strlen.
This one only occurs if there is exactly one element on the line without any
whitespace. This is however never a valid line, so not a big chance that
this would ever cause any problems.
original \0 on the terminating string, however I changed my mind to
make it more obvious that the termination was being taken care of and
explicitly added the nul terminator. I forgot to reset the bcopy length.
was being made one byte too short, and the string assembled in it was not
null terminated. The string was passed to regcomp() so it never matched
anything in /etc/usbd.conf. This is the cause of usbd not working for the
last few days.. The new malloc.conf default of AJ triggered this.
and has not been loaded via a kldload,
running usbd(8) will autoload the "usb.ko" kld.
thanks to Peter Wemm for enlightening me on the
differences between kldfind(2) and modfind(2).
devices. For example, starting 'usbd -e' would give a 'No USB
controllers found' message instead of a '/dev/usb0: Permission denied'.
Submitted-By: Dirk-Willem van Gulik <dirkx@webweaving.org>
/dev/usb. The actions are specified in the file /etc/usbd.conf.
usbd.c:
- Add event queue (/dev/usb) handling.
- Add comments
- Clean up code some more
usbd.8:
- Update manpage for the new command line flags
- Remove a duplicate FreeBSD tag from it).
usbd.conf, usbd.conf.5, Makefile:
- Add the usbd.conf configuration file and the man page for it.
NOTE: MAKEDEV already creates the /dev/usb device tree node, no change
needed there anymore.
- remove the use of NDEV. It is confusing. MAXUSBDEV should do.
- add some comments.
- add more explanation in usage()
- change the timeout value for undetected USB devices from 300 to 30
seconds. I don't think anyone wants to wait 5 minutes for broken
devices to show up. The overhead CPU wise is very little.
- print 'no controllers found' as a fatal error.
- remove inclusion of malloc.h. It's unused.
track.
The Id line is normally at the bottom of the main comment block in the
man page, separated from the rest of the manpage by an empty comment,
like so;
.\" $Id$
.\"
If the immediately preceding comment is a @(#) format ID marker than the
the $Id$ will line up underneath it with no intervening blank lines.
Otherwise, an additional blank line is inserted.
Approved by: bde
