remaining potential races in ifconfig's management of IPX addresses.
This is largely accomplished by dropping a global write lock for the
IPX address list over the body of in_control(), although there are
some places we bump the refcount on an ifaddr of interest while
calling out to the routing code or link layer code, which might
require revisiting.
Annotate one as a potential race if two simultaneous delete ioctls
are issued for the same IPX addresses at once.
MFC after: 3 weeks
a new rwlock, ipx_ifaddr_rw, wrapped with macros. This locking is
necessary but not sufficient, in isolation, to satisfy the stability
requirements of a fully parallel IPX input path during interface
reconfiguration.
MFC after: 3 weeks
- Unify reference count and lock initialization in a single function,
ifa_init().
- Move tear-down from a macro (IFAFREE) to a function ifa_free().
- Move reference count bump from a macro (IFAREF) to a function ifa_ref().
- Instead of using a u_int protected by a mutex to refcount(9) for
reference count management.
The ifa_mtx is now used for exactly one ioctl, and possibly should be
removed.
MFC after: 3 weeks
years by the priv_check(9) interface and just very few places are left.
Note that compatibility stub with older FreeBSD version
(all above the 8 limit though) are left in order to reduce diffs against
old versions. It is responsibility of the maintainers for any module, if
they think it is the case, to axe out such cases.
This patch breaks KPI so __FreeBSD_version will be bumped into a later
commit.
This patch needs to be credited 50-50 with rwatson@ as he found time to
explain me how the priv_check() works in detail and to review patches.
Tested by: Giovanni Trematerra <giovanni dot trematerra at gmail dot com>
Reviewed by: rwatson
structures in IPX/SPX -- primarily, sequence numbering, PCB lists,
and PCBs for IPX raw sockets, IPX datagram sockets, and IPX/SPX.
As such, remove remove NET_NEEDS_GIANT() for IPX, and remove the
assertion of Giant in the ipxintr() IPX input path.
Note that IPX/SPX is not fully MPSAFE, and that there are some
problems with IPX/SPX locking that will require some further work.
However, it is now safe enough to run in general without the Giant
lock.
MFC after: 4 weeks
operation using NET_NEEDS_GIANT(). This will result in a boot-time
restoration of Giant-enabled network operation, or run-time warning on
dynamic load (applicable only to the Netgraph component). Additional
components will likely need to be marked with this in the future.
general cleanup of the API. The entire API now consists of two functions
similar to the pre-KSE API. The suser() function takes a thread pointer
as its only argument. The td_ucred member of this thread must be valid
so the only valid thread pointers are curthread and a few kernel threads
such as thread0. The suser_cred() function takes a pointer to a struct
ucred as its first argument and an integer flag as its second argument.
The flag is currently only used for the PRISON_ROOT flag.
Discussed on: smp@
Note ALL MODULES MUST BE RECOMPILED
make the kernel aware that there are smaller units of scheduling than the
process. (but only allow one thread per process at this time).
This is functionally equivalent to teh previousl -current except
that there is a thread associated with each process.
Sorry john! (your next MFC will be a doosie!)
Reviewed by: peter@freebsd.org, dillon@freebsd.org
X-MFC after: ha ha ha ha
<sys/proc.h> to <sys/systm.h>.
Correctly document the #includes needed in the manpage.
Add one now needed #include of <sys/systm.h>.
Remove the consequent 48 unused #includes of <sys/proc.h>.
1:
s/suser/suser_xxx/
2:
Add new function: suser(struct proc *), prototyped in <sys/proc.h>.
3:
s/suser_xxx(\([a-zA-Z0-9_]*\)->p_ucred, \&\1->p_acflag)/suser(\1)/
The remaining suser_xxx() calls will be scrutinized and dealt with
later.
There may be some unneeded #include <sys/cred.h>, but they are left
as an exercise for Bruce.
More changes to the suser() API will come along with the "jail" code.
for possible buffer overflow problems. Replaced most sprintf()'s
with snprintf(); for others cases, added terminating NUL bytes where
appropriate, replaced constants like "16" with sizeof(), etc.
These changes include several bug fixes, but most changes are for
maintainability's sake. Any instance where it wasn't "immediately
obvious" that a buffer overflow could not occur was made safer.
Reviewed by: Bruce Evans <bde@zeta.org.au>
Reviewed by: Matthew Dillon <dillon@apollo.backplane.com>
Reviewed by: Mike Spengler <mks@networkcs.com>
FreeBSD/alpha. The most significant item is to change the command
argument to ioctl functions from int to u_long. This change brings us
inline with various other BSD versions. Driver writers may like to
use (__FreeBSD_version == 300003) to detect this change.
The prototype FreeBSD/alpha machdep will follow in a couple of days
time.
Use the MAC address of an interface for the host part of an IPX address
and not the MAC address of the first interface for every IPX address.
This is more inline with the way others like Novell do it.
Mostly Submitted by: "Serge A. Babkin" <babkin@hq.icb.chel.su>
Take out the error messages (the ip icmp equivalent) with #ifdef IPXERRORMSGS.
This is bogus and as far as I could figure out IPX don't have anything like
it. This is a leftover from its XNS heritage. If nobody complains, I will
take it out completely in a few weeks.
Add some more ipxstat statistics counters.
Make ipxprintfs a sysctl variable and off by default.
Add IPX Netbios "routing" support. This is off by default and can be
switched on with a sysctl knob.
General code cleanup to at least use the same style throughout the IPX
code, but also be more style(9) conformant. Also make a lot of functions
static.
If I don't get any complaints I'll bring all of this over to the 2.2 tree
in a few weeks.
This will make a number of things easier in the future, as well as (finally!)
avoiding the Id-smashing problem which has plagued developers for so long.
Boy, I'm glad we're not using sup anymore. This update would have been
insane otherwise.
to TAILQs. Fix places which referenced these for no good reason
that I can see (the references remain, but were fixed to compile
again; they are still questionable).
Submitted by: Mike Mitchell, supervisor@alb.asctmd.com
This is a bulk mport of Mike's IPX/SPX protocol stacks and all the
related gunf that goes with it..
it is not guaranteed to work 100% correctly at this time
but as we had several people trying to work on it
I figured it would be better to get it checked in so
they could all get teh same thing to work on..
Mikes been using it for a year or so
but on 2.0
more changes and stuff will be merged in from other developers now that this is in.
Mike Mitchell, Network Engineer
AMTECH Systems Corporation, Technology and Manufacturing
8600 Jefferson Street, Albuquerque, New Mexico 87113 (505) 856-8000
supervisor@alb.asctmd.com
