U-Boot will leave the ephy reset de-asserted and the MAC soft reset will
fail on these boards with internal PHY and no link established. Toggle reset
again before proceeding to attach/init.
MFC after: 1 week
Do not invoke 'wlan_up' function from devd(8) on interface
creation event (an example to create such event:
'ifconfig wlan0 create wlandev rtwn0');
they're typically produced during 'service netif (re)start'
and result in duplicate interface initialization.
From the user side if WPA option is used, this result in messages like:
- /etc/rc.d/wpa_supplicant: WARNING: failed to start wpa_supplicant
or
- wpa_supplicant already running? (pid=xxxx).
(for HOSTAP interfaces this race may result in startup failure).
As a side effect, wpa_supplicant(8) / hostapd(8) will not be
invoked when new wlan(4) interface is created manually and
corresponding configuration for it is present in rc.conf(5).
This change does not affect device attach / removal events.
MFC after: 5 days
Test failures don't seem to propagate up if atf_check is run in
a pipeline. Thus, the tests continued to pass despite the bug reverted
in r343245.
MFC after: 1 week
It breaks the special mode specified by passing "-" as one of the
input files. Revert for now while we discuss a fix.
PR: 234885
Reported by: delphij
MFC after: now
- Check if buffer can contain Rx descriptor before accessing it.
- Verify upper / lower bounds for frame length.
- Do not pass too short frames into ieee80211_find_rxnode().
While here:
- Move cleanup to the function end.
- Reuse IEEE80211_IS_DATA() macro.
MFC after: 1 week
- Discard frames that are bigger than MCLBYTES (to prevent buffer overrun).
- Check buffer length before accessing its contents.
- Fix len <-> dmalen check - the last includes Rx Wireless information
structure size.
- Fix out-of-bounds read during Rx node search for ACK / CTS frames
(monitor mode only).
While here:
- Mark few suspicious places with comments.
- Move common cleanup to the function end.
MFC after: 1 week
indicates an error. Also, do not remove it twice from the hf list in
this case.
Submitted by: Krishnamraju Eraparaju @ Chelsio
MFC after: 1 week
Sponsored by: Chelsio Communicatons
there's no need to even mention it in shell rc files. Not that it's wrong;
just pointless and somewhat misleading.
Reviewed by: jilles
MFC after: 2 weeks
Sponsored by: DARPA, AFRL
Differential Revision: https://reviews.freebsd.org/D18809
The libedit "fout" output must be sent to fd 2 since it contains prompts
that POSIX says must be sent to fd 2. However, the libedit "ferr" output
receives error messages such as from "bind" that make no sense to send to fd
1.
Since r287197 ieee80211com is a part of drivers softc; as a result,
after detach all pointers to it (iv_ic, ni_ic) are invalid. Most
possible users (tasks, interrupt handlers) are blocked / removed
when device is stopped; however, ioctl handlers were not tracked
and may crash if ieee80211com structure is accessed.
Since ieee80211com pointer access from ieee80211vap structure is not
protected by lock (constant after interface creation) and used in
many other places just use reference counting for ioctl handlers;
on detach set 'detached' flag and wait until reference counter goes to 0.
For HEAD ieee80211vap size was changed (__FreeBSD_version bumped);
however, in stable branches I'm going to split / reuse the last
iv_spare field for KBI stability.
Tested with:
- rsu(4), SIOCSIFCAP (-rxcsum) ioctl;
- rtwn_pci(4), SIOCG80211 / IEEE80211_IOC_HTPROTMODE ioctl.
MFC after: 1 week
Semicolon is a legal character in long names but not in 8.3 format.
Move it to respective character set.
PR: 140068
Submitted by: tom@uffner.com
MFC after: 3 weeks
The recent gcc versions (7 and 8 at least) can check for switch case
statements for fall through (implicit-fallthrough). When fall through
is intentional, the default method for warning suppression is to place
comment /* FALLTHROUGH */ exactly before next case statement.
Differential Revision: https://reviews.freebsd.org/D18577
For most wireless drivers Rx mbuf is allocated as one
contiguous chunk; only few are using chains for allocations -
but even then at least MCLBYTES (minus Rx descriptor size) is
available in the first mbuf.
In addition to the above, m_pullup was never called here - otherwise,
reallocation will break post-crypto_decap logic (ieee80211_decap,
ieee80211_deliver_data...), so just remove it; length check is left
in case if some truncated frame appears here.
PR: 234241
MFC after: 1 week
Book-E powerpc uses 64-bit vm_paddr_t, and 32-bit powerpc has 32-bit pointers,
so gcc errors with cast to pointer from integer of different size. As this will
not actually be used in reality anyway, simply quiet the warning by casting
through uintptr_t.
MFC after: 3 weeks
MFC with: r343168
sendfile(2) appears to now use DMAP wherever possible. These addresses are not
managed by pmap, so pmap_kextract() returns a 0 physical address, causing
failure.
This change fixes nginx running on P5020 SoC.
MFC after: 3 weeks
The powerpc_intr structure is not zero-initialized, so on an invariants
build would panic in the xics driver with an invalid pointer. Also fix the
xics driver to share the private data setup code between xics_enable() and
xics_bind().
Reported by: Leonardo Bianconi
For parity with Intel hosts, which already mask out the CPUID feature
bits that indicate the presence of the SPEC_CTRL MSR, do the same on
AMD.
Eventually we may want to have a better support story for guests, but
for now, limit the damage of incorrectly indicating an MSR we do not yet
support.
Eventually, we may want a generic CPUID override system for
administrators, or for minimum supported feature set in heterogenous
environments with failover. That is a much larger scope effort than
this bug fix.
PR: 235010
Reported by: Rys Sommefeldt <rys AT sommefeldt.com>
Sponsored by: Dell EMC Isilon
getopt_long(3) requires the long options be terminated by a NULL block.
Without the terminator, an invalid long option results in a segmentation
fault.
Reported by: Brandon Bergren
MFC after: 1 week
Correct a logic error.
Only disable when already enabled or enable when disabled.
Submitted by: Richard Scheffenegger
Reviewed by: Cheng Cui
Obtained from: Cheng Cui
MFC after: 3 days
Differential Revision: https://reviews.freebsd.org/D18885
Without HID_IGNORE quirk enabled these models appear in the system as a uhid
devices while NUT (Network UPS Tool) expects them to be ugen.
PR: 131521
Submitted by: Naoyuki Tai <ntai@smartfruit.com>, John Bayly <john.bayly@tipstrade.net>
MFC after: 1 week
src could potentially be installed under the based dir
and not under the root or vice versa.
PR: 224048
Submitted by: Gerald Aryeetey <aryeeteygerald_rogers.com>
Reviewed by: delphij
MFC after: 1 month
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D18849
If i386 has more than 4G of memory, allow the same number of busdma
bounce pages as for amd64. In fact, in this case bouncing sometimes
is much heavier than on amd64.
Reviewed by: markj
Tested by: pho
Sponsored by: The FreeBSD Foundation
MFC after: 2 weeks
Differential revision: https://reviews.freebsd.org/D18854
Right now bus_addr_t and vm_paddr_t are always aliased to the same
underlying integer type on x86, which makes the interchange hard to
detect. Shortly, i386 kernel would use uint64_t for vm_paddr_t to
enable automatic use of PAE paging structures if hardware allows it,
while bus_addr_t would be extended to 64bit only when PAE option is
specified.
Fix all places that were identified as using bus_addr_t while page
address was assumed. This was performed by testing the complete PAE
merging patch on machine with > 4G of RAM enabled.
Reviewed by: markj
Tested by: pho
Sponsored by: The FreeBSD Foundation
MFC after: 2 weeks
Differential revision: https://reviews.freebsd.org/D18854
In order to allow single kernel to use PAE pagetables on i386 if
hardware supports it, and fall back to classic two-level paging
structures if not, superpage code should be able to adopt to either 2M
or 4M superpages size. There I make MI VM structures large enough to
track the biggest possible superpage, by allowing architecture to
define VM_NFREEORDER_MAX and VM_LEVEL_0_ORDER_MAX constants.
Corresponding VM_NFREEORDER and VM_LEVEL_0_ORDER symbols can be
defined as runtime values and must be less than the _MAX constants.
If architecture does not define _MAXs, it is assumed that _MAX ==
normal constant.
Reviewed by: markj
Tested by: pho (as part of the larger patch)
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
Differential revision: https://reviews.freebsd.org/D18853
The SPA ids are published numbers, so it's safe (if not a bit
annoying) to copy them into a source file.
Submitted by: D Scott Phillips <d.scott.phillips@intel.com>
Sponsored by: Intel Corporation
MFC after: 1 week
Differential revision: https://reviews.freebsd.org/D18733
The NVDIMM root device is parent to the individual ACPI NVDIMM
devices. Add a driver for the NVDIMM root device that can own
enumeration of NVDIMM devices as well as NVDIMM SPA ranges that the
system has.
Submitted by: D Scott Phillips <d.scott.phillips@intel.com>
Sponsored by: Intel Corporation
MFC after: 1 week
Differential revision: https://reviews.freebsd.org/D18346
Fix missing initialisation of sc_flags into a valid sync state on clone which
breaks carp in pfsync.
This regression was introduce by r342051.
PR: 235005
Submitted by: smh@FreeBSD.org
Pointy hat to: kp
MFC after: 3 days
Differential Revision: https://reviews.freebsd.org/D18882
- Add ADA_Q_NO_TRIM quirk to be used with the device that falsely advertise TRIM support
- Add ADA_Q_NO_TRIM entry for KingDian S200 SSD
PR: 222802
Submitted by: Bertrand Petit <bsdpr@phoe.frmug.org>
MFC after: 1 week
This is mostly a style fix since the code in question is not called multiple
times and doesn't have cummulative effect.
PR: 204953
Submitted by: David Binderman <dcb314@hotmail.com>
MFC after: 1 week
Even M_WAITOK callers must check for failure. For example, if the device is
quiescing, either due to automatic error-recovery induced reset, or due to
administrative detach, the routine will return ENXIO and the acquire
reference will not be held. So, there is no mode in which it is safe to
assume the routine succeeds without checking.
Sponsored by: Dell EMC Isilon
Since the loader zfs reader does not need to read the dump zvol, we can
just enable the feature.
illumos issue #9051https://www.illumos.org/issues/9051
MFC after: 2 weeks
