are nevers used for PCI interrupts, but can cause false matches since
they are fully programmable.
2.) Skip the mapping registers for slot a2 and a3 on "psycho" bridges,
since they are not present there. Again, this could cause false matches,
which would result in the interrupt being delivered at most once.
Submitted by: jake (2)
Approved by: re
this is now done on all machines except for some known problematic ones.
Add an additional guard to make sure that the interrupt numbers are
in the correct range before swizzling. This should catch any remaining
models for which the swizzle is inappropriate.
Correct the swizzle calculation to account for the fact that the parent
interrupt numbers to be swizzled are 1-based.
Approved by: re
1. At least some Netra t1 models have PCI buses with no associated
interrupt map, but obviously expect the PCI swizzle to be done with
the interrupt number from the higher level as intpin. In this case,
the mapping also needs to continue at parent bus nodes.
To handle that, add a quirk table based on the "name" property of
the root node to avoid breaking other boxen. This property is now
retrieved and printed at boot.
2. On SPARCengine Ultra AX machines, interrupt numbers are not mapped
at all, and full interrupt numbers (not just INOs) are given in
the interrupt properties. This is more or less cosmetical; the
PCI interrupt numbers would be wrong, but the psycho resource
allocation method would pass the right numbers on anyway.
Tested by: mux (1), Maxim Mazurok <maxim@km.ua> (2)
recognized compat properties. This should make the psycho driver attach
properly on SPARCengine Ultra AX machines.
Switch to a table-driven logic to recognize the ID's, since their number
is now large enough to justify this.
These changes are analogous to those made in NetBSD r.1.35, but
implemented a bit differently.
of them, and couple them by always performing all operations on all
present IOMMUs. This is required because with the current API there
is no way to determine on which bus a busdma operation is performed.
While being there, clean up the iommu code a bit.
This should be a step in the direction of allow some of larger machines
to work; tests have shown that there still seem to be problems left.
code. Both tasks are not always performed completely by the firmware.
The former is required to get some e450 models to boot; the latter fixes
the repeated fifo underruns with hme(4)s and gem(4)s observed on some
machines (and probably performance problems with other peripherals as
well).
- change the IOMMU support code so that it supports overcommittting the
available DVMA memory, while still allocating as lazily as possible.
This is achieved by limiting the preallocation, and deferring the
allocation to map load time when it fails. In the latter case, the
DVMA memory reserved for unloaded maps can be stolen to free up enough
memory for loading a map.
- allow NULL settings in the method tables, and search the parent tags
until an appropriate implementation is found. This allows to remove some
kluges in the old implementation.
the bus-dependent code and to be able to support more systems. The core
of the new code is mostly obtained from NetBSD.
Kluge the interrupt routing methods of the psycho and apb drivers so
that an intline of 0 can be handled for now; real routing is still not
possible (all intline registers are preinitialized instead); this will
require a sparc64-specific adaption of the driver for generic PCI-PCI
bridges with a custom routing method to work right.
struct ofw_nexus_reg. Implement UPA device memory management in the
nexus driver.
Adapt the psycho driver to these changes, and do some minor cleanup work
while being there.
