preference to LIBFICL{,32}. LIBFICL{,32} are now always defined, but
LDR_INTERP{,32} is defined empty when building w/o forth (aka the
simple interpreter) and defined to LIBFICL{,32} when we are building
forth.
loader scripts. However, that path won't be taken after all it
seems. Remove this code before it decays into uselessness. Also remove
build dependencies on forth no longer needed.
MK_CTF, MK_SSP, MK_PROFILE, NO_PIC, and INTERNALLIB are always the
same, so set them in defs.mk. MAN= is common, so set it here too.
This removes a lot of boring repetition from the Makefiles that added
almost no value.
This should have been done as part of r327350, but due to lack of foresight
it came later. In the different places we apply overlays, we duplicate the
bits that check for fdt_overlays in the environment and supplement that with
any other places we need to check for overlays to load. These "other places"
will be loader specific and are not candidates for consolidation.
Provide an fdt_load_dtb_overlays to capture the common logic, allow passing
in an additional list of overlays to be loaded. This additional list of
overlays is used in practice for ubldr to pull in any fdt_overlays passed to
it from U-Boot environment, but it can be used for any other source of
overlays.
These additional overlays supplement loader.conf(5) fdt_overlays, rather
than replace, so that we're not restricted to specifying overlays in only
one place. This is a change from previous behavior where loader.conf(5)
supplied fdt_overlays would cause us to ignore U-Boot environment, and this
seems nonsensical- user should have sufficient control over both of these
aspects, or lack of control for good reasons.
A knob could be considered in the future to ignore U-Boot supplied overlays,
but the supplemental treatment seems like a good start.
Reviewed by: imp (earlier version), gonzo (earlier version)
Differential Revision: https://reviews.freebsd.org/D13993
These were found during bring-up on a new arm64 platform and in an
amd64 VM.
Submitted by: Arshan Khanifar <arshankhanifar_gmail.com>
Reviewed by: imp
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D14036
When building loader bits, lld fails with the following error:
"ld: error: section: .dynamic is not contiguous with other relro sections"
on both ubldr and EFI loader.
Move .dynamic up to make ld.lld happy, adjust .got as necessary for ubldr.
Tested on: OrangePi One (ld.lld, ubldr)
Tested on: Banana Pi-M3 (ld.lld, ubldr)
Tested on: qemu-armv7 (ld.lld, EFI)
Tested on: qemu-armv7 (ld.bfd, EFI)
Tested on: Raspberry Pi 2 (ld.bfd, ubldr) [manu]
Tested on: Banana Pi-M2 (ld.bfd, ubldr) [manu]
Reviewed by: andrew, emaste, imp
Differential Revision: https://reviews.freebsd.org/D13942
is NULL. That's more correct and doesn't depend on the error behavior
of utf8_to_ucs2. In practice, we'll never see this though since we
pass utf8_to_ucs2 a well formed string.
Sponsored by: Netflix
Differential Revision: https://reviews.freebsd.org/D13918
and utf8_to_ucs2, be sure to NULL out the return pointer too, rather
than return a pointer to free memory.
Sponsored by: Netflix
Differential Revision: https://reviews.freebsd.org/D13917
utf8_to_ucs2 in boot1.efi. We need to initialise the ucs2 output string
so it will allocate space, and use the return value to determine if the
call was successful.
Reviewed by: imp
Sponsored by: DARPA, AFRL
Differential Revision: https://reviews.freebsd.org/D13915
Use simple "foo" rather than "${.CURDIR}/foo" to include Makefile.fat
since the former works when including this Makefile from else
where. Also, use full path from ${BOOTSRC} to the FAT templates for
similar reasons. It doesn't change anything in base FreeBSD, but
allows us to have a custom boot1.efi more easily (though that will be
short-lived for us, it may also be helpful for others).
Sponsored by: Netflix
Overlays were previously not applied when U-Boot provides FDT or EFI
provides FDT, only when we load FDT from /boot/dtb given name from U-Boot.
Make all three paths lead to loading fdt_overlays and applying them, so that
fdt_overlays can be expected to Just Work.
Reviewed by: gonzo, imp, manu
Differential Revision: https://reviews.freebsd.org/D13664
This patch allows to scan all display modes in boot1 as loader does.
Before system tried to select optimal display mode by sequential scan of
modes and if error then stop scanning. This way is not good, because
if mode N is not present, mode N+1 may exist.
In loader we use conout->Mode->MaxMode to identify maximum number of modes.
This commit is to use same way in boot1 as in loader.
Reported by: Andrey Pustovetov <andrey.pustovetov@gmail.com>
Reviewed by: tsoome
Differential Revision: https://reviews.freebsd.org/D13541
removing this argument, and expanding when rc is NULL. This
effectively completes the back out of custom scripts for tftp booted
loaders from r269153 that was started in r292344 with the new path
tricks that obsoleted it.
Submitted by: Netflix
HELP_FILES is a loader only thing, so move it to loader.mk. Only
generate the help file if HELP_FILES is defined. Adjust Makefiles to
new convention. Fix a few cases where ${.CURDIR}/ was missing
resulting in missing bits from the help files.
Sponsored by: Netflix
Use _STANDALONE for guard expression in efichar.[ch] and add efi_char typedef.
clean up boot1.c, and replace for loop in efipart.c with ucs2len().
Reviewed by: imp
Differential Revision: https://reviews.freebsd.org/D13488
Don't print when we can't find a file. Copy it instead to the error
buffer. Higher level routines determine if it's appropriate to print
the error message.
Also, remove dead code (labeled bogusly lost functionality) since we
never used that functionality. Remove unused arg from interact() too.
Sponsored by: Netflix
latter aren't used. Prefer sys/link_elf.h to link.h so we're only
dependent on the kernel tree. The default installation of link.h just
includes this file, and any benefit from that is outweighed by the
hassle it causes. This reduces the footprint of files needed from the
system includes (or sysroot in buildworld).
Sponsored by: Netflix
Remove the now-useless dependency on ufsread.c. In some cases, it was
on the wrong file. But in all cases, we now automatically generate
.depend files, so we don't need it explicitly.
Sponsored by: Netflix
iPXE does insert stub BLOCK IO protocol handle to rework other issues,
this handle is not usable as it does not provide actual implementation.
We can detect this situation by checking and validating the BlockSize
property, so this update does make sure we have BlockSize at least 512B
and its value is power of 2.
PR: 223969
Reported by: Jeff Pieper
Reviewed by: imp
Differential Revision: https://reviews.freebsd.org/D13297
Rework the block device handle check to allow more robust device
classification. This is mostly usability issue - it can be quite confusing
for user when no disks are listed with lsdev.
Add more comments about what and why is done.
Reviewed by: imp
Differential Revision: https://reviews.freebsd.org/D13026
simd / no float stuff is centeralized here. Also centralise
-ffreestanding since it is specified everywhere.
This, along with a change to share/mk/bsd.cpu.mk to include -mno-avx2
in CFLAGS_NO_SIMD should fix building for newer machines (eg with
CPUTYPE=haswell) where clang was generating avx2 instructions.
Sponsored by: Netflix
