The HCDP table is one (non-proprietary) way for the platform to
inform the OS about headless operation. This field would normally
hold the address as can be found by scanning the EFI system table,
which we also pass to the kernel. The apparent duplication allows
us to synthesize a HCDP table in the loader by whatever means we
can think of, including relocating the platform table into pre-
mapped address space. In short: it gives us more freedom.
Approved by: re (blanket)
Add function map_port_space() to map the memory mapped I/O port
range as uncacheable virtual memory and call it prior to probing
for a console. This removes the dependency on the loader to have
done this for us. Note that this change does not include doing
the same for APs.
Approved by: re (blanket)
to worry about ABI vs released systems yet. This is mostly transparent
since there is no significant exposure in the syscall interface. The
things that go wrong are mostly userland stuff - time(&intvariable).
Reviewed by: dfr, marcel
Approved by: re (jhb)
Don't force 16-byte alignment at run-time. Do it at compile-time.
This saves us the pointer fiddling by the setjmp functions and
reduces complexity. While here, increase the jmp_buf by 16 bytes
to an even 512 bytes. Coincidentally, due to the way alignment
was handled prior to this change, the jmp_buf has not changed in
size, but only in how the space is used. Prior to this change
the 16 bytes were reserved for enforcing alignment; now they are
reserved by us for future extensions.
Therefore, this ABI breaker is relatively save: the failure is
always an alignment trap.
have f16-f31 as part of the context. The PCB has been reorganized to
better match how we save and restore the (preserved) registers. This
commit also moves the context restoriation to its own function (named
pcb_restore), as we did with pcb_save.
Only minimal effort has been put in writing optimal assembly. The
expectation is that there will be more rounds of changes.
from all low-level bus space support functions. There's no need
to actually force the read/write to be accepted by the platform
before we can do anything else. We still have the mf instruction
there, which forces ordering. This too is not required given the
semantices of the bus space I/O functions, but it's not at all
clear to me if there are any poorly written device drivers that
depend on the strict ordering by the processor. The motto here is
to take small steps...
o Properly set the pointer to the counter for each interrupt and
update the intrnames table.
o Remove Alpha cruft from intrcnt.h.
o Create INTRNAME_LEN as the single entity that defines the width
of the names in the intrnames table (incl. terminatinf '\0').
handling clean and functional as 5.x evolves. This allows some of the
nasty bandaids in the 5.x codepaths to be unwound.
Encapsulate 4.x signal handling under COMPAT_FREEBSD4 (there is an
anti-foot-shooting measure in place, 5.x folks need this for a while) and
finish encapsulating the older stuff under COMPAT_43. Since the ancient
stuff is required on alpha (longjmp(3) passes a 'struct osigcontext *'
to the current sigreturn(2), instead of the 'ucontext_t *' that sigreturn
is supposed to take), add a compile time check to prevent foot shooting
there too. Add uniform COMPAT_43 stubs for ia64/sparc64/powerpc.
Tested on: i386, alpha, ia64. Compiled on sparc64 (a few days ago).
Approved by: re
by using the linker hooks. Since these hooks are called for the
kernel as well, we don't need to deal with that with a special
SYSINIT. The initialization implicitly performed on the first
update of the unwind information is made explicit with a SYSINIT.
We now don't need the _ia64_unwind_{start|end} symbols.
as a trivial function that only calls ia64_tpa() and hence requires
the prototype of ia64_tpa(), but by defining pmap_kextract as
ia64_tpa. This solves the inclusion ordering issue in ddb/db_watch.c
expand to __attribute__((packed)) and __attribute__((aligned(x)))
respectively. Replace the handful of gcc-ism's that use
__attribute__((aligned(16))) etc around the kernel with __aligned(16).
There are over 400 __attribute__((packed)) to deal with, that can come
later. I just want to use __packed in new code rather than add more
gcc-ism's.
under way to move the remnants of the a.out toolchain to ports. As the
comment in src/Makefile said, this stuff is deprecated and one should not
expect this to remain beyond 4.0-REL. It has already lasted WAY beyond
that.
Notable exceptions:
gcc - I have not touched the a.out generation stuff there.
ldd/ldconfig - still have some code to interface with a.out rtld.
old as/ld/etc - I have not removed these yet, pending their move to ports.
some includes - necessary for ldd/ldconfig for now.
Tested on: i386 (extensively), alpha
in the original hardwired sysctl implementation.
The buf size calculator still overflows an integer on machines with large
KVA (eg: ia64) where the number of pages does not fit into an int. Use
'long' there.
Change Maxmem and physmem and related variables to 'long', mostly for
completeness. Machines are not likely to overflow 'int' pages in the
near term, but then again, 640K ought to be enough for anybody. This
comes for free on 32 bit machines, so why not?
These types are unlikely to ever become very MD. They include:
clockid_t, ct_rune_t, fflags_t, intrmask_t, mbstate_t, off_t, pid_t,
rune_t, socklen_t, timer_t, wchar_t, and wint_t.
While moving them, make a few adjustments (submitted by bde):
o __ct_rune_t needs to be precisely `int', not necessarily __int32_t,
since the arg type of the ctype functions is int.
o __rune_t, __wchar_t and __wint_t inherit this via a typedef of
__ct_rune_t.
o Some minor wording changes in the comment blocks for ct_rune_t and
mbstate_t.
Submitted by: bde (partially)
called <machine/_types.h>.
o <machine/ansi.h> will continue to live so it can define MD clock
macros, which are only MD because of gratuitous differences between
architectures.
o Change all headers to make use of this. This mainly involves
changing:
#ifdef _BSD_FOO_T_
typedef _BSD_FOO_T_ foo_t;
#undef _BSD_FOO_T_
#endif
to:
#ifndef _FOO_T_DECLARED
typedef __foo_t foo_t;
#define _FOO_T_DECLARED
#endif
Concept by: bde
Reviewed by: jake, obrien
<stdint.h>. Previously, parts were defined in <machine/ansi.h> and
<machine/limits.h>. This resulted in two problems:
(1) Defining macros in <machine/ansi.h> gets in the way of that
header only defining types.
(2) Defining C99 limits in <machine/limits.h> adds pollution to
<limits.h>.
handler in the kernel at the same time. Also, allow for the
exec_new_vmspace() code to build a different sized vmspace depending on
the executable environment. This is a big help for execing i386 binaries
on ia64. The ELF exec code grows the ability to map partial pages when
there is a page size difference, eg: emulating 4K pages on 8K or 16K
hardware pages.
Flesh out the i386 emulation support for ia64. At this point, the only
binary that I know of that fails is cvsup, because the cvsup runtime
tries to execute code in pages not marked executable.
Obtained from: dfr (mostly, many tweaks from me).
hardly MD, since all our platforms share the same macro. It's not
really compiler dependent either, but this helps in reducing
<machine/ansi.h> to only type definitions.
implementations can provide a base zero ffs function if they wish.
This changes
#define RQB_FFS(mask) (ffs64(mask))
foo = RQB_FFS(mask) - 1;
to
#define RQB_FFS(mask) (ffs64(mask) - 1)
foo = RQB_FFS(mask);
On some platforms we can get the "- 1" for free, eg: those that use the
C code for ffs64().
Reviewed by: jake (in principle)
