cmdlengthdelta is the size of the header and we were using it to
allocate a buffer to store the command line. This would mean that
the cmdbuf could be too short. In practice this was never noticed unless
you usually run top -a. On a stock FreeBSD system you can see the
problem by running sendmail and then running top -a on a big terminal
window. In practice this doubles to size available to cmdbuf since the
header is around 65-68 bytes.
Reviewed by: adrian
other than UART 0 from the outset.
o) Print board information from sysinfo after consoles have been initialized
rather than doing it during boot descriptor parsing.
o) Use cvmx_safe_printf and platform_reset rather than panic when doing very
early boot descriptor parsing before the console is set up.
o) Get rid of the global octeon_bootinfo.
- Use 2001:db8:: as an example instead of deprecated 3ffe:: address block.
- Add check for connected routes.
- Add support of RTM_IFANNOUNCE for dyanmically-added/removed interfaces.
- Add support of *, ?, and [ in the interface list.
- Add -P number to specify route flag which will never expire.
- Add -Q number to specify route flag which route6d will add to routes via RIP.
- Add -p pidfile to specify the process ID file.
- Use queue(3) for linked-list.
- Use a consistent naming scheme for struct members.
- Use ANSI C style function declaration.
- Add check of RTM_VERSION mismatch.
There is no functional change.
if we fail to generate a proper root pool configuration based on disk
probing. Currently we can not properly generate the configuration for
multi-vdev pools. Make that explicit.
Reported by: madpilot, Bartosz Stec <bartosz.stec@it4pro.pl>
Tested by: madpilot, Bartosz Stec <bartosz.stec@it4pro.pl>
MFC after: 4 days
While here, also correct a comment that seems to imply that this file is
NetBSD's all-singing, all-dancing locore.S, rather than our conservative set of
assembly support routines.
userland via routing socket or sysctl. This eliminates the following
KAME-specific sin6_scope_id handling routine from each userland utility:
sin6.sin6_scope_id = ntohs(*(u_int16_t *)&sin6.sin6_addr.s6_addr[2]);
This behavior can be controlled by net.inet6.ip6.deembed_scopeid. This is
set to 1 by default (sin6_scope_id will be filled in the kernel).
Reviewed by: bz
comma-separated list and/or range specification:
# route add -inet 192.0.2.0/24 198.51.100.1 -fib 1,3-5,6
Although all of the subcommands supports the modifier, "monitor" does not
support the list or range specification at this moment.
Reviewed by: bz
from HDMI/DisplayPort devices in form of general connection status and
sound(4)-style channel matrix. Now that information is only reported in
readable form to verbose logs, but potentially could be used by sound(4)
to correctly choose default devices and configure vchans.
Fix rear and side channels swap on analog 7.1 outputs. As soon as there is
a huge mess in industry about naming and using of these channels, duplicate
rear channels of 4 and 5.1 streams to both read and side speakers.
