for that argument. This will allow DDB to detect the broad category of
reason why the debugger has been entered, which it can use for the
purposes of deciding which DDB script to run.
Assign approximate why values to all current consumers of the
kdb_enter() interface.
old code special cased them too early which caused a few differences for
these sort of links relative to other PCI links:
- They were always re-routed via the BIOS call instead of assuming that
they were already routed if the BIOS had programmed the IRQ into a
matching device during POST.
- If the BIOS did route that link to a different IRQ that was marked as
invalid, we trusted the $PIR table rather than the BIOS IRQ.
This change moves the special casing for "unique IRQ" links to only take
that into account when picking an IRQ for an unrouted link so that these
links will now not be routed if the BIOS appears to have routed it already
(some BIOSen have problems with that) and so that if the BIOS uses a
different IRQ than the $PIR, we trust the BIOS routing instead (this is
what we do for all other links as well).
Reported by: Bruce Walter walter of fortean com
MFC after: 1 week
cards:
o RocketRAID 172x series
o RocketRAID 174x series
o RocketRAID 2210
o RocketRAID 222x series
o RocketRAID 2240
o RocketRAID 230x series
o RocketRAID 231x series
o RocketRAID 232x series
o RocketRAID 2340
o RocketRAID 2522
Many thanks to Highpoint for their continued support of FreeBSD.
Submitted by: Highpoint
register (MacBooks only).
This allows MacBooks to boot in SMP mode without any trick and solves
the timer problems with HZ=1000.
MFC after: 1 week
Reviewed by: njl (mentor), jhb
Approved by: njl (mentor), jhb
with insufficient protection mode.
For the i386 and amd64, create the tunable, machdep.prot_fault_translation,
with the following behaviour:
0 = autodetect the signal to be delivered on KERN_PROTECTION_FAILURE
from vm_fault based on the ELF OSABI note:
no note or __FreeBSD_version < 700004 - SIGBUS/BUS_PAGE_FAULT
note, and __FreeBSD_version >= 700004 - SIGSEGV/SEGV_ACCERR
1 = always SIGBUS/BUS_PAGE_FAULT
2 = always SIGSEGV/SEGV_ACCERR
This would do mostly automatic correction of ABI breakage, with the exception
of the untaged binaries for 7-CURRENT/RELENG_7 before the note is fixed. For
them, sysctl would allow to run the binary with manual settings.
Discussed with: portmgr (kris)
PR: kern/118304
MFC after: 3 days
- Introduce per-architecture stack_machdep.c to hold stack_save(9).
- Introduce per-architecture machine/stack.h to capture any common
definitions required between db_trace.c and stack_machdep.c.
- Add new kernel option "options STACK"; we will build in stack(9) if it is
defined, or also if "options DDB" is defined to provide compatibility
with existing users of stack(9).
Add new stack_save_td(9) function, which allows the capture of a stacktrace
of another thread rather than the current thread, which the existing
stack_save(9) was limited to. It requires that the thread be neither
swapped out nor running, which is the responsibility of the consumer to
enforce.
Update stack(9) man page.
Build tested: amd64, arm, i386, ia64, powerpc, sparc64, sun4v
Runtime tested: amd64 (rwatson), arm (cognet), i386 (rwatson)
allocation fails and pv entries are reclaimed, there may be an unused pv
entry in a pv chunk that survived the reclamation. However, previously,
after reclamation, get_pv_entry() did not look for an unused pv entry in
a surviving pv chunk; it simply retried the page allocation. Now, it
does look for an unused pv entry before retrying the page allocation.
Note: This only applies to RELENG_7. Earlier branches use a different
pv entry allocator.
MFC after: 6 weeks
since the branch caches on at least Athlon XP through Athlon 64 CPU's
don't understand such instructions and guarantee a cache miss taking
at least 10 cycles. Use the documented workaround "ret $0" instead
("nop; ret" also works, but "ret $0" is probably faster on old CPUs).
Normal code (even asm code) doesn't branch to "ret", since there is
usually some cleanup to do, but the __mcount, .mcount and .mexitcount
entry points were optimized too well to have the minimum number of
instructions (3 instructions each if profiling is not enabled) and
they did this. I didn't see a significant number of cache misses for
.mexitcount, but for the shared "ret" for __mcount and .mcount I
observed cache misses costing 26 cycles each. For a send(2) syscall
that makes about 70 function calls, the cost of these cache misses
alone increased the syscall time from about 4000 cycles to about 7000
cycles. 4000 is for a profiling (GUPROF) kernel with profiling disabled;
after this fix, configuring profiling only costs about 600 cycles in the
4000, which is consistent with almost perfect branch prediction in the
mcounting calls.
unused except to obfuscate disassemblies. -mprofiler-epilogue is
currently with gcc-4 (it does too little), but -finstrument-functions
is broken in a different way (it does too much).
amd64 version: meger whitespace fixes from i386 version.
- On amd64, just assume type #1 is always used. PCI 2.0 mandated
deprecated type #2 and required type #1 for all future bridges which
was well before amd64 existed.
- For i386, ignore whatever value was in 0xcf8 before testing for type #1
and instead rely on the other tests to determine if type #1 works. Some
newer machines leave garbage in 0xcf8 during boot and as a result the
kernel doesn't find PCI at all (which greatly confuses ACPI which expects
PCI to exist when PCI busses are in the namespace).
MFC after: 3 days
Discussed with: scottl
Currently, Giant is not too much contented so that it is ok to treact it
like any other mutexes.
Please don't forget to update your own custom config kernel files.
Approved by: cognet, marcel (maintainers of arches where option is
not enabled at the moment)
routine. It is not needed as the existing tests for segment coalescing
already handle bounced addresses and it prevents legal segment coalescing
in certain edge cases.
MFC after: 1 week
Reviewed by: scottl
include the ithread scheduling step. Without this, a preemption might
occur in between the interrupt getting masked and the ithread getting
scheduled. Since the interrupt handler runs in the context of curthread,
the scheudler might see it as having a such a low priority on a busy system
that it doesn't get to run for a _long_ time, leaving the interrupt stranded
in a disabled state. The only way that the preemption can happen is by
a fast/filter handler triggering a schduling event earlier in the handler,
so this problem can only happen for cases where an interrupt is being
shared by both a fast/filter handler and an ithread handler. Unfortunately,
it seems to be common for this sharing to happen with network and USB
devices, for example. This fixes many of the mysterious TCP session
timeouts and NIC watchdogs that were being reported. Many thanks to Sam
Lefler for getting to the bottom of this problem.
Reviewed by: jhb, jeff, silby
First, a file is mmap(2)ed and then mlock(2)ed. Later, it is truncated.
Under "normal" circumstances, i.e., when the file is not mlock(2)ed, the
pages beyond the EOF are unmapped and freed. However, when the file is
mlock(2)ed, the pages beyond the EOF are unmapped but not freed because
they have a non-zero wire count. This can be a mistake. Specifically,
it is a mistake if the sole reason why the pages are wired is because of
wired, managed mappings. Previously, unmapping the pages destroys these
wired, managed mappings, but does not reduce the pages' wire count.
Consequently, when the file is unmapped, the pages are not unwired
because the wired mapping has been destroyed. Moreover, when the vm
object is finally destroyed, the pages are leaked because they are still
wired. The fix is to reduce the pages' wired count by the number of
wired, managed mappings destroyed. To do this, I introduce a new pmap
function pmap_page_wired_mappings() that returns the number of managed
mappings to the given physical page that are wired, and I use this
function in vm_object_page_remove().
Reviewed by: tegge
MFC after: 6 weeks
communicate that it relates to (is called by) thread_alloc()
o Add cpu_thread_free() which is called from thread_free()
to counter-act cpu_thread_alloc().
i386: Have cpu_thread_free() call cpu_thread_clean() to
preserve behaviour.
ia64: Have cpu_thread_free() call mtx_destroy() for the
mutex initialized in cpu_thread_alloc().
PR: ia64/118024
opposed to what process. Since threads by default have teh name of the
process unless over-written with more useful information, just print the
thread name instead.
sys/dev/acpica/acpi.c rev 1.196 a while ago:
Grab Giant around calls to DEVICE_SUSPEND/RESUME in
acpi_SetSleepState().
If we are resuming non-MPSAFE drivers, they need Giant held for them.
This may fix some obscure suspend/resume problems. It has fixed keyrate
setting problems that were triggered by cardbus (MPSAFE) changing the
ordering for syscons resume (non-MPSAFE). Also, add some asserts that
Giant is held in our suspend/resume and shutdown methods.
Submitted by: Marko Zec
amd64 mechanism over. Instead of page table hackery that isn't
actually needed, just use 'struct pcpu __pcpu[MAXCPU]' for backing like
all the other platforms do. Get rid of 'struct privatespace' and a
while mess of #ifdef SMP garbage that set it up. As a bonus, this
returns the 4MB of KVA that we stole to implement it the old way.
This also allows you to read the pcpu data for each cpu when reading a
minidump.
Background information: Originally, pcpu stuff was implemented as having
per-cpu page tables and magic to make different data structures appear
at the same actual address. In order to share page tables, we switched
to using the GDT and %fs/%gs to access it. But we still did the evil
magic to set it up for the old way. The "idle stacks" are not used
for the idle process anymore and are just used for a few functions during
bootup, then ignored. (excercise for reader: free these afterwards).
This includes:
o mtree (for legal/intel_wpi)
o manpage for i386/amd64 archs
o module for i386/amd64 archs
o NOTES for i386/amd64 archs
Approved by: mlaier (comentor)
must be globally performed before calling any of the TLB invalidation
functions.
With one exception, on amd64, this requirement was already met. Fix this
one case. Also, as a clarification, change an existing atomic op into a
release. (Suggested by: jhb)
Reported and reviewed by: ups
MFC after: 3 days
silent NULL pointer dereference in the i386 and sparc64 pmap_pinit()
when the kmem_alloc_nofault() failed to allocate address space. Both
functions now return error instead of panicing or dereferencing NULL.
As consequence, vmspace_exec() and vmspace_unshare() returns the errno
int. struct vmspace arg was added to vm_forkproc() to avoid dealing
with failed allocation when most of the fork1() job is already done.
The kernel stack for the thread is now set up in the thread_alloc(),
that itself may return NULL. Also, allocation of the first process
thread is performed in the fork1() to properly deal with stack
allocation failure. proc_linkup() is separated into proc_linkup()
called from fork1(), and proc_linkup0(), that is used to set up the
kernel process (was known as swapper).
In collaboration with: Peter Holm
Reviewed by: jhb
warnings. Specifically, whenever vm_page_alloc(9) returned NULL to
get_pv_entry(), we issued a warning regardless of the number of pv
entries in use. (Note: The older pv entry allocator in RELENG_6 does
not have this problem.)
Reported by: Jeremy Chadwick
Eliminate the direct call to pagedaemon_wakeup() by get_pv_entry().
This was a holdover from earlier times when the page daemon was
responsible for the reclamation of pv entries.
MFC after: 5 days
refactored it to be a generic device.
Instead of being part of the standard kernel, there is now a 'nvram' device
for i386/amd64. It is in DEFAULTS like io and mem, and can be turned off
with 'nodevice nvram'. This matches the previous behavior when it was
first committed.
from Mac OS X Leopard--rationalize naming for entry points to
the following general forms:
mac_<object>_<method/action>
mac_<object>_check_<method/action>
The previous naming scheme was inconsistent and mostly
reversed from the new scheme. Also, make object types more
consistent and remove spaces from object types that contain
multiple parts ("posix_sem" -> "posixsem") to make mechanical
parsing easier. Introduce a new "netinet" object type for
certain IPv4/IPv6-related methods. Also simplify, slightly,
some entry point names.
All MAC policy modules will need to be recompiled, and modules
not updates as part of this commit will need to be modified to
conform to the new KPI.
Sponsored by: SPARTA (original patches against Mac OS X)
Obtained from: TrustedBSD Project, Apple Computer
macros to treat the 'slice' field as a real part of the bootdev instead
of as hack that spans two other fields (adaptor (sic) and controller)
that are not used in any modern FreeBSD boot code.
MFC after: 1 week
to kproc_xxx as they actually make whole processes.
Thos makes way for us to add REAL kthread_create() and friends
that actually make theads. it turns out that most of these
calls actually end up being moved back to the thread version
when it's added. but we need to make this cosmetic change first.
I'd LOVE to do this rename in 7.0 so that we can eventually MFC the
new kthread_xxx() calls.
optimization level (-march=pentium-mmx for example) does not insert
intermediate ops which would trash the carry.
Change both sys/i386/i386/in_cksum.c[1] and sys/i386/include/in_cksum.h.
To my best understanding the same problem was addressed in rev. 1.16
of src/sys/i386/include/in_cksum.h for just a single function 3y ago.
Reviewed by: jhb
Submitted by: Zhouyi ZHOU <zhouzhouyi FreeBSD.org> (intial version of [1])
MFC after: 5 days
PR: 115678, 69257
