in every sense.
General
-------
- Multichannel safe, endian safe, format safe
* Large part of critical pcm filters such as vchan.c, feeder_rate.c,
feeder_volume.c, feeder_fmt.c and feeder.c has been rewritten so that
using them does not cause the pcm data to be converted to 16bit little
endian.
* Macrosses for accessing pcm data safely are defined within sound.h in
the form of PCM_READ_* / PCM_WRITE_*
* Currently, most of them are probably limited for mono/stereo handling,
but the future addition of true multichannel will be much easier.
- Low latency operation
* Well, this require lot more works to do not just within sound driver,
but we're heading towards right direction. Buffer/block sizing within
channel.c is rewritten to calculate precise allocation for various
combination of sample/data/rate size. As a result, applying correct
SNDCTL_DSP_POLICY value will achive expected latency behaviour simmilar
to what commercial 4front driver do.
* Signal handling fix. ctrl+c of "cat /dev/zero > /dev/dsp" does not
result long delay.
* Eliminate sound truncation if the sound data is too small.
DIY:
1) Download / extract
http://people.freebsd.org/~ariff/lowlatency/shortfiles.tar.gz
2) Do a comparison between "cat state*.au > /dev/dsp" and
"for x in state*.au ; do cat $x > /dev/dsp ; done"
- there should be no "perceivable" differences.
Double close for PR kern/31445.
CAVEAT: Low latency come with (unbearable) price especially for poorly
written applications. Applications that trying to act smarter
by requesting (wrong) blocksize/blockcount will suffer the most.
Fixup samples/patches can be found at:
http://people.freebsd.org/~ariff/ports/
- Switch minimum/maximum sampling rate limit to "1" and "2016000" (48k * 42)
due to closer compatibility with 4front driver.
Discussed with: marcus@ (long time ago?)
- All driver specific sysctls in the form of "hw.snd.pcm%d.*" have been
moved to their own dev sysctl nodes, notably:
hw.snd.pcm%d.vchans -> dev.pcm.%d.vchans
Bump __FreeBSD_version.
Driver specific
---------------
- Ditto for sysctls.
- snd_atiixp, snd_es137x, snd_via8233, snd_hda
* Numerous cleanups and fixes.
* _EXPERIMENTAL_ polling mode support using simple callout_* mechanisme.
This was intended for pure debugging and latency measurement, but proven
good enough in few unexpected and rare cases (such as problematic shared
IRQ with GIANT devices - USB). Polling can be enabled/disabled through
dev.pcm.0.polling. Disabled by default.
- snd_ich
* Fix possible overflow during speed calibration. Delay final
initialization (pcm_setstatus) after calibration finished.
PR: kern/100169
Tested by: Kevin Overman <oberman@es.net>
* Inverted EAPD for few Nec VersaPro.
PR: kern/104715
Submitted by: KAWATA Masahiko <kawata@mta.biglobe.ne.jp>
Thanks to various people, notably Joel Dahl, Yuriy Tsibizov, Kevin Oberman,
those at #freebsd-azalia @ freenode and others for testing.
Joel Dahl will do the manpage update.
wait (time waited to acquire) and hold times for *all* kernel locks. If
the architecture has a system synchronized TSC, the profiling code will
use that - thereby minimizing profiling overhead. Large chunks of profiling
code have been moved out of line, the overhead measured on the T1 for when
it is compiled in but not enabled is < 1%.
Approved by: scottl (standing in for mentor rwatson)
Reviewed by: des and jhb
except sun4v.
This change makes the transition from a default to an option more
transparent and is an attempt to head off all the compliants that are
likely from people who don't read UPDATING, based on experience with
the io/mem change.
Submitted by: scottl@
OpenBSD. This driver seems to give a small performance increase, and
should lead to better maintainability in the future.
The nForce Ethernet-specific hack in sys/i386/xbox/xbox.c is still
required, judging from dev/nfe/if_nfe.c. The condition it hacks will
almost certainly only occur on XBOX-es anyway, so it is best left there.
Approved by: imp (mentor)
Add note about the '_dhcp' user.
While one is expected to run mergemaster -p before installworld, make
a note of the points where this will actively fail due to the addition of
users/groups.
enabled by default in NETSMB and smbfs.ko.
With the most of modern SMB providers requiring encryption by
default, there is little sense left in keeping the crypto part
of NETSMB optional at the build time.
This will also return smbfs.ko to its former properties users
are rather accustomed to.
Discussed with: freebsd-stable, re (scottl)
Not objected by: bp, tjr (silence)
MFC after: 5 days
into a separate module. Accordingly, convert the option into a device
named similarly.
Note for MFC: Perhaps the option should stay in RELENG_6 for POLA reasons.
Suggested by: scottl
Reviewed by: cokane
MFC after: 5 days
replacement and has additional features which make it superior.
Discussed on: -arch
Reviewed by: thompsa
X-MFC-after: never (RELENG_6 as transition period)
- removes obsolete files/dirs or libraries.
- works in interactive (default) and batch mode
- respects DISTDIR
- documented in UPDATING and build(7)
The head of the file ObsoleteFiles.inc contains instructions how to add
obsolete files/dirs/libs to the list. Obviously one should add obsolete
files to this list, when he removes a file/dir/lib from the basesystem.
Additionally add check-old target:
- allows re@ to check if a file on the obsolete list resurfaces
Design goals:
- allows full control by the user (default interactive mode)
- possibility of scripted removal of obsolete files (batch mode)
- opt-in removal of files (explicit list of files)
- seperate removal of libs (2 delete targets)
Important design decissions:
- structured list of files to remove instead of a plain text file:
* allows to remove additional files if a NO_foo knob is specified
without the need to change the targets (no NO_foo knob is respected
yet)
- not using mtree like NetBSD does:
* mtree doesn't has an interactive mode
Discussed on: arch (long ago), current (this year)
Additional input from: re (hrs)
Approved by: mentor (joerg)
