command in case this setting was not saved. Since bandwidth reclamation
(-current only) often results in bus activity continuing to the end
of every frame, most transfers would fail with IOERROR if this
setting is missed.
Reviewed by: n_hibma
MFC after: 1 week
- Fix permission of device node.
fwochi.c, fwohcireg.h
- Detect phy access failure correct way.
- Set root hold-off bit before initiating bus reset.
This should fix the problem with VIA6306.
fwohcivar.h
- Fix over-allocation of array. (fwohcivar.h)
sbp.c
- Return CAM_DEV_NOT_THERE rather than CAM_TID_INVALID to prevent retry.
when julian@ added it, but the commented out code had at least
one bug -- not freeing the allocated mbuf.
Anyway, this comment no longer applies as of revision 1.67, so
remove it.
the entry being removed (ret_nrt != NULL), increment the entry's
rt_refcnt like we do it for RTM_ADD and RTM_RESOLVE, rather than
messing around with 1->0 transitions for rtfree() all over.
useful for accessing more than 1 page of contiguous physical memory, and
to use 4mb tlb entries instead of 8k. This requires that the system only
use the direct mapped addresses when they have the same virtual colour as
all other mappings of the same page, instead of being able to choose the
colour and cachability of the mapping.
- Adapt the physical page copying and zeroing functions to account for not
being able to choose the colour or cachability of the direct mapped
address. This adds a lot more cases to handle. Basically when a page has
a different colour than its direct mapped address we have a choice between
bypassing the data cache and using physical addresses directly, which
requires a cache flush, or mapping it at the right colour, which requires
a tlb flush. For now we choose to map the page and do the tlb flush.
This will allows the direct mapped addresses to be used for more things
that don't require normal pmap handling, including mapping the vm_page
structures, the message buffer, temporary mappings for crash dumps, and will
provide greater benefit for implementing uma_small_alloc, due to the much
greater tlb coverage.
- Added support for ITR (interrupt throttle register). This feature is available on
adapters based on 82545 and above
- Fixed problem with vlan support when traffic has priority bits set. (kern/45907)
PR: kern/45907
MFC after: 1 week
to current leaves because function may vanish the current node.
If parent RTA_GENMASK route has a clone (a "cloning clone"), an
rn_walktree_from() starting from parent will cause another walk
starting from clone. If a function is either rt_fixdelete() or
rt_fixchange(), this recursive walk may vanish the leaf that is
remembered by an outer walk (the "next leaf" above), panicing a
system when it resumes with an outer walk.
The following script paniced my single-user mode booted system:
: sysctl net.inet.ip.forwarding=1
: ipfw add 1 allow ip from any to any
: ifconfig lo0 127.1
: route add -net 10 -genmask 255.255.255.0 127.1
: telnet 10.1 # rt_fixchange() panic
: telnet 10.2
: telnet 10.1
: route delete -net 10 # rt_fixdelete() panic
For the time being, avoid these races by disallowing recursive
walks in rt_fixchange() and rt_fixdelete().
Also, make a slight optimization in the rtrequest(RTM_RESOLVE)
case: there is no reason to call rt_fixchange() in this case.
PR: kern/37606
MFC after: 5 days
I/O port range, then we should ignore a resource if it's NOT
a memory range AND NOT an I/O port range.
The OR in the condition caused us to ignore perfectly valid
memory addresses.
While here, remove redundant parenthesis and reindent the
debug print to avoid long lines.
- Put the kernel tsb before before the kernel load address, below
VM_MIN_KERNEL_ADDRESS, instead of after the kernel where it consumes
usable kva. This is magic mapped so the virtual address is irrelevant,
it just needs to be out of the way.
