that are made in each of the FSMs (LCP, CCP & IPCP) and the
number of REQs/Challenges for PAP/CHAP by accepting more arguments
in the ``set {c,ip,l}cpretry'' and ``set {ch,p}apretry'' commands.
Change the non-convergence thresholds to 3 times the number of configured
REQ tries (rather than the previous fixed ``10''). We now notice
repeated NAKs and REJs rather than just REQs.
Don't suggest that CHAP 0x05 isn't supported when it's not configured.
Fix some bugs that expose themselves with smaller numbers of retries:
o Handle instantaneous disconnects (set device /dev/null) correctly
by stopping all fsm timers in fsm2initial.
o Don't forget to uu_unlock() devices that are files but are not
ttys (set device /dev/zero).
Fix a *HORRENDOUS* bug in RFC1661 (already fixed for an Open event in state
``Closed''):
According to the state transition table, a RCR+ or RCR- received in
the ``Stopped'' state are supposed to InitRestartCounter, SendConfigReq
and SendConfig{Ack,Nak}. However, in ``Stopped'', we haven't yet
done a TLS (or the last thing we did is a TLF). We must therefore
do the TLS at this point !
This was never noticed before because LCP and CCP used not use
LayerStart() for anything interesting, and IPCP tends to go into
Stopped then get a Down because of an LCP RTR rather than getting a
RCR again.
(with care) in those instances where boot0 is not passed the
correct drive number by the PC BIOS. (The symptoms are a
"F5 Drive 0" line, even though the current drive is drive 0.)
a bum name to return as 0.0.0.0... we don't want ``delete xxx''
to delete the default route when xxx doesn't resolve.
Support IP number specifications as the host when specifying
a tcp-style device (rather than *just* hostnames).
correctly by invoking the timer to get the value before
displaying the message.
Don't assume that a value of 0 is ``random'' in
``show datalink''.
Make the random value between 1 and DIAL_TIMEOUT rather
than between 0 and DIAL_TIMEOUT-1
This is for various Olicom cards. An IBM driver is following.
This patch also adds support to tcpdump to decode packets on tokenring.
Congratulations to the proud father.. (below)
Submitted by: Larry Lile <lile@stdio.com>
Some CHAP implementations send no welcome message with their
SUCCESS/FAILURE packets. This was being mis-identified as
a truncated packet by the new authentication code :-(
is complete before checking carrier. If it's there,
the device supports carrier. If it's not it doesn't.
Add the ``set cd'' command for deciding how soon to check
for carrier, and for deciding if carrier is REQUIRED.
The default has changed: Pre 2.0 versions of ppp waited
for 1 second. Version 2 didn't wait, but this causes
problems with some (few?) modems that don't assert carrier
immediately on reporting CONNECT. The one second delay
is back now and can be removed with ``set cd 0''.
Bump the ppp version number in case this needs to be changed
again....
