since make depend wasn't picking up any new dependencies. However, due
to a bug in the old code, the original dependencies weren't being used, so
this version is better than the original and the lastest version.
(And is more readable as well)
* Novell probe changed to be invasive because of too many complaints
* about some clone boards not being reset properly and thus not
* found on a warmboot. Yuck.
*
* Revision 2.10 1993/10/23 04:07:12 davidg
* increment output errors if the device times out (done via watchdog)
*
* Revision 2.9 1993/10/23 04:01:45 davidg
* increment input error counter if a packet with a bad length is
* detected.
(see changes to getty which this patch is part of)
Basically, a few of the tty flags were changed to work better with
'CRT's, and the flags are better documented (documentation from Bruce
Evans).
Date: Wed, 20 Oct 1993 18:28:44 +0300
Editors Note:
Line ended with comma (``,'') instead of semicolon (``;''),
this should not have effected the code.
Submitter made no comments other than it was ``simple''.
(rick@snowhite.cis.uoguelph.ca). I am currently using it with a Microsoft
InPort busmouse, under FreeBSD Epsilon. I hadn't planned on supporting it,
but I have patched it a few times, and I guess this is now the de facto
reference version, so send me any problems or improvements.
- Gene Stark
stark@cs.sunysb.edu
October 9, 1993
if any are referenced.
libc's malloc.o contains malloc(), free() and realloc(). And libc
refers to realloc which will cause the linker to pull in redundant
malloc() and free() definitions from malloc.o if it isn't already
linked in from GNU malloc. Rich
Date: Tue, 19 Oct 1993 02:22:41 -40962758 (WST)
As the subject line says:
I can;t believe this typo is still here.
Has NOBODY used the isa_dmastart() routine for 16bit DMA?
I know I just hit the dma regs directly for the AHA1542,
and it appears that either everybody else does as well, or
they only use 8bit DMA (e.g. floppy)
Editors Note:
The definition of DMA2_CHN was incorrectly using IO_DMA1!
Clean up some stuff so that it reads a little better (some one please
review this for me!)
Adaptec controllers are 154x and 174x series. Add Buslogic 545S.
the RELEASE NOTES.
Adaptec controllers are now 154x and 174x series, no more reference
to specific models. Revamp the CSI hard disk controller section in
general to be more user readable.
Add the fact that the Mitsumi CDROM controller and drive are now
supported.
Add a note that the Intel 82501 serial chip is NOT supported.
Floppy controller is fd0, not fdc0, same for wd disk controller.
