Submitted by: Jun Su <junsu microsoft com>
Reviewed by: sephe, Dexuan Cui <decui microsoft com>
MFC after: 1 week
Sponsored by: Microsoft OSTC
Differential Revision: https://reviews.freebsd.org/D5957
Replace loop with switch statement (rate2ridx())
(should be noop).
Tested with RTL8188EU / RTL8188CUS, STA mode.
Reviewed by: adrian
Differential Revision: https://reviews.freebsd.org/D4848 (rebased)
rounddown2 tends to produce longer lines than the original code
and when the code has a high indentation level it was not really
advantageous to do the replacement.
This tries to strike a balance between readability using the macros
and flexibility of having the expressions, so not everything is
converted.
bcm2835_mbox_fb_init sets configuration so SET_VIRTUAL_OFFSET should be used
instead of GET_VIRTUAL_OFFSET
Submitted by: Sylvain Garrigues <sylvain@sylvaingarrigues.com>
- Enable the commented out locking in fd_probe(). The worker thread
should not be running yet (even after these changes), but better to be
safe than sorry.
- Defer starting the worker thread until after the child drives have been
probed. The worker thread startup is moved into a fdc_start_worker()
thread that the various front ends call at the end of attach. As a
side effect this fixes a few edge cases that weren't shutting down the
worker thread if attach encountered a late failure.
- When executing the initial reset requested by attach in the worker
thread, use DELAY() instead of a tsleep() if cold is set.
Tested by: Howard Su <howard0su@gmail.com>
Sponsored by: Netflix
Eventually with earlier AP startup this code will change to call the
startup function synchronously instead of queueing the task. Moving
the time we queue the task should be a no-op since taskqueue threads
don't start executing tasks until much later, but this reduces the diff
with the earlier AP startup patches.
Sponsored by: Netflix
sys/geom/geom_disk.c:
disk_attr_changed(): Generate a devctl event of type GEOM:<attr> for
every call.
MFC after: 4 weeks
Sponsored by: Spectra Logic Corp
Differential Revision: https://reviews.freebsd.org/D5952
IPv6 addresses has a scope ID which sometimes is stored in the
"sin6_scope_id" field of "struct sockaddr_in6" and sometimes as part
of the IPv6 address itself depending on the context. If the scope ID
is not in the expected location, the IPv6 address lookups in the
so-called GID table will fail. Some code factoring has been made to
achieve a clean exit of the "addr_resolve" function via a common
"done" label.
Sponsored by: Mellanox Technologies
Submitted by: Shani Michaeli <shanim@mellanox.com>
MFC after: 1 week
already required both of them, so having a separate rctl_lock didn't
buy us anything.
Reviewed by: mjg@
MFC after: 1 month
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D5914
tp->snd_wnd. This can happen, for example, when the remote side responds to
a window probe by ACKing the one byte it contains.
Differential Revision: https://reviews.freebsd.org/D5625
Reviewed by: hiren
Obtained from: Juniper Networks (earlier version)
MFC after: 2 weeks
Sponsored by: Juniper Networks
Only compile what each SoC needs and get rid of MEDIATEK generic config.
Approved by: adrian (mentor)
Sponsored by: Smartcom - Bulgaria AD
Differential Revision: https://reviews.freebsd.org/D5996
ieee80211_scan_done().
Refresh comments that reference scan_next() method
(does not exist since r191746) + fix spelling of 'current'.
Differential Revision: https://reviews.freebsd.org/D5137
- Allow to enable/disable promiscuous mode when:
* interface is not a member of bridge, or;
* request was issued by user (ifconfig wlan0 promisc), or;
* interface is in MONITOR or AHDEMO mode.
- Drop local workarounds in mwl(4) and malo(4).
Tested with:
- Intel 3945BG, STA mode;
- RTL8188CUS, MONITOR mode;
Reviewed by: adrian
Differential Revision: https://reviews.freebsd.org/D5472
VideoCore reports garbage in viewport geometry fields unless
viewport was set previously by earlier stage boot loader. So
when booting FreeBSD kernel directly from VideoCore's start.elf
framebuffer intialization fails due to invalid vxres, vyres
values. Make sure we request viewport to be equal to physical
resolution
Submitted by: Sylvain Garrigues <sylvain@sylvaingarrigues.com>
Hide subtype mask/shift (which is used for index calculation
in ieee80211_mgt_subtype_name[] array) in function call.
Tested with RTL8188CUS, STA mode.
Reviewed by: adrian
Differential Revision: https://reviews.freebsd.org/D5369
Tell the firmware that we support PCI-express config space access
and MSI.
Reviewed by: jkim
MFC after: 2 weeks
Differential Revision: https://reviews.freebsd.org/D6023
This wrapper does not translate errors in the first word to ACPI
error status returns. Use this wrapper in the acpi_cpu(4) driver in
place of the existing _OSC code. While here, fix a bug where the wrong
count of words was passed when invoking _OSC.
Reviewed by: jkim
MFC after: 2 weeks
Differential Revision: https://reviews.freebsd.org/D6022
The additional regex replacements are actully required due to an
elfcopy bug which is now fixed (by r298361), not a Clang/GCC issue.
Sponsored by: The FreeBSD Foundation
le*dec / le*enc functions.
Replace net80211 specific macros with system-wide bytestream
encoding/decoding functions:
- LE_READ_2 -> le16dec
- LE_READ_4 -> le32dec
- LE_WRITE_2 -> le16enc
- LE_WRITE_4 -> le32enc
+ drop ieee80211_input.h include, where it was included for these
operations only.
Reviewed by: adrian
Differential Revision: https://reviews.freebsd.org/D6030
Newest CLANG objcpy uses different name parsing.
Modify regexp to match (i.e. avoid substitution
of "/" or "-" with "_").
Obtained from: Semihalf
Sponsored by: Juniper Networks
Reviewed by: hselasky, zbb
Differential Revision: https://reviews.freebsd.org/D5873
of service to the arbitrary value of 256. Log an appropriate message
that indicates the hard limit.
PR: 208808
Submitted by: cturt@hardenedbsd.org
Reviewed by: dfr
Obtained from: HardenedBSD
MFC after: 2 weeks
This revision makes the mtk_gpio_v1 driver read its register map property
from the OpenWRT dts files.
Approved by: adrian (mentor)
Sponsored by: Smartcom - Bulgaria AD
Differential Revision: https://reviews.freebsd.org/D6029
