working IRQ0 with APIC anymore. Previously, it was possible to have
some other ATPIC IRQS "leak" through in a few edge cases. For example, on
my x86 test machine, ACPI re-routes the SCI (IRQ 9) to intpin 13 on the
first I/O APIC. This leaves a hole for IRQ 13 (since the APIC doesn't
provide a source for IRQ 13 in that case) with the result that the ATPIC
IRQ13 source was registered instead. This changes the 8259A drivers to
only register their interrupt sources if none of the 16 ISA IRQs have an
interrupt source already installed.
MFC after: 1 week
- Add a new SET_KERNEL_SREGS macro that sets up %ds and %es to point to
kernel data and %fs to point to per-CPU data and use the new macro
in several kernel entry points including trap and interrupt handlers.
- Convert the IPI_STOP handler Xcpustop to push a standard trap frame
rather than an application frame.
- Make the TRAP() macro private to exception.s since it is only used
there.
- Move the PCPU_*() macros in asmacros.h out of the middle of the
profiling macros.
Reviewed by: bde
Requested by: bde (4, 5)
acquired anywhere in the driver now.
- Axe the spin mutex used for the nve_oslock*() routines. The driver lock
already provides sufficient synchronization.
- Don't mess around with IFF_UP when the link state changes. IFF_UP is
an administrative flag, not a link status indicator.
MFC after: 1 week
lock object (and thus off of each mutex and sx lock):
- Rename the all_locks list to pending_locks and only put locks initialized
before SI_SUB_WITNESS on the list so that the SI_SUB_WITNESS can add them
to witness once it starts up.
- Now that pending_locks is only used during early startup, change it from
a TAILQ to an STAILQ. This removes a pointer from the STAILQ_ENTRY in
struct lock_object.
- Since the pending_locks list is only used during the single-threaded
early boot it no longer needs to be protected by a mutex, so remove
all_mtx.
- Since the lo_list member of struct lock_object is now only used during
early boot before witness is running, collapse lo_list and lo_witness
into a union. This shaves the second pointer off of struct lock_object.
- Axe lock_cur_cnt and lock_max_cnt.
With these changes, struct mtx shrinks from 36 to 28 bytes on 32-bit
platforms and from 72 to 56 bytes on 64-bit platforms. Note that this
commit will completely and utterly destroy the kernel ABI, so no MFC.
Tested on: alpha, amd64, i386, sparc64
immediately from acpi_pci_link_route_interrupt() since we aren't going
to have a valid pci_link device to talk to try to route interrupts. This
fixes a page fault if you disable just pci_link. Note that trying to use
ACPI without pci_link is probably not advised however.
MFC after: 1 week
Tested by: Eugene Grosbein eugen at kuzbass dot ru
since mount_smbfs(8) assumed long name mounting by default unless "-n long"
was explicitly specified.
Rather than supplying a "long" option in mount_smbfs(8), this commit brings
back the original behaviour by associating SMBFS_MOUNT_NO_LONG with the
"nolong" option. This should fix the broken long file names on smbfs people
observed recently.
Reported by: Vladimir Grebenschikov <vova at fbsd dot ru>
Reviewed by: phk
Tested by: Slawa Olhovchenkov <slw at zxy dot spb dot ru>
the eaddr array (introduced in rev. 1.174) prior to writing to it. As
dc_read_eeprom() is told to write only 3 16-bit words to eaddr but eaddr
in fact is somewhat larger removal of the zeroing defeated the check
whether the MAC address is all zero as there can be some random garbage
in eaddr past the 3 words written to it and the check verifys all bits
in eaddr. Solve this by changing the check to verify only the 3 words
(happenning to be ETHER_ADDR_LEN bytes) written to eaddr.
- While here change the notation of "FCode" in a nearby comment to the
official way.
Ok'ed by: marcel, ru
o plug memory leak in adhoc mode: on rx the sender may be the
current master so simply checking against ic_bss is not enough
to identify if the packet comes from an unknown sender; must
also check the mac address
o split neighbor node creation into two routines and fillin state
of nodes faked up on xmit when a beacon or probe response frame
is later received; this ensures important state like the rate set
and advertised capabilities are correct
Obtained from: netbsd
MFC after: 1 week
polarity. Some machines route PCI IRQs to an ISA IRQ but fail to include
an interrupt override entry to set the polarity and trigger of the given
ISA IRQ in their MADT table.
PR: usb/74989
Reported by: Julien Gabel jpeg at thilelli dot net
MFC after: 1 week
from sys/sparc64/include/ofw_upa.h to sys/sparc64/pci/ofw_pci.h and
rename them to struct ofw_pci_ranges and OFW_PCI_RANGE_* respectively.
This ranges struct only applies to host-PCI bridges but no to other
bridges found on UPA. At the same time it applies to all host-PCI
bridges regardless of whether the interconnection bus is Fireplane/
Safari, JBus or UPA.
- While here rename the PCI_CS_* macros in sys/sparc64/pci/ofw_pci.h
to OFW_PCI_CS_* in order to be consistent and change this header to
use uintXX_t instead of u_intXX_t.
the bridge (PCI bus A or B) we are attaching to rather than registering
both handlers at once when attaching to the first half we encounter.
This is a bit cleaner as it corresponds to which PCI bus error interrupt
actually is assigned to the respective half by the OFW and allows to
collapse both PCI bus error interrupt handlers into one function easily.
- Use the actual RID of the respective interrupt resource as index into
sc_irq_res and also use it when allocating the resource. For now this
is a bit cleaner and will be mandatory later on.
- According to OpenSolaris the spare hardware interrupt is used as the
over-temperature interrupt in systems with Psycho bridges. Unlike as
with the SBus-based workstations I didn't manage to trigger it when
covering the fan outlets of an U60 but better be safe than sorry and
register a handler anyway.
MFC after: 1 month
bug by explaining what the problem is and how the workaround works.
- Fix some cosmetics nits, mainly properly terminate sentences in comments,
which I missed when backporting the style changes to psycho(4) in psycho.c
rev. 1.54 due to lack of corresponding code.
- The "USIIe version of the Sabre bridge" actually is termed "Hummingbird";
name it as such in comments and messages.
and some fixes from Motomichi Matsuzaki. Testing involved many people, but the
final, successful testing was from rwatson who endured several rounds of "it
crashes at XYZ stage" "oh, please correct this typo and try again." The Linux
driver, and to a small extent the limited specs, were both used as a reference
for how to program the chipset.
PR: kern/80396
Submitted by: Martin Mersberger
the base rcorder. This is accomplished by running rcorder twice,
first to get all the disks mounted (through mountcritremote),
then again to include the local_startup directories.
This dramatically changes the behavior of rc.d/localpkg, as
all "local" scripts that have the new rc.d semantics are now
run in the base rcorder, so only scripts that have not been
converted yet will run in rc.d/localpkg.
Make a similar change in rc.shutdown, and add some functions in
rc.subr to support these changes.
Bump __FreeBSD_version to reflect this change.
revision 1.179 to correctly set/clear execute permission on the mapping
it creates. Thus, mmap(2)ing a memory resident file will not result in
the file being mapped with execute permission when execute permission was
not requested.
Eliminate an unneeded Instruction Memory Barrier (IMB) in
pmap_enter_quick(). Since there was no previous (instruction) mapping
for the given virtual address prior to pmap_enter_quick(), there can be
no instructions from the given virtual address in the pipeline that need
flushing.
MFC after: 1 week
