other changes too).
(without any real order)
1. Use device_get_nameunit for mutex naming
2. Add timer for low-latency playback
3. Move most mixer controls from sysctls to mixer(8) controls.
This is a largest part of this patch.
4. Add analog/digital switch (as a temporary sysctl)
5. Get back support for low-bitrate playback (with help of (2))
6. Change locking for exclusive I/O. Writing to non-PTR register
is almost safe and does not need to be ordered with PTR operations.
7. Disable MIDI until we get it to detach properly and fix memory
managment problems.
8. Enable multichannel playback by default. It is as stable as
single-channel mode. Multichannel recording is still an
experimental feature.
9. Multichannel options can be changed by loader tunables.
10. Add a way to disable card from a loader tunable.
11. Add new PCI IDs.
12. Debugger settings are loader tunables now.
14. Remove some unused variables.
15. Mark pcm sub-devices MPSAFE.
16. Partially revert (bus_setup_intr -> snd_setup_intr) since it need
to be done independently
Submitted by: Yuriy Tsibizov (driver maintainer)
Approved by: re (bmah)
Bill Paul copyright. Not sure what the right copyright is, but this
file has been through 22 reversions on OpenBSD and 1 on NetBSD. This
isn't (yet) connected to the build, just in case I've done something
wrong (test builds worked, but better safe than sorry).
Submitted by: Weongyo Jeong
Approved by: re@
I did this in the previous commit, leaves out the parsing of $FreeBSD$
which is actually required to be parsed.
Kindly reminded by: bmah
Approved by: re (bmah)
Approved by: imp (mentor, implicit)
Timezone data changes in the following locations:
- Egypt
- Australia (new DST rules for 2008 and following)
- Perry County, Indiana
- America/Indiana/Tell_City
- Pike County, Indiana
Also:
- City coordinates corrected.
- Layout of leapseconds is updated
PR: conf/115706
Approved by: re (bmah@)
cr0-4, etc. Support should be added for other platforms that have a
different set of registers for system use.
Loosely based on: OpenBSD
Approved by: re
Also rename the related functions in a similar way.
There are no functional changes.
For a packet coming in with IPsec tunnel mode, the default is
to only call into the firewall with the "outer" IP header and
payload.
With this option turned on, in addition to the "outer" parts,
the "inner" IP header and payload are passed to the
firewall too when going through ip_input() the second time.
The option was never only related to a gif(4) tunnel within
an IPsec tunnel and thus the name was very misleading.
Discussed at: BSDCan 2007
Best new name suggested by: rwatson
Reviewed by: rwatson
Approved by: re (bmah)
Merge in parts of the old fast_ipsec.4 man page to ipsec.4 and
start updating ipsec.4 man page.
Reviewed by: brueffer, sam (slightly earlier versions), bmah
Approved by: re (bmah)
64bit counters are needed to simplify traffic accounting and
reduce system load at the big PPP concentrators.
Approved by: re (rwatson), glebius (mentor)
ports to the lagg interface.
- Use the MTU from the first interface as the lagg MTU, all extra interfaces
must be the same.
This fixes using a lagg interface for a vlan or enabling jumbo frames, etc.
Approved by: re (kensmith)
MFC After: 3 days
information from the submitter:
Starting value for OID_AUTO was changed from 100 to 256 (0x100) in
kern/kern_sysctl.c#rev1.112 on 2001-07-25, and defined as
CTL_AUTO_START in sys/sysctl.h#rev1.98.
Submitted by: cnst
Silence from: #bsddocs on efnet
MFC After: 3 days
Approved by: re (bmah)
