cards. This basically involves switching to the 12.4.13 firmware, plus
a couple of minor tweaks to the driver.
Also changed the jumbo buffer allocation scheme just a little to avoid
'failed to allocate jumbo buffer' conditions in certain cases.
The tap driver is used to present a virtual Ethernet interface to the
system. Packets presented by the network stack to the interface are
made available to a character device in /dev. With tap and the bridge
code, you can make remote bridge configurations where both sides of
the bridge are separated by userland daemons.
This driver also has a special naming hack to allow it to serve a similar
purpose to the vmware port.
Submitted by: myevmenkin@att.com, vsilyaev@mindspring.com
whitespace changes, which should not be a problem because this
is only the second revision of the file and translators are
unlikely to have gotten started yet.
Reviewed by: abial
whitespace changes, which should not be a problem because this
is only the second revision of the file and translators are
unlikely to have gotten started yet.
Reviewed by: abial
3.3volt PCI/cardbus chipsets similar to the 98715 (and they have
512-bit hash tables). Also update the man page to mention the 98727/98732
and the SOHOware SFA110A Rev B4 card with the 98715AEC-C chip.
PR: 19894
Submitted by: Tony Finch <dot@dotat.at>
2. "brackets" -> "angle brackets" when referring to < and >.
3. Clean up the bit about creating the usage() message. After clarifying a
couple of points the sentence became rather long, and rather poor English, so
it was converted to a enumerated list instead.
parts 1, 2, 3:
Reviewed by: sheldonh
and remove sysctl oids at will during runtime - they don't rely on
linker sets. Also, the node oids can be referenced by more than
one kernel user, which means that it's possible to create partially
overlapping trees.
Add sysctl contexts to help programmers manage multiple dynamic
oids in convenient way.
Please see the manpages for detailed discussion, and example module
for typical use.
This work is based on ideas and code snippets coming from many
people, among them: Arun Sharma, Jonathan Lemon, Doug Rabson,
Brian Feldman, Kelly Yancey, Poul-Henning Kamp and others. I'd like
to specially thank Brian Feldman for detailed review and style
fixes.
PR: kern/16928
Reviewed by: dfr, green, phk
* Clear the Os macro, which is assumed gracefully at run-off time.
* Use quotes to reduce the long name description (Nd) to a single
argument.
* Use meaningful arguments to the -width option of the Bl macro.
* Mark rc.conf up with Xr instead of Pa so that it is obvious that
further help on that file is available.
* Explicitly indicate that mediaopt is a command modifier (Cm) of
the ifconfig(8) utility.
* Do not mark up half-duplex and full-duplex as arguments (Ar),
since they are allowed values for an argument.
* Fix various grammar and spelling mistakes.
controller chip. This chip is currently being used on the NetGear
FA312-TX adapter, which I guess is a replacement for the FA310-TX
(PNIC-based).
I added support for this chip by modifying the sis driver since
the SiS 900 and the NS DP83815 have almost the same programming
interface (the RX filter programming and PHY access methods are
different, but the general configuration, DMA scheme and register
layout are identical).
I would have had this done a lot sooner, but getting the damn MAC
address out of the EEPROM proved to be more complicated than expected.
the command-line arguments to be used for the call to df(1) when
daily_status_disks_enable is set to YES.
The name of the new variable was chosen by the maintainer of our
periodic hierarchy, Brian Somers.
PR: 19631
