these names are used in data sheet. Also use UnicastPkts,
MulticastPkts and BroadcastPkts instead of UcastPkts, McastPkts
and BcastPkts to clarify its meaning.
Suggested by: bde
addresses that is greater than a superpage in size but not a multiple of
the superpage size, then vm_map_find() is not always expanding the kernel
pmap to support the last few small pages being allocated. These failures
are not commonplace, so this was first noticed by someone porting FreeBSD
to a new architecture. Previously, we grew the kernel page table in
vm_map_findspace() when we found the first available virtual address.
This works most of the time because we always grow the kernel pmap or page
table by an amount that is a multiple of the superpage size. Now, instead,
we defer the call to pmap_growkernel() until we are committed to a range
of virtual addresses in vm_map_insert(). In general, there is another
reason to prefer calling pmap_growkernel() in vm_map_insert(). It makes
it possible for someone to do the equivalent of an mmap(MAP_FIXED) on the
kernel map.
Reported by: Svatopluk Kraus
Reviewed by: kib@
MFC after: 3 weeks
suspicious about 'l' and '1' being confused in numeric constants.
The fear being that some old fart programmer might still think that
he is using a Remmington Noiseless as input terminal device.
An easy way to placate this fear is to use capital 'L' or to put
the 'u' in unsigned constants in front of the 'l'.
Unlike actual MTRR, this only controls the mapping attributes for
subsequent mmap() of /dev/mem. Nonetheless, the support is sufficiently
MTRR-like that Xorg can use it, which translates into an enormous increase
in graphics performance on PowerPC.
MFC after: 2 weeks
trap frame when trap initiated kdb entry, incorrectly calculated the
value of %rsp for trapped thread.
According to Intel(R) 64 and IA-32 Architectures Software Developer's Manual
Volume 3A: System Programming Guide, Part 1, rev. 035, 6.14.2 64-Bit Mode
Stack Frame, "64-bit mode ... pushes SS:RSP unconditionally, rather than
only on a CPL change."
Even assuming the conditional push of the %ss:%rsp, the calculation
was still wrong because sizeof(tf_ss) + sizeof(tf_rsp) == 16 on amd64.
Always use the tf_rsp from trap frame. The change supposedly fixes
stepping when using kgdb backend for kdb.
Submitted by: Zhouyi Zhou <zhouzhouyi gmail com>
PR: amd64/151167
Reviewed by: avg
MFC after: 1 week
scratch. This driver adds support for USB3.0 devices. The XHCI
interface is also backwards compatible to USB2.0 and USB1.0 and will
evntually replace the OHCI/UHCI and EHCI drivers.
There will be follow-up commits during the coming week to link the
driver into the default kernel build and add missing USB3.0
functionality in the USB core. Currently only the driver files are
committed.
Approved by: thompsa (mentor)
- Wakeup multiple threads per core using message ring watermark interrupts.
- Update message ring handler registration, use the real device station id
for registering interrupts.
- rge/nlge: update for the new message ring registration code.
- rge/nlge: use 2 message ring stations for incoming packets, this will
allow more messages to be queued.
- nlge: comment fixes, remove unused variable
- style and whitespace fixes
it (the root mount code) into a new file called vfs_mountroot.c
The split is almost trivial, as the code is almost perfectly
non-intertwined. The only adjustment needed was to move the UMA
zone allocation out of vfs_mountroot() [in vfs_mountroot.c] and
into vfs_mount.c, where it had to be done as a SYSINIT [see
vfs_mount_init()].
There are no functional changes with this commit.
different PHY instance being selected and isolation out into the wrappers
around the service methods rather than duplicating them over and over
again (besides, a PHY driver shouldn't need to care about which instance
it actually is).
- Centralize the check for the need to isolate a non-zero PHY instance not
supporting isolation in mii_mediachg() and just ignore it rather than
panicing, which should sufficient given that a) things are likely to
just work anyway if one doesn't plug in more than one port at a time and
b) refusing to attach in this case just leaves us in a unknown but most
likely also not exactly correct configuration (besides several drivers
setting MIIF_NOISOLATE didn't care about these anyway, probably due to
setting this flag for no real reason).
- Minor fixes like removing unnecessary setting of sc->mii_anegticks,
using sc->mii_anegticks instead of hardcoded values etc.
the linker_load_file methods. The change is that the consequent
linker_file_unload() call is not under the vnode lock anymore.
This prevents the LOR between kernel linker sx xlock and vnode lock,
because linker_file_unload() relocks kernel linker lock.
MFC after: 2 weeks
the miibus attached to octe interfaces.
o) Add an SMI/MDIO interface to the MV88E61XX and use it for the switch PHY on
the Lanner MR-320. An actual driver for the switch PHY will come later.
Note that for now it intercepts and fakes MII_BMSR reads to prevent the
miibus from talking to anything but the switch itself.
bus interface does that's special here now is to use a 64-bit register size.
In theory, uart(4) ought to support a regsz as well as regshft and support
64-bit registers directly.
Also use the UART class's range rather than a hand-coded 1024 for the address
range.
and set memory attributes appropriately for mmap() calls on /dev/console.
Xorg no longer uses /dev/console to mmap the framebuffer, so framebuffer
write combining support in X will arrive in the next patch.
by just caching the mode for later use by pmap_enter(), following amd64.
While here, correct some mismerges from mmu_oea64 -> mmu_oea and clean
up some dead code found while fixing the fictitious page behavior.
This patch is significantly based on previous work by jkim.
List of changes:
- added comments that describe topology uniformity assumption
- added reference to Intel Processor Topology Enumeration article
- documented a few global variables that describe topology
- retired weirdly set and used logical_cpus variable
- changed fallback code for mp_ncpus > 0 case, so that CPUs are treated
as being different packages rather than cores in a single package
- moved AMD-specific code to topo_probe_amd [jkim]
- in topo_probe_0x4() follow Intel-prescribed procedure of deriving SMT
and core masks and match APIC IDs against those masks [started by
jkim]
- in topo_probe_0x4() drop code for double-checking topology parameters
by looking at L1 cache properties [jkim]
- in topo_probe_0xb() add fallback path to topo_probe_0x4() as
prescribed by Intel [jkim]
Still to do:
- prepare for upcoming AMD CPUs by using new mechanism of uniform
topology description [pointed by jkim]
- probe cache topology in addition to CPU topology and probably use that
for scheduler affinity topology; e.g. Core2 Duo and Athlon II X2 have
the same CPU topology, but Athlon cores do not share L2 cache while
Core2's do (no L3 cache in both cases)
- think of supporting non-uniform topologies if they are ever
implemented for platforms in question
- think how to better described old HTT vs new HTT distinction, HTT vs
SMT can be confusing as SMT is a generic term
- more robust code for marking CPUs as "logical" and/or "hyperthreaded",
use HTT mask instead of modulo operation
- correct support for halting logical and/or hyperthreaded CPUs, let
scheduler know that it shouldn't schedule any threads on those CPUs
PR: kern/145385 (related)
In collaboration with: jkim
Tested by: Sergey Kandaurov <pluknet@gmail.com>,
Jeremy Chadwick <freebsd@jdc.parodius.com>,
Chip Camden <sterling@camdensoftware.com>,
Steve Wills <steve@mouf.net>,
Olivier Smedts <olivier@gid0.org>,
Florian Smeets <flo@smeets.im>
MFC after: 1 month
IFF_ALLMULTI/IFF_PROMISC as well as multicast filter configuration.
Rewrite RX filter logic to reduce number of register accesses and
make it handle promiscuous/allmulti toggling without controller
reinitialization.
Previously rl(4) counted on controller reinitialization to reprogram
promiscuous configuration but r211767 resulted in avoiding
controller reinitialization whenever promiscuous mode is toggled.
To address this, keep track of driver's view of interface state and
handle IFF_ALLMULTI/IFF_PROMISC changes without reinitializing
controller. This should fix a regression introduced in r211267.
While I'm here remove unnecessary variable reassignment in ioctl
handler.
PR: kern/151079
MFC after: 1 week
SI_SUB_RUN_SCHEDULER+SI_ORDER_ANY should only be used to call
scheduler() function which turns the initial thread into swapper proper
and thus there is no further SYSINIT processing.
Other SYSINITs with SI_SUB_RUN_SCHEDULER+SI_ORDER_ANY may get ordered
after scheduler() and thus never executed. That particular relative
order is semi-arbitrary.
Thus, change such places to use SI_ORDER_MIDDLE.
Also, use SI_ORDER_MIDDLE instead of correct, but less appealing,
SI_ORDER_ANY - 1.
MFC after: 1 week
number of unexplained interrupt problems. For some reason, using HPET
interrupts there breaks HDA sound. Legacy route mode interrupts reported
to work fine there.
controllers. bge(4) exported MAC statistics on controllers that
maintain the statistics in the NIC's internal memory. Newer
controllers require register access to fetch these values. These
counters provide useful information to diagnose driver issues.
The check for alignment should be made against the physical address and not
the virtual address that maps it.
Sponsored by: NetApp
Submitted by: Will McGovern (will at netapp dot com)
Reviewed by: mjacob, jhb
