Recently a change was made which broke loading 32-bit binaries on powerpc64,
with an assertion in ld-elf32.so.1:
ld-elf32.so.1: assert failed:
/usr/local/poudriere/jails/ppc64/usr/src/libexec/rtld-elf/rtld.c:390
It turns out Elf32_AuxInfo was broken for a very long time on powerpc64, as
it uses long and pointers, which are both 64 bits on powerpc64, and only
manifested with the recent work on auxargs.
Currently kexec loads an initrd file into the main memory but does not
mark that region as reserved, thus the area is not protected.
If any initrd/md file is loaded from kexec/petitboot, the region might become
corarupted/overwritten since FreeBSD does not know the region is 'reserved'.
This patch simply adds the initrd area as a reserved memory region.
Approved by: jhibbits
Differential Revision: https://reviews.freebsd.org/D15610
sg_alloc_table_from_pages() function in the LinuxKPI.
This basically allow segments to have a limit, max_segment.
Submitted by: Johannes Lundberg <johalun0@gmail.com>
MFC after: 1 week
Sponsored by: Mellanox Technologies
Sponsored by: Limelight Networks
I want to do this change because this call (actually,
AcpiHwLegacyWakePrep) does a memory allocation and ACPI namespace
evaluation. Although it is not very likely to run into any trouble, it
is still not safe to make those calls with interrupts disabled.
witness(4) and malloc(9) do not currently check for a context with
interrupts disabled via intr_disable and we lack a facility for doing
that. So, those unsafe operations fly under the radar. But if
intr_disable in acpi_EnterSleepState was replaced with spinlock_enter
(which it probably should be), then witness and malloc would immediately
complain.
Also, AcpiLeaveSleepStatePrep is documented as called when interrupts
are enabled. It used to require disabled interrupts, but that
requirement was changed a long time ago when support for _BFS and _GTS
was removed from ACPICA.
The ACPI wakeup sequence is very sensitive to changes. I consider this
change to be correct, but there can be fallouts from it.
What AcpiHwLegacyWakePrep essentially does is writing a value
corresponding to S0 into SLP_TYPx bits of PM1 Control Register(s).
According to ACPI specifications that write should be a NOP as SLP_EN
bit is not set. But I see in some chipset specifications that they
allow to ignore SLP_EN altogether and to act on a change of SLP_TYPx
alone.
Also, there are a couple of accesses to ACPI hardware before the new
location of the call to AcpiLeaveSleepStatePrep. One is to clear the
power button status and the other is to enable SCI. So, the move may
affect the interaction between then OS and ACPI platform.
I have not seen any regressions on my test system, but it's a desktop.
MFC after: 5 weeks
Intel now provides comprehensive tables for all performance counters
and the various valid configuration permutations as text .json files.
Libpmc has been converted to use these and hwpmc_core has been greatly
simplified by moving to passthrough of the table values.
The one gotcha is that said tables don't support pentium pro and and pentium
IV. There's very few users of hwpmc on _amd64_ kernels on new hardware. It is
unlikely that anyone is doing low level optimization on 15 year old Intel
hardware. Nonetheless, if someone feels strongly enough to populate the
corresponding tables for p4 and ppro I will reinstate the files in to the
build.
Code for the K8 counters and !x86 architectures remains unchanged.
- move harvest mask check inline
- move harvest mask to frequently_read out of actively
modified cache line
- disable ether_input collection and describe its limitations
in NOTES
Typically entropy collection in ether_input was stirring zero
in to the entropy pool while at the same time greatly reducing
max pps. This indicates that perhaps we should more closely
scrutinize how much entropy we're getting from a given source
as well as what our actual entropy collection needs are for
seeding Yarrow.
Reviewed by: cem, gallatin, delphij
Approved by: secteam
Differential Revision: https://reviews.freebsd.org/D15526
This is a follow-up to r321483, which disabled -Wmacro-redefined for
some lib/msun tests.
If an application included both fenv.h and ieeefp.h, several macros such
as __fldcw(), __fldenv() were defined in both headers, with slightly
different arguments, leading to conflicts.
Fix this by putting all the common macros in the machine-specific
versions of ieeefp.h. Where needed, update the arguments in places
where the macros are invoked.
This also slightly reduces the differences between the amd64 and i386
versions of ieeefp.h.
Reviewed by: kib
MFC after: 1 week
Differential Revision: https://reviews.freebsd.org/D15633
- Calculate the number of segments based on the page size
- Add some comments on dma function so it's easier to read
- Only enable interrupts on the last dma segment
- If the segments size is the max transfer size, use the special size 0
for the controller.
- The max_data ivars is in block so calculate it properly.
with upstream Linux by returning the pointer to the removed element.
Submitted by: Johannes Lundberg <johalun0@gmail.com>
MFC after: 1 week
Sponsored by: Mellanox Technologies
This is defined as Device-nGnRnE in the UEFI spec (UEFI 2.4, section
2.3.6.1). This is the VM_MEMATTR_DEVICE type in FreeBSD.
Reported by: tuexen
Sponsored by: DARPA, AFRL
The copied data is accessed in part soon after and it results with additional
cache misses during a -j 1 buildkernel WITHOUT_CTF=yes KERNFAST=1, as measured
with pmc stat.
before:
256165411 cache-references # 0.003 refs/inst
15105408 cache-misses # 5.897%
20.70 real # 99.67% cpu
13.24 user # 63.94% cpu
7.40 sys # 35.73% cpu
after:
256764469 cache-references # 0.003 refs/inst
11913551 cache-misses # 4.640%
20.70 real # 99.67% cpu
13.19 user # 63.73% cpu
7.44 sys # 35.95% cpu
Note the real time did not change, but traffic to RAM was reduced (multiple
measurements performed with switching the implementation at runtime).
Since nobody else is using non-temporal for this and there is no apparent
benefit at least these days, don't use them either.
Side note is that pagecopy arguments should probably get reversed to not
have to flip them around in the primitive.
Discussed with: jeff
- Restore local change to include <net/bpf.h> inside pcap.h.
This fixes ports build problems.
- Update local copy of dlt.h with new DLT types.
- Revert no longer needed <net/bpf.h> includes which were added
as part of r334277.
Suggested by: antoine@, delphij@, np@
MFC after: 3 weeks
Sponsored by: Mellanox Technologies
Rather than using fixed-length strings, pack them into a string table
to return. Also expand the buffer from ~300 charaters to 3k. This should
be enough, even for USB.
This fixes a problem where USB pnp info is truncated on return to
userland.
Differential Revision: https://reviews.freebsd.org/D15629
bhyve's root PCI complex shows up as PCIe, but behaves as traditional PCI.
Until that is special cased in a root complex driver, leave x86 as it was.
Requested by: grehan
for a port. Fix other related issues while here:
- Require port lock for access to link_config.
- Allow 100Mbps operation by tracking the speed in Mbps. Yes, really.
- New port flag to indicate that the media list is immutable. It will
be used in future refinements.
This also fixes a bug where the driver reports incorrect media with
recent firmwares.
MFC after: 2 days
Sponsored by: Chelsio Communications
security/audit/audit_ioctl.h uses a type from bsm/audit.h, so needs to
include it. And it needs to know the type's size, so it can't just
forward-declare.
PR: 228470
Submitted by: aniketp
MFC after: 2 weeks
Sponsored by: Google, Inc. (GSoC 2018)
Differential Revision: https://reviews.freebsd.org/D15561
pmap_is_prefaultable() and pmap_incore(), pushing the number of
shootdown IPIs back to the 3/1 kernel.
Benchmarked by: bde
Tested by: pho
Sponsored by: The FreeBSD Foundation
Create yet another temporal pte mapping routine pmap_pte_quick3(),
which is the copy of the pmap_pte_quick() and relies on the
pvh_global_lock to protect the frame. It accounts into the same
counters as pmap_pte_quick(). It is needed since pmap_copy() uses
pmap_pte_quick() already, and since a user pmap is no longer current
pmap.
pmap_copy() still provides the advantage for real-world workloads
involving lot of forks where processes do not exec immediately.
Benchmarked by: bde
Sponsored by: The FreeBSD Foundation
If a client did a DestroySession on a session while it was still in use,
the server might try to use the session structure after it is free'd.
I think the client has violated RFC5661 if it does this, but this patch
makes DestroySession block all other nfsd threads so no thread could
be using the session when it is free'd. After the DestroySession, nfsd
threads will not be able to find the session. The patch also adds a check
for nd_sessionid being set, although if that was not the case it would have
been all 0s and unlikely to have a false match.
This might fix the crashes described in PR#228497 for the FreeNAS server.
PR: 228497
MFC after: 1 week
