Remove useless release semantic for some stores to it_need. For
stores where the release is needed, add a comment explaining why.
Fence after the atomic_cmpset() op on the it_need should be acquire
only, release is not needed (see above). The combination of
atomic_cmpset() + fence_acq() is better expressed there as
atomic_cmpset_acq().
Use atomic_cmpset() for swi' ih_need read and clear.
Discussed with: alc, bde
Reviewed by: bde
Comments wording provided by: bde
Sponsored by: The FreeBSD Foundation
MFC after: 2 weeks
For Lenovo laptops with buggy bios (x220, t420, t520):
Write the 0xee entry into the second slot in the pmbr instead of the first
For some Dell and HP models:
The BIOS gives a warning message when booting in legacy mode from a GPT partitioned disk where the 0xee partition in the pmbr is not flagged active
For models known to have this problem, mark the pmbr active during installation
Use smbios data to identify machines known to be affected by any of the above, and offer the user the option to apply the workaround
In bsdinstall's ufs auto mode (autopart partition wizard):
Allow users to select which type of partition table to use
Keep current defaults: MBR for BIOS, GPT for UEFI
This allows users to choose GPT for legacy boot if they wish
PR: 184910
PR: 194359
Reviewed by: Michael Dexter
Approved by: marcel
MFC after: 3 days
X-MFC-With: r285594
Relnotes: yes
Sponsored by: ScaleEngine Inc.
Differential Revision: https://reviews.freebsd.org/D3091
with some cards that causes them to become deselected after probing for
switch capabilities. The old workaround fixes the behavior with some cards,
but causes problems with the cards the behave correctly and don't become
deselected. Forcing a deselect then reselect appears to work correctly
with all cards in initial testing.
SIGCHLD signal, should keep full 32 bits of the status passed to the
_exit(2).
Split the combined p_xstat of the struct proc into the separate exit
status p_xexit for normal process exit, and signalled termination
information p_xsig. Kernel-visible macro KW_EXITCODE() reconstructs
old p_xstat from p_xexit and p_xsig. p_xexit contains complete status
and copied out into si_status.
Requested by: Joerg Schilling
Reviewed by: jilles (previous version), pho
Tested by: pho
Sponsored by: The FreeBSD Foundation
a set of differentiated services, set IPTOS_PREC_* macros using
IPTOS_DSCP_* macro definitions.
While here, add IPTOS_DSCP_VA macro according to RFC 5865.
Differential Revision: https://reviews.freebsd.org/D3119
Reviewed by: gnn
LO_NOPROFILE is set. Some timecounter handlers acquire a spin mutex, and
we don't want to recurse if lockstat probes are enabled.
PR: 201642
Reviewed by: avg
MFC after: 3 days
enabled. The cost of a timecounter read can be quite significant, and the
problem became more apparent after r284297, since that change resulted in
a call to lockstat_nsecs() for each acquisition of an rwlock read lock.
PR: 201642
Reviewed by: avg
Tested by: Jason Unovitch
MFC after: 3 days
Differential Revision: https://reviews.freebsd.org/D3073
It turns out that the CDDL sources already introduce a function called
thread_create(). I'll investigate what we can do to make these functions
coexist.
Reported by: Ivan Klymenko
retval is used to test the return of XML_Parse function which is ok if 1 is
returned and retval it directly returned to the main function and used as an
exit value.
if all the parsing part is done reset retval to 0 so that the command return 0
if everything ok
Differential Revision: https://reviews.freebsd.org/D3102
Reviewed by: trasz
MFC after: 3 days
Sponsored by: gandi.net
scaling code does not use an uninitialized timestamp echo reply value
from the stack when timestamps are not enabled.
Differential Revision: https://reviews.freebsd.org/D3060
Reviewed by: hiren
Approved by: jmallett (mentor)
MFC after: 3 days
Sponsored by: Norse Corp, Inc.
This change refactors the existing create_thread() function to be more
generic. It replaces almost all of its arguments by a callback that can
be used to extract the thread ID and copy it out to the right place, but
also to perform additional initialization steps, such as setting the
trapframe. This also makes the difference between thr_new() and
thr_create() more clear in my opinion.
This function is going to be used by the CloudABI compatibility layer.
Reviewed by: kib
MFC after: 1 month
Basing on B.2.3.4:
Synchronization and coherency issues between data and
instruction accesses.
To ensure that modified instructions are visible to all PEs
(Processing Elements) in a shareability domain one need to
perform following sequence:
1. Clean D-cache
2. Ensure the visibility of data cleaned from cache
3. Invalidate I-cache
4. Ensure completion
5. In SMP system PE must issue isb to ensure execution of the
modified instructions
Reviewed by: andrew
Obtained from: Semihalf
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D3106
Secondary stack calculation is modified to provide
stack_top = secondary_stacks + (cpu_id) * PAGE_SIZE * KSTACK_PAGES
because on ARM64 the stack grows to lower memory addresses.
Obtained from: Semihalf
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D3107
Previous DMAP size was too small for systems with more than 64GB
of RAM. Increase it to 128GB to support ThunderX CRB.
Reviewed by: andrew
Obtained from: Semihalf
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D3113
Add support for the <sys/mman.h> functions by wrapping around our own
implementations. There are no kern_*() variants of these system calls,
but we also don't need them in this case. It is sufficient to just call
into the sys_*() functions.
Differential Revision: https://reviews.freebsd.org/D3033
Reviewed by: brooks
save it for later. This enables direct manipulation of the indirection
tables (although the stock driver doesn't do that right now).
MFC after: 1 month
belongs to the kernel stack address range for the thread. Right now,
code checks that new frame is not farther then KSTACK_PAGES pages from
the current frame, which allows the address to point past the top of
the stack.
Reviewed by: andrew, emaste, markj
Differential revision: https://reviews.freebsd.org/D3108
Sponsored by: The FreeBSD Foundation
MFC after: 2 weeks
Re-apply r99054 by des in 2002. This was accidentally dropped
by the update to OpenSSH 6.5p1 (r261320).
This change is actually taken from r387082 of
ports/security/openssh-portable/files/patch-ssh.c
PR: 198043
Differential Revision: https://reviews.freebsd.org/D3103
Reviewed by: des
Approved by: kib (mentor)
MFC after: 3 days
Relnotes: yes
Sponsored by: Dell Inc.
Summary:
For CloudABI we need to put two things on the stack of new processes:
the argument data (a binary blob; not strings) and a startup data
structure. The startup data structure contains interesting things such
as a pointer to the ELF program header, the thread ID of the initial
thread, a stack smashing protection canary, and a pointer to the
argument data.
Fetching system call arguments and setting the return value is similar
to FreeBSD. The only differences are that system call 0 does not exist
and that we call into cloudabi_convert_errno() to convert the error
code. We also need this function in a couple of other places, so we'd
better reuse it here.
Reviewers: dchagin, kib
Reviewed By: kib
Subscribers: imp
Differential Revision: https://reviews.freebsd.org/D3098
1) Use the TX FIFO empty interrupts to poll the transmit FIFO usage,
instead of using own software counters and waiting for SOF
interrupts. Assume that enough FIFO space is available to execute one
USB OUT transfer of any kind when the TX FIFO is empty.
2) Use the host channel halted event to asynchronously wait for host
channels to be disabled instead of waiting for SOF interrupts. This
results in less turnaround time for re-using host channels and at the
same time increases the performance.
The network transmit performance measured by "iperf" for the "RPi-B v1
2011/12" board, increased from 45MBit/s to 65Mbit/s after applying the
changes above.
No regressions seen using:
- High Speed (BULK, CONTROL, INTERRUPT)
- Full Speed (All transfer types)
- Low Speed (Control and Interrupt)
MFC after: 1 month
Submitted by: Daisuke Aoyama <aoyama@peach.ne.jp>
Their primary use was in thread_cow_update to free up old resources.
Freeing had to be done with proc lock held and _cow_ funcs already knew
how to free old structs.
Transitions 0->1 and 1->0 (which decide e.g. on putting the vnode on the free
list) of either counter are still guarded with vnode interlock.
Reviewed by: kib (earlier version)
Tested by: pho
If KSTACK_PAGES was changed to anything alse than the default,
the value from param.h was taken instead in some places and
the value from KENRCONF in some others. This resulted in
inconsistency which caused corruption in SMP envorinment.
Ensure all places where KSTACK_PAGES are used the opt_kstack_pages.h
is included.
The file opt_kstack_pages.h could not be included in param.h
because was breaking the toolchain compilation.
Reviewed by: kib
Obtained from: Semihalf
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D3094