/disktab as we can.
Notice that on-disk labels still take precedence over /etc/disktab,
this is probably wrong, but not as wrong as the entire concept of
/etc/disktab is.
Sponsored by: DARPA & NAI Labs.
particular as there may not be one. Remove #if 0'ed code which might
mislead people to think otherwise.
unifdef -ULOSTDIR, fsck can make lost+found on the fly.
Sponsored by: DARPA & NAI Labs
diskdrives do neither need nor want:
-O create a 4.3BSD format filesystem
-d rotational delay between contiguous blocks
-k sector 0 skew, per track
-l hardware sector interleave
-n number of distinguished rotational positions
-p spare sectors per track
-r revolutions/minute
-t tracks/cylinder
-x spare sectors per cylinder
No change in the produced filesystem image unless one or more of
these options were used.
Approved by: mckusick
Add a couple of simple regression tests accessible with "make test", they
depend on the md(4) driver.
FYI I have also tried running the test against a week old newfs and it
passed.
anyone needs a newfs without it. Remove the #ifdef's from around
the code and the -DFSIRAND from the Makefile. Also remove redundant
declarations of random() and srandomdev().
Old code obfuscates long (but single-line) messages by printing them in
pieces using %s. Rev.1.41 obfuscated some new long messages using ISO
string concatenation. This commit only fixes the new obfuscations.
16384/2048.
Following recent discussions on the -arch mailing list, involving dillon
and mckusick, this change parallels the one made over a decade ago when
the default was bumped up from 4096/512.
This should provide significant performance improvements for most
folks, less significant performance losses for a few folks and
wasted space lost to large fragments for many folks.
For discussion, please see the following thread in the -arch archive:
Subject: Using a larger block size on large filesystems
The discussion ceases to be relevant when the issue of partitioning
schemes is raised.
were only of benefit to large filesystems, which recent research
suggests is not the case, and which the original author of the text
no longer endorses.
size ratio other than 8:1. Currently, we only recommend an 8:1
ratio, because the impact of others ratios has not been adequately
investigated.
Also, do not recommend the use of the -c option in the example, since
newfs now automatically calculates the best cyl:cylgrp ratio.
This change was discussed with the author of rev 1.29.
