- Use unsigned types for the (32-bit) Open Firmware device handles
to avoid sign extension on 64-bit architectures.
- Add a standard type definition for Open Firmware arguments.
What the heck, the OpenBSD version will benefit.
1. Add wx_txint_delay as a tunable (defaults to 5000 now, or ~5ms) and switch
to using delayed TXDW interrupts. Since the chip continues to reload the
TIDV with this value for each descriptor written back, this allows continued
deferral of the actual interrupt until the last packet completes (assuming
that 5ms between multiple packets transmitting is reasonable).
2. Add two other SYSCTL entities:
hw.wx.dump_stats
hw.wx.clear_stats
to be used, hackey hackey, to get the watchdog routine to dump/clear
the current softc statistics.
Usage would be:
sysctl -w hw.wx.dump_stats=UNIT
to cause the current stats to be dumped for UNIT.
3. Attempt to clean up wx_detach routine so we don't panic. Well, things
still panic, but given that the code is just like other NIC drivers,
I suspect it's actually something elsewhere, like e1000phy, that's actually
blowing up.
4. Skip the entire test for runt packets- after doing somet thinking
and experimenting, I believe that the chip only doesn't like it if
the whole frame to xmit is < 16 bytes- each TFD can be some fragment
of that. This should improve performance a chunk because of all of the
(14 byte ETHERHEADER + DATA) mbuf chains.
5. Keep track of total frame length. Try not to xmit an odd byte frame-
this is supposed to get around some dumb Cisco switch problems.
6. On the last packet, also set Interrupt Delay && Report Packet Sent
(see #1 above)
7. Attempt to do xmit garbage collection *first* in order to avoid setting
IFF_OACTIVE if at all possible.
MFC after: 1 week
+ Remove 'sleep' (not sure why it is so important in fix-it mode).
+ Remove ability to mount MSDOSFS as that is not a typical filesystem on an
alpha; and thus does not really add to the fix-it mix.
+ Sync style with i386.
to working but still needs some work to properly switch the full context
(such as saving the fpu registers, switch stacks, etc.). Also, remove some
dead code that was mixed in.
This significantly reduces the number of TLB shootdowns caused by
vmapbuf/vunmapbuf when performing many large reads from raw disk devices.
Reviewed by: dillon
- vm map entries are not valid after the map has been unlocked.
- An exclusive lock on the map is needed before calling
vm_map_simplify_entry().
Fix cleanup after page wiring failure to unwire all pages that had been
successfully wired before the failure was detected.
Reviewed by: dillon
these chips. There is a new hint, hint.pcm.N.hwvol_config, that can be set
to 1 or 0 to select which pins the buttons are connected to. I'm open to
suggestions on where to document this. Also bump the number of playback
channels up to 4.
MFC after: 3 days
