lastest rev of the spec. Use an explicit flag for Fast Recovery. [1]
Fix bug with exiting Fast Recovery on a retransmit timeout
diagnosed by Lu Guohan. [2]
Reviewed by: Thomas Henderson <thomas.r.henderson@boeing.com>
Reported and tested by: Lu Guohan <lguohan00@mails.tsinghua.edu.cn> [2]
Approved by: Thomas Henderson <thomas.r.henderson@boeing.com>,
Sally Floyd <floyd@acm.org> [1]
sure that the MAC label on TCP responses during TIMEWAIT is
properly set from either the socket (if available), or the mbuf
that it's responding to.
Unfortunately, this is made somewhat difficult by the TCP code,
as tcp_twstart() calls tcp_twrespond() after discarding the socket
but without a reference to the mbuf that causes the "response".
Passing both the socket and the mbuf works arounds this--eventually
it might be good to make sure the mbuf always gets passed in in
"response" scenarios but working through this provided to
complicate things too much.
Approved by: re (scottl)
Reviewed by: hsu
Obtained from: TrustedBSD Project
Sponsored by: DARPA, Network Associates Laboratories
doing Limited Transmit. Only artificially inflate the congestion
window by 1 segment instead of the usual 3 to take into account
the 2 already sent by Limited Transmit.
Approved in principle by: Mark Allman <mallman@grc.nasa.gov>,
Hari Balakrishnan <hari@nms.lcs.mit.edu>, Sally Floyd <floyd@icir.org>
control block. Allow the socket and tcpcb structures to be freed
earlier than inpcb. Update code to understand an inp w/o a socket.
Reviewed by: hsu, silby, jayanth
Sponsored by: DARPA, NAI Labs
routine does not require a tcpcb to operate. Since we no longer keep
template mbufs around, move pseudo checksum out of this routine, and
merge it with the length update.
Sponsored by: DARPA, NAI Labs
not meant to duplicate) TCP/Vegas. Add four sysctls and default the
implementation to 'off'.
net.inet.tcp.inflight_enable enable algorithm (defaults to 0=off)
net.inet.tcp.inflight_debug debugging (defaults to 1=on)
net.inet.tcp.inflight_min minimum window limit
net.inet.tcp.inflight_max maximum window limit
MFC after: 1 week
indication of whether this happenned so the calling function
knows whether or not to unlock the pcb.
Submitted by: Jennifer Yang (yangjihui@yahoo.com)
Bug reported by: Sid Carter (sidcarter@symonds.net)
Ensure that the syn cache's syn-ack packets contain the same
ip_tos, ip_ttl, and DF bits as all other tcp packets.
PR: 39141
MFC after: 2 weeks
This time, make sure that ipv4 specific code (aka all of the above)
is only run in the ipv4 case.
receiver was not sending an immediate ack with delayed acks turned on
when the input buffer is drained, preventing the transmitter from
restarting immediately.
Propogate the TCP_NODELAY option to accept()ed sockets. (Helps tbench and
is a good idea anyway).
Some cleanup. Identify additonal issues in comments.
MFC after: 1 day
to send all its data, especially when the data is less than one MSS.
This fixes an issue where the stack was delaying the sending
of data, eventhough there was enough window to send all the data and
the sending of data was emptying the socket buffer.
Problem found by Yoshihiro Tsuchiya (tsuchiya@flab.fujitsu.co.jp)
Submitted by: Jayanth Vijayaraghavan
In order to ensure security and functionality, RFC 1948 style
initial sequence number generation has been implemented. Barring
any major crypographic breakthroughs, this algorithm should be
unbreakable. In addition, the problems with TIME_WAIT recycling
which affect our currently used algorithm are not present.
Reviewed by: jesper
generation scheme. Users may now select between the currently used
OpenBSD algorithm and the older random positive increment method.
While the OpenBSD algorithm is more secure, it also breaks TIME_WAIT
handling; this is causing trouble for an increasing number of folks.
To switch between generation schemes, one sets the sysctl
net.inet.tcp.tcp_seq_genscheme. 0 = random positive increments,
1 = the OpenBSD algorithm. 1 is still the default.
Once a secure _and_ compatible algorithm is implemented, this sysctl
will be removed.
Reviewed by: jlemon
Tested by: numerous subscribers of -net
connection. The information contained in a tcptemp can be
reconstructed from a tcpcb when needed.
Previously, tcp templates required the allocation of one
mbuf per connection. On large systems, this change should
free up a large number of mbufs.
Reviewed by: bmilekic, jlemon, ru
MFC after: 2 weeks
For TCP, verify that the sequence number in the ICMP packet falls within
the tcp receive window before performing any actions indicated by the
icmp packet.
Clean up some layering violations (access to tcp internals from in_pcb)
Add new PRC_UNREACH_ADMIN_PROHIB in sys/sys/protosw.h
Remove condition on TCP in src/sys/netinet/ip_icmp.c:icmp_input
In src/sys/netinet/ip_icmp.c:icmp_input set code = PRC_UNREACH_ADMIN_PROHIB
or PRC_UNREACH_HOST for all unreachables except ICMP_UNREACH_NEEDFRAG
Rename sysctl icmp_admin_prohib_like_rst to icmp_unreach_like_rst
to reflect the fact that we also react on ICMP unreachables that
are not administrative prohibited. Also update the comments to
reflect this.
In sys/netinet/tcp_subr.c:tcp_ctlinput add code to treat
PRC_UNREACH_ADMIN_PROHIB and PRC_UNREACH_HOST different.
PR: 23986
Submitted by: Jesper Skriver <jesper@skriver.dk>
messages send by routers when they deny our traffic, this causes
a timeout when trying to connect to TCP ports/services on a remote
host, which is blocked by routers or firewalls.
rfc1122 (Requirements for Internet Hosts) section 3.2.2.1 actually
requi re that we treat such a message for a TCP session, that we
treat it like if we had recieved a RST.
quote begin.
A Destination Unreachable message that is received MUST be
reported to the transport layer. The transport layer SHOULD
use the information appropriately; for example, see Sections
4.1.3.3, 4.2.3.9, and 4.2.4 below. A transport protocol
that has its own mechanism for notifying the sender that a
port is unreachable (e.g., TCP, which sends RST segments)
MUST nevertheless accept an ICMP Port Unreachable for the
same purpose.
quote end.
I've written a small extension that implement this, it also create
a sysctl "net.inet.tcp.icmp_admin_prohib_like_rst" to control if
this new behaviour is activated.
When it's activated (set to 1) we'll treat a ICMP administratively
prohibited message (icmp type 3 code 9, 10 and 13) for a TCP
sessions, as if we recived a TCP RST, but only if the TCP session
is in SYN_SENT state.
The reason for only reacting when in SYN_SENT state, is that this
will solve the problem, and at the same time minimize the risk of
this being abused.
I suggest that we enable this new behaviour by default, but it
would be a change of current behaviour, so if people prefer to
leave it disabled by default, at least for now, this would be ok
for me, the attached diff actually have the sysctl set to 0 by
default.
PR: 23086
Submitted by: Jesper Skriver <jesper@skriver.dk>
delete the cloned route that is associated with the connection.
This does not exhaust the routing table memory when the system
is under a SYN flood attack. The route entry is not deleted if there
is any prior information cached in it.
Reviewed by: Peter Wemm,asmodai
better recovery for multiple packet losses in a single window.
The algorithm can be toggled via the sysctl net.inet.tcp.newreno,
which defaults to "on".
Submitted by: Jayanth Vijayaraghavan <jayanth@yahoo-inc.com>
is an application space macro and the applications are supposed to be free
to use it as they please (but cannot). This is consistant with the other
BSD's who made this change quite some time ago. More commits to come.
pr_input() routines prototype is also changed to support IPSEC and IPV6
chained protocol headers.
Reviewed by: freebsd-arch, cvs-committers
Obtained from: KAME project
- eliminate the fast/slow timeout lists for TCP and instead use a
callout entry for each timer.
- increase the TCP timer granularity to HZ
- implement "bad retransmit" recovery, as presented in
"On Estimating End-to-End Network Path Properties", by Allman and Paxson.
Submitted by: jlemon, wollmann
This makes it possible to change the sysctl tree at runtime.
* Change KLD to find and register any sysctl nodes contained in the loaded
file and to unregister them when the file is unloaded.
Reviewed by: Archie Cobbs <archie@whistle.com>,
Peter Wemm <peter@netplex.com.au> (well they looked at it anyway)
flag means that there is more data to be put into the socket buffer.
Use it in TCP to reduce the interaction between mbuf sizes and the
Nagle algorithm.
Based on: "Justin C. Walker" <justin@apple.com>'s description of Apple's
fix for this problem.
another specialized mbuf type in the process. Also clean up some
of the cruft surrounding IPFW, multicast routing, RSVP, and other
ill-explored corners.
mismatches exposed by this (the prototype for tcp_respond() didn't
match the function definition lexically, and still depends on a
gcc feature to match if ints have more than 32 bits).
Define a parameter which indicates the maximum number of sockets in a
system, and use this to size the zone allocators used for sockets and
for certain PCBs.
Convert PF_LOCAL PCB structures to be type-stable and add a version number.
Define an external format for infomation about socket structures and use
it in several places.
Define a mechanism to get all PF_LOCAL and PF_INET PCB lists through
sysctl(3) without blocking network interrupts for an unreasonable
length of time. This probably still has some bugs and/or race
conditions, but it seems to work well enough on my machines.
It is now possible for `netstat' to get almost all of its information
via the sysctl(3) interface rather than reading kmem (changes to follow).
is believed to have been broken with the Brakmo/Peterson srtt
calculation changes. The result of this bug is that TCP connections
could time out extremely quickly (in 12 seconds).
Also backed out jdp's partial fix for this problem in rev 1.17 of
tcp_timer.c as it is obsoleted by this commit.
Bug was pointed out by Kevin Lehey <kml@roller.nas.nasa.gov>.
PR: 6068
a hashed port list. In the new scheme, in_pcblookup() goes away and is
replaced by a new routine, in_pcblookup_local() for doing the local port
check. Note that this implementation is space inefficient in that the PCB
struct is now too large to fit into 128 bytes. I might deal with this in the
future by using the new zone allocator, but I wanted these changes to be
extensively tested in their current form first.
Also:
1) Fixed off-by-one errors in the port lookup loops in in_pcbbind().
2) Got rid of some unneeded rehashing. Adding a new routine, in_pcbinshash()
to do the initialial hash insertion.
3) Renamed in_pcblookuphash() to in_pcblookup_hash() for easier readability.
4) Added a new routine, in_pcbremlists() to remove the PCB from the various
hash lists.
5) Added/deleted comments where appropriate.
6) Removed unnecessary splnet() locking. In general, the PCB functions should
be called at splnet()...there are unfortunately a few exceptions, however.
7) Reorganized a few structs for better cache line behavior.
8) Killed my TCP_ACK_HACK kludge. It may come back in a different form in
the future, however.
These changes have been tested on wcarchive for more than a month. In tests
done here, connection establishment overhead is reduced by more than 50
times, thus getting rid of one of the major networking scalability problems.
Still to do: make tcp_fastimo/tcp_slowtimo scale well for systems with a
large number of connections. tcp_fastimo is easy; tcp_slowtimo is difficult.
WARNING: Anything that knows about inpcb and tcpcb structs will have to be
recompiled; at the very least, this includes netstat(1).
