change... This eliminates a cast, and also forces td_retval
(often 2 32-bit registers) to be aligned so that off_t's can be
stored there on arches with strict alignment requirements like
armeb (AVILA)... On i386, this doesn't change alignment, and on
amd64 it doesn't either, as register_t is already 64bits...
This will also prevent future breakage due to people adding additional
fields to the struct...
This gets AVILA booting a bit farther...
Reviewed by: bde
AppleTalk was a network transport protocol for Apple Macintosh devices
in 80s and then 90s. Starting with Mac OS X in 2000 the AppleTalk was
a legacy protocol and primary networking protocol is TCP/IP. The last
Mac OS X release to support AppleTalk happened in 2009. The same year
routing equipment vendors (namely Cisco) end their support.
Thus, AppleTalk won't be supported in FreeBSD 11.0-RELEASE.
IPX was a network transport protocol in Novell's NetWare network operating
system from late 80s and then 90s. The NetWare itself switched to TCP/IP
as default transport in 1998. Later, in this century the Novell Open
Enterprise Server became successor of Novell NetWare. The last release
that claimed to still support IPX was OES 2 in 2007. Routing equipment
vendors (e.g. Cisco) discontinued support for IPX in 2011.
Thus, IPX won't be supported in FreeBSD 11.0-RELEASE.
mechanism, based on the new SB_STOP sockbuf flag. The old hack dynamically
changed the sending sockbuf's high water mark whenever adding or removing
data from the receiving sockbuf. It worked for stream sockets, but it never
worked for SOCK_SEQPACKET sockets because of their atomic nature. If the
sockbuf was partially full, it might return EMSGSIZE instead of blocking.
The new solution is based on DragonFlyBSD's fix from commit
3a6117bbe0ed6a87605c1e43e12a1438d8844380 on 2008-05-27. It adds an SB_STOP
flag to sockbufs. Whenever uipc_send surpasses the socket's size limit, it
sets SB_STOP on the sending sockbuf. sbspace() will then return 0 for that
sockbuf, causing sosend_generic and friends to block. uipc_rcvd will
likewise clear SB_STOP. There are two fringe benefits: uipc_{send,rcvd} no
longer need to call chgsbsize() on every send and receive because they don't
change the sockbuf's high water mark. Also, uipc_sense no longer needs to
acquire the UIPC linkage lock, because it's simpler to compute the
st_blksizes.
There is one drawback: since sbspace() will only ever return 0 or the
maximum, sosend_generic will allow the sockbuf to exceed its nominal maximum
size by at most one packet of size less than the max. I don't think that's
a serious problem. In fact, I'm not even positive that FreeBSD guarantees a
socket will always stay within its nominal size limit.
sys/sys/sockbuf.h
Add the SB_STOP flag and adjust sbspace()
sys/sys/unpcb.h
Delete the obsolete unp_cc and unp_mbcnt fields from struct unpcb.
sys/kern/uipc_usrreq.c
Adjust uipc_rcvd, uipc_send, and uipc_sense to use the SB_STOP
backpressure mechanism. Removing obsolete unpcb fields from
db_show_unpcb.
tests/sys/kern/unix_seqpacket_test.c
Clear expected failures from ATF.
Obtained from: DragonFly BSD
PR: kern/185812
Reviewed by: silence from freebsd-net@ and rwatson@
MFC after: 3 weeks
Sponsored by: Spectra Logic Corporation
a single priority queue. If that queue had a thread or threads which
could not be migrated we would fail to steal load. This could cause
starvation in situations where cores are idle.
Submitted by: Doug Kilpatrick <dkilpatrick@isilon.com>
Tested by: pho
Reviewed by: mav
Sponsored by: EMC / Isilon Storage Division
perforce syntax and committed some unrelated files. Only devd files
should've been committed.
Reported by: imp
Pointy hat to: asomers
MFC after: 3 weeks
X-MFC-With: r262914
sbin/devd/devd.cc
Add a -q flag to devd that will suppress syslog logging at
LOG_NOTICE or below.
Requested by: ian@ and imp@
MFC after: 3 weeks
Sponsored by: Spectra Logic Corporation
buffers drop packets". It was caused by a check for the space available
in a sockbuf, but it was checking the wrong sockbuf.
sys/sys/sockbuf.h
sys/kern/uipc_sockbuf.c
Add sbappendaddr_nospacecheck_locked(), which is just like
sbappendaddr_locked but doesn't validate the receiving socket's
space. Factor out common code into sbappendaddr_locked_internal().
We shouldn't simply make sbappendaddr_locked check the space and
then call sbappendaddr_nospacecheck_locked, because that would cause
the O(n) function m_length to be called twice.
sys/kern/uipc_usrreq.c
Use sbappendaddr_nospacecheck_locked for SOCK_SEQPACKET sockets,
because the receiving sockbuf's size limit is irrelevant.
tests/sys/kern/unix_seqpacket_test.c
Now that 185813 is fixed, pipe_128k_8k fails intermittently due to
185812. Make it fail every time by adding a usleep after starting
the writer thread and before starting the reader thread in
test_pipe. That gives the writer time to fill up its send buffer.
Also, clear the expected failure message due to 185813. It actually
said "185812", but that was a typo.
PR: kern/185813
Reviewed by: silence from freebsd-net@ and rwatson@
MFC after: 3 weeks
Sponsored by: Spectra Logic Corporation
to use-after-free.
fdescfree proceeds to free file pointers once fd_refcnt reaches 0, but
kern_proc_{o,}filedesc_out only checked for hold count.
MFC after: 3 days
fdgrowtable() now only reallocates fd_map when necessary.
This fixes fdgrowtable() to use the same logic as fdescfree() for
when to free the fd_map. The logic in fdescfree() is intended to
not free the initial static allocation, however the fd_map grows
at a slower rate than the table does. The table is intended to hold
20 fd, but its initial map has many more slots than 20. The slot
sizing causes NDSLOTS(20) through NDSLOTS(63) to be 1 which matches
NDSLOTS(20), so fdescfree() was assuming that the fd_map was still
the initial allocation and not freeing it.
This partially reverts r244510 by reintroducing some of the logic
it removed in fdgrowtable().
Reviewed by: mjg
Approved by: bapt (mentor)
MFC after: 2 weeks
routine, now a platform can provide a pointer to an early_putc() routine
which is used instead of cn_putc(). Control can be handed off from early
printf support to standard console support by NULLing out the pointer
during standard console init.
This leverages all the existing error reporting that uses printf calls,
such as panic() which can now be usefully employed even in early
platform init code (useful at least to those who maintain that code and
build kernels with EARLY_PRINTF defined).
Reviewed by: imp, eadler
in the sysctl_root().
Note: SYSCTL_VNET_* macros can be removed as well. All is
needed to virtualize a sysctl oid is set CTLFLAG_VNET on it.
But for now keep macros in place to avoid large code churn.
Sponsored by: Nginx, Inc.
r261266:
Add a jail parameter, allow.kmem, which lets jailed processes access
/dev/kmem and related devices (i.e. grants PRIV_IO and PRIV_KMEM_WRITE).
This in conjunction with changing the drm driver's permission check from
PRIV_DRIVER to PRIV_KMEM_WRITE will allow a jailed Xorg server.
/dev/kmem and related devices (i.e. grants PRIV_IO and PRIV_KMEM_WRITE).
This in conjunction with changing the drm driver's permission check from
PRIV_DRIVER to PRIV_KMEM_WRITE will allow a jailed Xorg server.
Submitted by: netchild
MFC after: 1 week
It's common for multi-threaded processes to create a thread for
the purpose of synchronously processing signals. Allow such processes to
utilize a capabilities sandbox.
Discussed with: rwatson, pjd
MFC after: 2 weeks
paper trail now, this patch is similar to one posted for one of the
preliminary versions of a new armv6 port. I took them and made them
more generic. Option not enabled by default since each board/port has
to provide its own eputc, and possibly do other things as well...
This fires off a kqueue note (of type sendfile) to the configured kqfd
when the sendfile transaction has completed and the relevant memory
backing the transaction is no longer in use by this transaction.
This is analogous to SF_SYNC waiting for the mbufs to complete -
except now you don't have to wait.
Both SF_SYNC and SF_KQUEUE should work together, even if it
doesn't necessarily make any practical sense.
This is designed for use by applications which use backing cache/store
files (eg Varnish) or POSIX shared memory (not sure anything is using
it yet!) to know when a region of memory is free for re-use. Note
it doesn't mark the region as free overall - only free from this
transaction. The application developer still needs to track which
ranges are in the process of being recycled and wait until all
pending transactions are completed.
TODO:
* documentation, as always
Sponsored by: Netflix, Inc.
Callers do that already and additional check races with process
decreasing limits and can result in not growing the table at all, which
is currently not handled.
MFC after: 3 days
Having ncneg diverge with the actual length of the ncneg tailq causes
NULL dereference.
Add assertion that an entry taken from ncneg queue is indeed negative.
Reported by and discussed with: avg
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
