- Fill in autosense data.
- Add compatibility for RELENG_4.
* scsi_target.c
- Raw device support
- Set correct value in c_descr->offset for CAM_DIR_NONE case.
- Support for CTIO abort.
* Fix a bug where devices weren't cleaned up on close(): CAM_REQ_CMP != 0
user:
* Increase timeout in usermode to CAM_TIME_INFINITY. The initiator is in
charge of timeouts and the value was in ms, not seconds.
* Bring two debugging printfs under the debug flag
* Clean up man page to show increased testing on isp(4)
Submitted by: gibbs (bugfixes)
This code allows a user program to enable target mode on a SIM and
then emulate any number of devices (disks, tape drives, etc.) All
decisions about device behavior (UA, CA, inquiry response) are left
to the usermode program and the kernel driver is merely a conduit
for CCBs. This enables multiple concurrent target emulators, each
using its own backing store and IO model.
Also included is a user program that emulates a disk (RBC) using a
file as a backing store. This provides functionality similar to
md(4) at the CAM layer.
Code has been tested on ahc(4) and should also work on isp(4) (and
other SIMs that gain target mode support). It is a complete rewrite
of /sys/cam/scsi_target* and /usr/share/examples/scsi_target.
Design, comments from: gibbs
Supported by: Cryptography Research
Approved by: re
up cam_fill_ctio usage to passed atio flags. Clear periph_priv area
of new ctio so if the kernel is dumb enough to look at them (this is
a SECURITY hole) the panic will be obvious instead of subtle.
it up on exit. The address for attaching the emulator (path, target id,
lun) is now specified on the command line. Some attempt at cathing
signals and cleaning up target mode instances is now made.
