when using '-p' with reboot, and the power down action failds, reboot
the system normally. The behaviour of 'halt -p' and of shutdown(8) is
unchanged.
Approved by: roberto
'-p' is used on the reboot(8) command line.
This is intended for use when you want to attempt a power down
action, but you want the system to reboot (not halt) if the
power down action fails.
This is typically useful when the power-off action performed by
the kernel consists in signalling an uninterrupted power supply
that it should shut down its inverter if mains power has not returned.
The behaviour of shutdown(8) and init(8) is not modified;
only the behaviour of invoking 'reboot -p' manually is
modified, and then only in the case when a power-down action
fails.
Sounded reasonable to: phk
Approved by: roberto (mentor)
around. If the kernel boots successfully, the record of this kernel
is erased, it is intended to be a one-shot option for testing
kernels.
This could be improved by having the loader remove the record of
the next kernel to boot, it is currently removed in /etc/rc immediately
after disks are mounted r/w.
I'd like to MFC this before the 4.6 freeze unless there is violent
objection.
Reviewed by: Several on IRC
MFC after: 4 days
This flag adds a pausing utility. When ran with -p, during the kernel
probing phase, the kernel will pause after each line of output.
This pausing can be ended with the '.' key, and is automatically
suspended when entering ddb.
This flag comes in handy at systems without a serial port that either hang
during booting or reser.
Reviewed by: (partly by jlemon)
MFC after: 1 week
Avoid using parenthesis enclosure macros (.Pq and .Po/.Pc) with plain text.
Not only this slows down the mdoc(7) processing significantly, but it also
has an undesired (in this case) effect of disabling hyphenation within the
entire enclosed block.
processes and then sends SIGKILLs. If a lot of processes are swapped
out, this delay may not be long enough, so processes such as an X
server may be killed before they have had time to clean up properly.
Make this delay more dynamic by waiting up to 60 seconds for swap
page-in activity to end. While I'm here, ANSIfy and remove a
`register' specifier.
