only doing so if loader.rc does not exist. This fixes the problem where
installworld doesn't update /boot/loader.4th, resulting in device.hints not
being loaded after updating past the config(8) changes, which resulted in
mcclock0 not being probed, and a nice kernel panic during boot.
are working. Add a small blurb about XE_DEBUG as it might be useful
to some people troubelshooting problems in the future.
Submitted by: "Kevin Oberman" <oberman@es.net>
hose are 16 PCI instances apart. This allows us to recognize secondary
PCI busses (at least to a first level) until the pci infrastructure is
fixed.
Turn on support for secondary cycles, too. Redo debug printouts.
Instead, for now (until we get a pci infrastructure cleanup),
assign the PCI bus number to be mcpcia bus instance << 4. This
is to allow secondary bridges some room to be recongnized on
4100 systems.
Currently, many drivers support more than one bus of ISA, EISA, MCA,
PCI.
Before this commit, we had, for example, some SCSI devices listed more
than once, iirc, some up to three times (ISA/EISA, MCA, PCI).
Since now the "device" line is common for all of them and they only
differ for the hints stuff, I did the following:
First, list Busses: (E)ISA, MCA, PCI and explain, that only ISA
needs the hints stuff.
Move NIC/SCSI stuff, which were the only split sections, behind these
stuff. Describe all drivers only one time and list all supported
chips.
List all device (+ hints for ISA, if possible).
I've also added few additional supported chips to some drivers, xl for
example and some SCSI drivers.
Also, softupdates is no longer disabled by default, so the comment should
not say, it's not enabled by default due to license issues.
Approved by: asmodai
To come: include PAO devices (imp volunteered for help)
netgraph. Eventually we may need to have a separate hook for packets
that already have a source AMC address but for now just drop it in.
Should fix PPPoE.
controller chip. This chip is currently being used on the NetGear
FA312-TX adapter, which I guess is a replacement for the FA310-TX
(PNIC-based).
I added support for this chip by modifying the sis driver since
the SiS 900 and the NS DP83815 have almost the same programming
interface (the RX filter programming and PHY access methods are
different, but the general configuration, DMA scheme and register
layout are identical).
I would have had this done a lot sooner, but getting the damn MAC
address out of the EEPROM proved to be more complicated than expected.
