The variables in question are actually return arguments, but it's still good
form to initialize them.
Reported by: Coverity
CID: 979679 979680
MFC after: 4 weeks
Sponsored by: Spectra Logic Corp
until copy relocations are done.
Newer binutils and lld seems to output copy into relro-protected range.
Reported by: Rafael Espц╜ndola via emaste
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
The sysctl controls the period per interface.
Reviewed by: gnn
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D9153
and tw_so_options defined here which is supposed to be a copy of the
former (short vs u_short respectively).
Switch tw_so_options to be "signed short" to match the type of the field
it's inherited from.
Some g_raid tasters attempt metadata reads in multiples of the provider
sectorsize. Reads larger than MAXPHYS are invalid, so detect and abort
in such situations.
Spiritually similar to r217305 / PR 147851.
PR: 214721
Sponsored by: Dell EMC Isilon
m_pulldown()
m_pulldown() only needs to determine if a mbuf is writable if it is going to
copy data into the data region of an existing mbuf. It does this to create a
contiguous data region in a single mbuf from multiple mbufs in the chain. If
the requested memory region is already contiguous and nothing needs to
change, the mbuf does not need to be writeable.
Submitted by: Brian Mueller <bmueller@panasas.com>
Reviewed by: bz
MFC after: 1 week
Sponsored by: Panasas
Differential Revision: https://reviews.freebsd.org/D9053
The period should be taken into account by the function which
refreshes driver stats.
Reviewed by: philip
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D9130
Firmware version which takes PERIOD_MS parameter into account is
required.
Reviewed by: philip
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D9129
drain timeout handling to historical freebsd behavior.
The primary reason for these changes is the need to have tty_drain() call
ttydevsw_busy() at some reasonable sub-second rate, to poll hardware that
doesn't signal an interrupt when the transmit shift register becomes empty
(which includes virtually all USB serial hardware). Such hardware hangs
in a ttyout wait, because it never gets an opportunity to trigger a wakeup
from the sleep in tty_drain() by calling ttydisc_getc() again, after
handing the last of the buffered data to the hardware.
While researching the history of changes to tty_drain() I stumbled across
some email describing the historical BSD behavior of tcdrain() and close()
on serial ports, and the ability of comcontrol(1) to control timeout
behavior. Using that and some advice from Bruce Evans as a guide, I've
put together these changes to implement the hardware polling and restore
the historical timeout behaviors...
- tty_drain() now calls ttydevsw_busy() in a loop at 10 Hz to accomodate
hardware that requires polling for busy state.
- The "new historical" behavior for draining during close(2) is retained:
the drain timeout is "1 second without making any progress". When the
1-second timeout expires, if the count of bytes remaining in the tty
layer buffer is smaller than last time, the timeout is extended for
another second. Unfortunately, the same logic cannot be extended all
the way down to the hardware, because the interface to that layer is a
simple busy/not-busy indication.
- Due to the previous point, an application that needs a guarantee that
all data has been transmitted must use TIOCDRAIN/tcdrain(3) before
calling close(2).
- The historical behavior of honoring the drainwait setting for TIOCDRAIN
(used by tcdrain(3)) is restored.
- The historical kern.drainwait sysctl to control the global default
drainwait time is restored, but is now named kern.tty_drainwait.
- The historical default drainwait timeout of 300 seconds is restored.
- Handling of TIOCGDRAINWAIT and TIOCSDRAINWAIT ioctls is restored
(this also makes the comcontrol(1) drainwait verb work again).
- Manpages are updated to document these behaviors.
Reviewed by: bde (prior version)
Reallow device selectors to have a trailing colon, as documented in the
manual page. This was broken along with some unrelated cleanups in
r295806.
PR: 215979
Reported by: David Boyd <David.Boyd49 at twc.com>
Sponsored by: Dell EMC Isilon
This lets one interrupt DDB's output, which is useful if paging is
disabled and the output device is slow.
Submitted by: Anton Rang <rang@acm.org>
Reviewed by: jhb
MFC after: 1 week
Differential Revision: https://reviews.freebsd.org/D9138
Include netinet/in.h before ip_compat.t which will then check if
IPPROTO_IPIP is defined or not. Doing it the other way round,
ip_compat.h would not find it defined and netinet/in.h then
redefine it.
Active Open:
- Save the socket's vnet at the time of the active open (t4_connect) and
switch to it when processing the reply (do_act_open_rpl or
do_act_establish).
Passive Open:
- Save the listening socket's vnet in the driver's listen_ctx and switch
to it when processing incoming SYNs for the socket.
- Reject SYNs that arrive on an ifnet that's not in the same vnet as the
listening socket.
CLIP (Compressed Local IPv6) table:
- Add only those IPv6 addresses to the CLIP that are in a vnet
associated with one of the card's ifnets.
Misc:
- Set vnet from the toepcb when processing TCP state transitions.
- The kernel sets the vnet when calling the driver's output routine
so t4_push_frames runs in proper vnet context already. One exception
is when incoming credits trigger tx within the driver's ithread. Set
the vnet explicitly in do_fw4_ack for that case.
MFC after: 3 days
Sponsored by: Chelsio Communications
Avoid "unused variable 'i'" warnings in generated .c files by only
emitting the "int i;" for non-opaque arrays. Opaque arrays use
xdr_opaque() rather than iterating over the array.
Obtained from: OpenBSD (CVS rev 1.28)
MFC after: 1 week
when fortune and other games moved from /usr/games to /usr/bin; I am
removing rather than correcting it since we normally do not mention in
the FILES section the paths to programs in /usr/bin/.
PR: 215962
Reported by: Andras Farkas
With clang 4.0.0, we are getting the following warnings about struct
boot_module_t in efi's boot_module.h:
In file included from sys/boot/efi/boot1/ufs_module.c:41:
sys/boot/efi/boot1/boot_module.h:67:14: error: this function declaration is not a prototype [-Werror,-Wstrict-prototypes]
void (*init)();
^
void
sys/boot/efi/boot1/boot_module.h:92:16: error: this function declaration is not a prototype [-Werror,-Wstrict-prototypes]
void (*status)();
^
void
sys/boot/efi/boot1/boot_module.h:95:24: error: this function declaration is not a prototype [-Werror,-Wstrict-prototypes]
dev_info_t *(*devices)();
^
void
3 errors generated.
Fix this by adding 'void' to the parameter lists. No functional change.
Reviewed by: emaste, imp, smh
MFC after: 3 days
Differential Revision: https://reviews.freebsd.org/D9144
With clang 4.0.0, the EFI API header causes the following warning:
In file included from sys/boot/efi/loader/bootinfo.c:43:
In file included from sys/boot/efi/loader/../include/efi.h:52:
sys/boot/efi/include/efiapi.h:534:32: error: this function declaration is not a prototype [-Werror,-Wstrict-prototypes]
(EFIAPI *EFI_RESERVED_SERVICE) (
^
Add VOID to make it into a real prototype.
Reviewed by: imp, emaste, tsoome
MFC after: 3 days
Differential Revision: https://reviews.freebsd.org/D9132
after it, which has a conflicting definition of errno. This leads to
the following warning with clang 4.0.0:
In file included from sys/boot/common/reloc_elf32.c:6:
In file included from sys/boot/common/reloc_elf.c:37:
/usr/obj/usr/src/tmp/usr/include/stand.h:155:12: error: this function declaration is not a prototype [-Werror,-Wstrict-prototypes]
extern int errno;
^
sys/sys/errno.h:46:26: note: expanded from macro 'errno'
#define errno (* __error())
^
MFC after: 3 days
This also (inadvertently) contains an update to
contrib/netbsd-tests/lib/libc/sys/t_wait.c (new testcases).
MFC after: 2 weeks
In collaboration with: christos@NetBSD.org
There's no sense in trying to close a file descriptor from the negative cases
with unlink_test; it's best to ignore these cases.
The mkfifo case does make sense to keep though.
MFC after: 3 days
